Recently, road cave-in and depression in urban area due to subsurface cavity are emerging as a social issue in Korea. These phenomena enable to cause not only damage to human lives and properties, but also an anxiety of the citizens. Furthermore, it is a problem that needs more fundamental solution to countermeasure. The objective of this study is to evaluate the stiffness characteristics of asphalt pavement with existence of subsurface cavity using Falling Weight Deflectometer (FWD) deflection and backcalculation analysis using GAPAVE program developed the KICT. The characteristics of FWD deflections are analysed for cavity and intact asphalt pavements. The stiffness reduction in the asphalt pavement due to subsurface cavity was evaluated as a result of this FWD test. The Seoul Metropolitan Government has conducted a Ground Penetrating Radar (GPR) test, coring, and image photographing in four different locations to determine the presence of the cavity and figure out the cavity depth and size underneath asphalt pavements. The cavity depths measured in this section range between 17cm to 51cm, and its lengths are at least 70cm to up to 310cm. It is found from this analysis that the deflections measured from cavity section are generally higher than intact section in same locations. As results of backcalculation analysis, it appears that the backcalculated moduli are generally decreasing with increase of cavity depth. After comparing with AC moduli obtained from intact and cavity section, it is observed that about 80% of moduli was reduced with existence of subsurface.

In this paper, the performance of a synthetic fiber filter aimed at high-speed operation and dosed with different coagulants or filter aids was investigated. Without a coagulant, the filter efficiency was about 62% which was greatly enhanced when three types of coagulants namely PAC, Alum, and FeCl3 were used. Among the coagulants tested, PAC was the most effective, giving 91% filter efficiency, followed by Alum with 90%, and FeCl3 with 78%. PAC worked effectively at a very small range of dose, but Alum was relatively effective in a wide range of concentration. Compared with PAC and Alum, FeCl3 provided more or less contant efficiency regardless of its dose but gave the poorest filter efficiency. Moreover, as the inflow turbidity increased, headloss increased and the efficiency decreased at any dose and type of coagulant. The headloss recorded in this particular synthetic fiber filter is not significant as compared to that observed in typical granular filters. The recovery of solids estimated after filter cleaning was about 80% for both PAC and Alum, but poorer at 72% in the case of FeCl3 due to the heavy and large floc characteristics. The recurrence of filter efficiency verified through repetitive filter runs was found to be satisfactory.