Crushed, depitted peach stones were impregnated activated with 50% H3PO4 followed by pyrolysis at 500℃. Two activated carbons were produced, one under its own evolved gases during pyrolysis, and the second conducted with air flow throughout the carbonization stage. Physicochemical properties were investigated by several procedures; carbon yield, ash content, elemental chemical analysis, TG/DTG and FTIR spectra. Porosity characteristics were determined by the conventional N2 adsorption at 77 K, and data analyzed to get the major texture parameters of surface area and pore volume. Highly developed activated carbons were obtained, essentially microporous, with slight effect of air on the porous structure. Oxygen was observed to be markedly incorporated in the carbon matrix during the air treatment process. Cation exchange capacity towards Cu (II) and Cd (II) was tested in batch single ion experimental mode, which proved to be slow and a function of carbon dose, time and initial ion concentration. Copper was up taken more favorably than cadmium, under same conditions, and adsorption of both cations was remarkably enhanced as a consequence of the air treatment procedure. Sequestration of the metal ions was explained on basis of the combined effect of the oxygen functional groups and the phosphorous-containing compounds; both contributing to the total surface acidity character.

Oxidized activated carbons were prepared by reacting steam-activated carbon developed from pecan shells with nitric acid of varying strength (15, 30, 45 and 60%). The textural properties and the chemistry of the surface of the non-oxidized and of the oxidized carbons were determined from nitrogen adsorption and base neutralization capacities. The uptake of Pb(II) and Cd(II) from aqueous solution by these carbons was determined by kinetic and equilibrium experiments as well as by the column method. Treatment with nitric acid brought about drastic decrease in surface area and remarkable increase in the pore size of the carbon with these changes depending on the strength of nitric acid. Nitric acid increased the surface acidity by developing new surface oxygen functional groups of acidic nature. HNO3-oxidized carbons exhibited high adsorption capacities for Pb(II) and Cd(II). The adsorption of these ions increased with the decrease of the surface pH of the carbon and with the increase of the solution pH from 2.5 to 6 and 7. The amount adsorbed from lead and cadmium was also related to the amount of surface acidity, the pH of the point of zero charge and on some metal ion parameters. Cadmium and lead uptake by the investigated carbons followed pseudo-second order model and the equilibrium sorption data fitted Langmuir adsorption model.

Treatment of water hyacinth with sulphuric acid produces carbonaceous materials that have been used to remove Cu(II) and Cd (II) ions from aqueous solutions. Untreated water hyacinth was also used for the subject of comparison. The textural properties of the carbonaceous materials were determined from nitrogen adsorption at 77 K. The optimum pH for the sorption of Cu (II) and Cd (II) ions on the investigated sorbents was determined. Dynamic adsorption measurements have been taken at 298 K whereas equilibrium measurements were carried out at 298, 313 and 323 K. The adsorption of nitrogen at 77 K on the untreated sample was too low and the surface areas of the treated samples 2, 3 and 4 were found between 70-208 m2/g. The total pore volumes of these samples which were determined for the carbonaceous materials investigated were found to be 0.076-0.140 ml/g. The kinetic adsorption data of Cu (II) and Cd(II) were applicable to both pseudo - first and pseudo-second order but fit more the latter order. The equilibrium adsorption data were found to fit Freundlich and Langmiur equations. The values of DG, DH and DS are all negative indicating the feasibility and the spontaneous nature of the sorption of Cu (II) and Cd (II) ions by the sorbents investigated.

Various kinds of zeolites, such as analcime (ANA), cancrinite (CAN), Na-P1 and sodalite octahydrate (SOD) could be synthesized from Hwangto by hydrothermal reaction in a high-pressure vessel. The adsorption characteristics of Cu(II) and Cd(II) by Hwangto and its synthetic zeolites were investigated using the chemical and electrochemical surface parameters of these adsorbents. The heavy metal adsorptivity among the adsorbents decreased in the following sequences: Na-P1>SOD>ANA>CAN>Hwangto. This sequence was the same with the values of surface site density (Ns) of these adsorbents and was correlated inversely with the values of pHpzc (pH of the point of zero charge) and the values of Ka2(int) (intrinsic surface deprotonation constant) of the adsorbents for synthetic zeolites, i.e., the adsorbents with higher values of Ns and with lower values of pHpzc and Ka2(int) for synthetic zeolites showed higher heavy metal adsorptivity. With increasing pH, the heavy metal adsorptivity increased greatly between pHpzc and pH 6 or 7 because of the steep increase of negatively charged sites for synthetic zeolites, but for Hwangto, it increased broadly because of slow increase of negatively charged sites based on its lower surface sites.