In this research, reduced graphene oxide/polypyrrole (rGO/PPy) particles were synthesized and used to measure the amount of dopamine (DA) electrochemically. The obtained rGO/PPy particle was characterized by Fourier Transform Infrared Spectrophotometer (FTIR), UV–Visible Spectrophotometer (UV–Vis), and X-Ray Diffraction Diffractometry (XRD). To investigate the DA sensor performance, cyclic voltammetry (CV) and differential pulse voltammetry (DPV) were used to acquire electrochemical measurements of the sensor. Current values of 1.65 and 5.9 mA were observed in the CV at 0.2 mM and 1.2 mM concentrations of target molecule, respectively. Under optimized conditions, the linear calibration plots were found to exhibit significant sensitivity in the linear range of 0.2 and 1.2 mM, with a corresponding detection limit of 0.061 μM for DA. The results obtained were similar to the sensor results of DA made using precious metals. This work was a demonstration of the feasibility of high-sensitivity electrochemical analysis with conductive carbon materials without the use of precious metals. It was also observed that the cost-effective rGO/PPy exhibited a very high potential for DA detection.

MicroRNAs (miRNAs) are emerging materials as ideal biomarkers for noninvasive cancer detection in the early phase. In this article, a simple and label-free electrochemical miRNA biosensor was developed. A single-stranded DNA (ss-DNA) probes were successfully mapped to f-MWCNT and hybridized with the target miR-141 sequence. The optimum peak points of the obtained hybridization were determined using Cyclic Voltammetry (CV) and Differential Pulse Voltammetry (DPV) methods. Significant peaks were observed in the results, depending on miR-141 at different concentrations. The linear relationship (ν) between redox peak currents (Ip) and scanning rate indicated that electron transfer (ET) between miR-141 and the electrode surface was accomplished successfully. In DPV measurements, miR-141 was measured with a low detection limit (LOD) in the 1.3–12 nM concentration range, and the LOD and limit of quantification (LOQ) results were found to be 3 and 9.1 pM, respectively. Besides, selectivity test was investigated for the biosensor using different target analytes and a significant difference in value was observed between the peak currents of miR-141, and other target molecules. This developed strategy has been found to detect miR-141 sensitively, selectively and without tags, and its integration into mobile devices has been successfully carried out.