This study was performed to analyze a saltiness enhancement at the same salt content through multiple emulsion. We compared the samples with different conditions to determine the optimum stability conditions of water-in-oil through layer separation rate, microscopic observation and size analysis. Four electrolytes such as NaCl, KCl, MgCl2, and CaCl2 were used and agar contents ranged from 0 to 1% were experimented at different volume ratios including 5:5, 4:6, 3:7, 2:8, and 1:9 of water and oil. As a result of this study, the droplet size according to the electrolyte type did not show significant differences (p<0.05). Therefore, KCl was used to facilitate in-body excretion of NaCl in the outer water phase, and corn oil containing 8%(w/w) polyglycerol polyricinoleate was used as oil phase. When the volume ratio of water and oil was 3:7, 2:8, and 1:9, the layer separation rate was relatively slow and droplet size was also small. It reveals that the particle size becomes smaller as the water volume ratio decreases. However, considering the amount of water to be stored and eluted on the inner water, appropriate volume ratio of water and oil should be adopted to 3: 7. At Microscopic observation depending on agar concentrations, small particle size appeared at 0.2% and 0.4% agars. When the water and oil ratio was fixed at 3:7, the particle size was measured at 0.2% and 0.4% agar using a zeta sizer. In conclusion, the droplet size of 0.2% agar was smaller than 0.4%. Therefore, the most stable water-in-oil emulsion was obtained with 0.2% agar, when water to oil ratio was 3:7.