Because of the International Maritime Organization(IMO)'s regulation to regulate emissions of ships, a change is taking place to replace ship fuels from Heavy Fule Oil(HFO) to Liquefied Natural Gas(LNG). In the case of LNG, it is a material obtained by liquefying Natural Gas(NG), and it is -163 degrees below zero, and the volume is reduced to 1/600 level. The material of the tank that can store LNG must be a material that can safely store LNG in a cryogenic environment, and the materials of the tank that can store LNG are limited in the International Code of the Construction and Equipment of Ships Carrying Liquefied Gases in Bulk(IGC Code). Among the materials listed in the IGC Code, 9% nickel steel is used as a material for LNG fuel propulsion tanks that are recently ordered because of relatively high mechanical properties under cryogenic environments. In this study, the mechanical properties of butt welds were measured following the weld reliability evaluation of Flux Cored Arc Welding(FCAW) butt welds made of 9% nickel steel by PARTI. The measured mechanical properties are tensile strength, bending strength, hardness, and cryogenic impact test required by the classification for Welding Procedure Specification(WPS) approval.

Because of the International Maritime Organization(IMO)'s regulation to regulate emissions of ships, a change is taking place to replace ship fuels from Heavy Fule Oil(HFO) to Liquefied Natural Gas(LNG). In the case of LNG, it is a material obtained by liquefying Natural Gas(NG), and it is -163 degrees below zero, and the volume is reduced to 1/600 level. The material of the tank that can store LNG must be a material that can safely store LNG in a cryogenic environment, and the materials of the tank that can store LNG are limited in the International Code of the Construction and Equipment of Ships Carrying Liquefied Gases in Bulk(IGC Code). Among the materials listed in the IGC Code, 9% nickel steel is used as a material for LNG fuel propulsion tanks that are recently ordered because of relatively high mechanical properties under cryogenic environments. In this study, butt welding was performed on a 9% nickel steel material using Flux Cored Arc Welding(FCAW), the most widely used welding method in shipyards. In PARTI, after securing the welding conditions, cross-sectional observation results analysis, liquid penetrating test, and radiographic test were performed to verify the reliability of the weld.

As the International Maritime Organization (IMO)'s environmental regulations on ship emissions become strict, the demand for ships powered by Liquefied Natural Gas (LNG) is rapidly increasing worldwide. Compared to other materials, high manganese steel has the advantages of superior impact toughness at cryogenic temperatures, a small coefficient of thermal expansion, and low cost of base materials and welding rods. However, there is a limitation in that the mechanical properties of the filler material are lower than the base material having excellent mechanical properties. In this study, after performing a high manganese steel laser butt welding experiment, the welding performance was evaluated through mechanical property (yield strength, tensile strength, hardness, cryogenic impact strength) tests of the weld. As a result, it was observed that the yield strength and tensile strength of the high manganese steel laser welding part was 97.5% and 93.5% of the base metal respectively. Also the hardness of welding part was 84.2% of the base metal. The cryogenic impact strength of the welding part and the base metal were over the 27J, the level of welding part is 76.1% of the base metal.