We report on the fabrication and characterization of an oxide photoanode with a zinc oxide (ZnO) nanorod array embedded in cuprous oxide (Cu2O) thin film, namely a ZnO/Cu2O oxide p-n heterostructure photoanode, for enhanced efficiency of visible light driven photoelectrochemical (PEC) water splitting. A vertically oriented n-type ZnO nanorod array is first prepared on an indium-tin-oxide-coated glass substrate via a seed-mediated hydrothermal synthesis method and then a p-type Cu2O thin film is directly electrodeposited onto the vertically oriented ZnO nanorod array to form an oxide p-n heterostructure. The introduction of Cu2O layer produces a noticeable enhancement in the visible light absorption. From the observed PEC current density versus voltage (J-V) behavior under visible light illumination, the photoconversion efficiency of this ZnO/Cu2O p-n heterostructure photoanode is found to reach 0.39 %, which is seven times that of a pristine ZnO nanorod photoanode. In particular, a significant PEC performance is observed even at an applied bias of 0 V vs Hg/Hg2Cl2, which makes the device self-powered. The observed improvement in the PEC performance is attributed to some synergistic effect of the pn bilayer heterostructure on the formation of a built-in potential including the light absorption and separation processes of photoinduced charge carriers, which provides a new avenue for preparing efficient photoanodes for PEC water splitting.

We present the rectifying and nitrogen monoxide (NO) gas sensing properties of an oxide semiconductor heterostructure composed of n-type zinc oxide (ZnO) and p-type copper oxide thin layers. A CuO thin layer was first formed on an indium-tin-oxide-coated glass substrate by sol-gel spin coating method using copper acetate monohydrate and diethanolamine as precursors; then, to form a p-n oxide heterostructure, a ZnO thin layer was spin-coated on the CuO layer using copper zinc dihydrate and diethanolamine. The crystalline structures and microstructures of the heterojunction materials were examined using X-ray diffraction and scanning electron microscopy. The observed current-voltage characteristics of the p-n oxide heterostructure showed a non-linear diode-like rectifying behavior at various temperatures ranging from room temperature to 200 oC. When the spin-coated ZnO/CuO heterojunction was exposed to the acceptor gas NO in dry air, a significant increase in the forward diode current of the p-n junction was observed. It was found that the NO gas response of the ZnO/CuO heterostructure exhibited a maximum value at an operating temperature as low as 100 oC and increased gradually with increasing of the NO gas concentration up to 30 ppm. The experimental results indicate that the spin-coated ZnO/CuO heterojunction structure has significant potential applications for gas sensors and other oxide electronics.

This study is focused on the antimicrobial activity of cyanobacteria Microcystis aeruginosa by the reduction and oxidation reaction of copper and zinc alloy metal fiber filter. Cu/Zn ion is easily makes radicals with molecular hydroperoxide. Especially, hydroperoxide radical shows strong toxicity to the strains. Plasma membrane causes conformational change when hydroperoxide radical binds to plasma membrane. Elution of copper ion from copper and zinc alloy metal fiber is detected in the cyanobacteria solution as 0.5 ppm, and that of zinc ion is 0 ppm respectively. Zinc ion is figured to form a hydroxide in the cyanobacteria solution and precipitated to form a sludge. The concentration of chlorophyll-a in the cyanobacteria solution was proved to be the index of antimicrobial level of Microcystis aeruginosa.

however, these elements can limit plant growth. This study selected a heavy metal-tolerant plant by analyzing seed germination and biomass of alfalfa (Medicago sativa), canola (Brassica campestris subsp. napus var. nippo-oleifera), Chinese corn (Setaria italica), and a sorghum-sudangrass hybrid (Sorghum bicolor × S. sudanense), and determined heavy metal uptake capacity by analyzing biomass, chlorophyll a fluorescence, and heavy metal contents under high external copper or zinc levels. The seed germination rate and biomass of the sorghum-sudangrass hybrid were higher under copper or zinc stress compared to the other three plants. The plant biomass and photosynthetic pigment contents of the sorghum-sudangrass hybrid seedlings were less vulnerable under low levels of heavy metals (≤ 50 ppm copper or ≤ 400 ppm zinc). The maximum quantum yield of PSII (Fv/Fm) and the maximum primary yield of PSII (Fv/Fo) decreased with increasing copper or zinc levels. Under high copper levels, the decline in Fv/Fm was caused only by the decline in Fm, and was accompanied by an increase in non-photochemical quenching (NPQ). The Fv/Fm declined under high levels of zinc due to both a decrease in the maximum fluorescence (Fm) and an increase in the initial fluorescence (Fo), and this was accompanied by a marked decrease in photochemical quenching (qP), but not by an increase in NPQ. Accumulations of copper and zinc were found in both aboveand below-ground parts of plants, but were greater in the below-ground parts. The uptake capacity of the sorghum-sudangrass hybrid for copper and zinc reached 4459.1 mg/kg under 400 ppm copper and 9028.5 mg/kg under 1600 ppm zinc. Our results indicate that the sorghum-sudangrass hybrid contributes to the in situ phytoremediation of copper or zinc polluted soils due to its high biomass yield.

The adsorption performance of cupper and zinc ions(Cu2+ and Zn2+) in aqueous solution was investigated by an adsorption process on reagent grade Na-A zeolite(Z-WK) and Na-A zeolite (Z-C1) prepared from coal fly ash. Z-C1 was synthesized by a fusion method with coal fly ash from a thermal power plant. Batch adsorption experiment with Z-C1 was employed to study the kinetics and equilibrium parameters such as initial metal ions concentration and adsorption time of the solution on the adsorption process. Adsorption rate of metal ions occurred rapidly and adsorption equilibrium reached at less than 120 minutes. The kinetics data of Cu2+ and Zn2+ ions were well fitted by a pseudo-second-order kinetics model more than a pseudo-first-order kinetics model. The equilibrium data were well fitted by a Langmuir model and this result showed Cu2+ and Zn2+ adsorption on Z-C1 would be occupied by a monolayer adsorption. The maximum adsorption capacity(qmax) by the Langmuir model was determined as Cu2+ 99.8 mg/g and Zn2+ 108.3 mg/g, respectively. It appeared that the synthetic zeolite, Z-C1, has potential application as absorbents in metal ion recovery and mining wastewater.

To find heavy metal-specific effects on the photosynthetic apparatus of higher plants, we investigated effects of CuCl_2, HgCl_2 and ZnCl_2 on electron transport activity and chlorophyll fluorescence induction kinetics of chloroplasts isolated from barley seedlings. Effects on some related processes such as germination, growth and photosynthetic pigments of the test plants were also studied. Germination and growth rate were inhibited in a concentration-dependent manner by these metals. Mercury was shown to be the most potent inhibitor of germination, growth and biosynthesis of photosynthetic pigments of barley plants. In the inhibition of electron transport activity, quantum yield of PSⅡ, and chlorophyll fluorescence induction kinetics of chloroplasts isolated from barley seedlings, mercury chloride showed more pronounced effects than other two metals. Contrary to the effects of other two metals, mercury chloride increased variable fluorescence significantly and abolished qE in the fluorescence induction kinetics from broken chloroplasts of barley seedlings. This increase in variable fluorescence is due to the inhibition of the electron transport chain after PSⅡ and the following dark reactions. The inhibition of qE could be attributed to the interruption of pH formation and de-epoxidation o1 violaxathin to zeaxanthin to thylakoids by mercury. This unique effect of mercury on chlorophyll fluorescence induction pattern could be used as a good indicator for testing the presence and/or the concentration of mercury in the samples contaminated with heavy metals