Load carrying capacity(LCC) can be reduced from its design value as a result of film thickness change when a journal is misaligned and some part of bearing is unintentionally translated. In this study, the numerical solution of the incompressible Reynolds equation was obtained by using the finite difference method and mass conservation algorithm (JFO boundary condition) with periodic pressure distribution in circumferential direction to analyze the change of LCC due to journal misalignment and step change of film thickness in axial direction for a journal bearing of vertical pumps. Smallest LCC in each eccentricity ratio is obtained as two angular positions are changed – an angular position where misalignment occurs, and another angular position where the axial step takes place while the degree of misalignment is fixed at 90%. Compared with the reaction force of plain journal bearing, the LCC reduced as much as 26.7% due to geometric effects of journal bearing at the eccentricity ratio of 0.9, while the step height is no higher than 0.1 times of bearing clearance.

In the power steering systems used for automobiles, because of its small size and low noise, a balanced type hydraulic vane pump is mainly used as a power source. Therefore it is requested to research on the lubrication characteristics of a oil hydraulic vane pump which is the key part to improve its performance. The performance of a oil hydraulic vane pump is influenced by the lubrication characteristics of the critical sliding components. Thus, lubrication characteristics between the shaft and the journal bearing have to be researched for the design and the performance improvement of a oil hydraulic vane pump. Therefore, in this paper, it is theoretically investigated that the lubrication characteristics between the shaft and the journal bearing of a balanced type oil hydraulic vane pump for power steering systems. The results demonstrate that lubrication characteristics are significantly influenced by the clearance between the shaft and the journal bearing.

The planetary gearing system is compact and lightweight. The performance of planetary gearing system which uses floating intermediate rings have been found to be very good for practical systems. To apply this system for the reduction of rotation of an engine, in designing stage, the quantitative estimate of the load sharing factors is required for understanding the performance. The method widely used for this purpose is to make use of elastic deformation of components of the structure or to utilize hydrodynamic oil film. This paper shows the way how to analyze the static load sharing factors by using the coefficient ''. This method can be applied for non-linear systems such as oil film bearing. The influences of various factors on '' of oil film spring are also shown. Furthermore, It is established in this study that the use of floating intermediate ring in designing the planetary gearing system has a very high reliability.

형상 최적설계에서 절점의 재배치 및 형상 민감도 계산은 많은 노력이 필요하다. 본 연구에서는 구조물의 형상을 Bezier 곡선을 이용하여 표현하고, 민감도 계산을 위하여 개선된 직접미분법을 이용한다. 그리고, 절점의 재배치에는 변위장을 수정한 속도장을 이용한다. 또한, 본 연구에서는 자중을 고려한 외팔보와 3차원 저널베어링을 수치예제로 선택하여 본 연구의 기법들을 적용한 형상 최적설계를 해석한다.