Durable softening water-repellenting agent such as PODCW, PDDCW and PEDCW were prepared by blending cationized compound such as poly(octadecyl methacrylate-co-2-diethylaminoethyl methacrylate)[PODC], poly(2-dodecyl methacrylate-co-2-diethyl-aminoethyl methacrylate)[PDDC] and poly(2-ethylhexyl methacrylate-co-2-diethyl-aminoethyl methacrylate)[PEDC], and cationized compound of fatty carbamide, of which synthetic methods were reported in the previous paper, waxes, and emulsifiers. The results of physical tests of the P/C blended fabrics treated with PODCW, PDDCW and PEDCW with and without textile finishing resin, showed a remarkable improvement of the physical properties. The prepared water-repellenting agents, PODCW-6 and PDDCW-1, were treated on P/C blended fabrics with and without resin. For any cases, there are a little changes between initial water repellency and repellency after 3 times washing of the fabrics. Therefore, the water-repellenting agents proved to be a durable agents, and initial water 100+ and 90+ point, respectively.

Cinnamoyl ester(PGEFC) of poly(phloroglucinol-formaldehyde) glycidyl ether which has photosensitive functional group was prepared to apply to photoresist. Photosensitivity of PGEFC was estimated by the solubility difference in organic solvent before and after exposure to light. The yield of residual film was calculated by immersing the sample-coated quartz plates in the solvent which was used in coating. The yield of the residual film which was closely related to the sensitivity of the film, was affected by the degree of polymerization of the backbone resin, sensitizers and their concentration. The sensitivity was depended upon the degree of polymerization. Most of effective sensitizer for PGEFC among the sensitizers was 2, 6-dichloro-4-nitroaniline.

1, 3-Di(2-dodecanoylaminoethyl)-2, 7-dioxy-1, 3, 6, 8-tetraazacyclodecane[DDTD] and sorbitan monostearate(SMS) were synthesized as a main component for softner. O/W type softner(DSA) was prepared by blending of DSA, SMS, polyoxyethylene(10) castor oil, glyceryl monooleate, and polyoxyethylene(7) stearyl ether. After treatment of DSA to all cotton fabrics, the physical properties such as tear strength, crease recovery, and flexing abrasion resistance were measured. As a result of the measurement, DSA was found to be durable softner with good softness.

1, 3-Di(dodecanoyl)-2, 7-dioxy-6, 8-di(2-hydroxyethyl)-1, 3, 6, 8-tetraazacyclodecane(DDDT) and pentaerythritol monostearate(PMS) were synthesized as a main component for softner. O/W type softner(DPSA) was prepared by blending DDDT and PMS with polyoxyethylene(10) castor oil, polyoxyethylene(20) oleyl ether, and polyoxyethylene(10) monolaurate. After treatment of DPSA to all cotton fabrics, the physical properties such as tear strength, crease recovery, and flexing abrasion resistance were measured. As a result of the measurement, DPSA was proved to be durable softner with good softness.

For the evaluation of load carrying capacity of continuous bridges, the testing target span should be selected where peak impact factor can be expected. In this paper, two and three continuous bridges with equal span length are considered and the moving vehicle load analysis is performed. All possible vehicle speeds are applied to the bridges and the peak impact factors obtained for each span are investigated. From the results, the maximum peak impact factors are developed at the middle of the first span to the direction of vehicle moving.