This research studied faults that may occur during slow charging using the J1772 adapter of Tesla Model-3 electric vehicles. When the AC terminal was instantaneously disconnected, charging was performed normally when an AC circuit with disconnection up to three disconnection times was connected. Charging control was suspended when the number of disconnection reached four times. However, if the AC disconnection time exceeded 22 seconds, the charging control was stopped regardless of the number of disconnection. When a contact failure occurred at the AC terminal, high surge current and noise occurred. However, when the contact improved, the charging control continued. In terms of safety, it seems necessary to take measures such as stopping charging control when detecting noise.

In the event of an defective wire in the low-speed CAN communication of vehicle, the problem had to be solved by relying on fault codes or using expensive measuring equipment. An experiment was conducted to analyze waveforms of communication circuits with wire conditions such as normal, short circuits in the main body, and mutual short circuits. When the controller drives the CAN transceiver and transmits a message, the voltage and current waveforms were measured using an OEM oscilloscope to check for abnormalities in the circuit. As a result, it was confirmed that when a defective wire occurs in low-speed CAN communication, the CAN driver can switch to the fail-safe mode to exchange normal messages.

An implementation of OSEK NM, a network management protocol for automotive embedded systems, has been defined. In this experiment, the NM ID of each ECU of the vehicle is reverse-engineered when the vehicle is parked with a discharged battery, and the power management status and error status of each ECU and node are identified through NM ID OPCODE analysis, Sleep status, and Wake-up status, LIMP HOME status, were analyzed. After analyzing the NM OPCODE to find the faulty ECU, remove the cause of the failure and analyze the sleep mode entry state.In order to prevent the vehicle battery from being discharged, additional research is needed on how to enter the forced sleep mode when a failure not related to vehicle security occurs.

In order to identify the CAN message sent from the ECU, the CAN waveform and operating current were measured during the operation of the CAN driver.CAN ID was identified in the same phase as the measured voltage waveform and operating current, and reverse engineering was performed .And, by measuring CAN bus wire EMI noise, it was tested whether CAN ID was identified.CAN ID verified ECU data using CAN analyzer.

In this paper, we break away from the method of removing and inspecting the GDI injector, measure the pressure change of the fuel rail pressure sensor when driving the GDI injector of a vehicle equipped with the GDI fuel system, and compare the results. analyzed.There was a pressure change in the fuel rail pressure sensor from the general drive GDI injector. There was no pressure change in the fuel rail pressure sensor when driving the GDI injector without injecting fuel. You can check the fuel injection status in the pressure change data of the fuel rail pressure sensor without removal the GDI injector.

In this paper, each controller's unique ID and PICO oscilloscope were used to measure the voltage waveform of each CAN communication line, and compare and analyze the serial decoding results. Using the voltage change level of the CAN communication line, it was possible to check whether the CAN-High line and the Low line were disconnected. And it was possible to infer the circuit disconnection point between the controller and the controller only with the unique ID information of each controller. And when the CAN-High circuit was disconnected, the voltage of the high line was measured at the same voltage level as the Low line.