Water, plankton, blood and liver of crucian carp (Carassius auratus) and mandarin fish (Siniperca cherzeri) samples from 5 freshwater ecosystems in 3 major rivers of Korea including Nam Han River, Nakdong River and Yeongsan River were collected.

This is fundamental study to apply the waste edible-oil utilization technology using cooking oil. Especially, this study was carried out to apply a hot air heater using the waste edible-oil. This waste edible-oil hot air heater was a fuel supply equipment, a combustion and a indirect heat exchanger. waste edible-oil hot air heater was remodeled and manufactured by modification of a heavy oil hot air heater of a heating capacity 40,000kcal/h, changing fuel supplying system fitted with the waste edible-oil. An experimental apparatus supplies waste edible-oil, which is heated with intake oil, into an intake fuel injection nozzle of the combustion equipment. As the result, heavy oil, light oil and waste edible-oil Caloric value were 10,000kcal/kg, 10,890 kcal/kg and 9,370 kcal/kg. The waste edible-oil hot air heater performance showed that air temperature at inlet , outlet and exhaust gas were 23℃, 59∼63℃, 280℃ respectively. heat rating and thermal efficiency showed that in hot air heater was 683,333kJ/h, 78% respectively. It was found that CO, CO2 were 13ppm, 13.1%. waste edible-oil consumption rate was 22.1ℓ/h.

This study was carried out to investigate of the combustion characteristics for the waste edible-oil and heavy oil on hot air heater. There was highly reduction in energy cost using by the hot air heater. The hot air heater to study with duct connector type, and the motor output was 2.2kW. The experimental factors for performance test, fan speed ranged from 1700 rpm to 1800rpm, and SFC, efficiency, exhaust gas emissions, and noise were measured. The results obtained were as follows; efficiency were increased to 87% at the heavy oil and was decreased to 79% on the waste edible-oil. The fuel consumption was decreased to 25L/h at the heavy oil and CO2 emissions was decreased in the case of the heavy oil

This study was carried out to investigate of the performance for Sweet potato Harvester using Power-tiller. There was highly reduction in energy consumption using by Sweet potato Harvester of Power-tiller. A diesel engine with four cycle with single cylinder, water cooling and rated output 8.1 kW/2200 rpm was selected. The experimental factors for performance test, engine speed ranged from 1000 rpm to 2400 rpm, and BSFC, efficiency, traction power, and vibration were measured. The results obtained were as follows; engine output were increased from 4.4 kW to 5.74 kW at 1800 rpm and increased to 8.83 kW at 2400 rpm The specific fuel consumption was decreased to 320 g/kW.h at engine speed 2200 rpm and the traction power were showed 420~440 kgf.

This technology is to highly produce heat by microorganism during fermentation of mushroom sludge as a byproduct at farm field which would be established more competitive in mushroom growers and distinguished technology with ordinary mushroom growers. Furthermore this technology could be reduced energy as well as high efficiency in resource uses. There was highly reduction in energy consumption using by heat during fermentation of mushroom sludge which was produced by different media material with vegetable for mushroom cultivation. After 4 days the inner temperature during fermentation of mushroom media was a little changes of 61～50℃ and inner temperature of fermentation chamber was 55～45℃, inlet temperature of cooling water was 17℃, outlet temperature was 44～35℃, and ambient temperature was 28℃ at daytime and 14℃ at night time which was relatively constant. A heat exchange from fermentation chamber was 1090～648㎉/10min and the maximum heat exchange was 11550～1064㎉/10min which was caused to reduce fermentation heat with time The efficiency of heat exchange was distributed with 81～61% with time.

처분장에서 지하수로 쉽게 유출될 수 있는 방사성 핵종들의 양을 예측하기 위하여 국내 PWR 사용후핵연료 팰렛들의 갭(gap) 및 입계에 있는 용해성 원소들의 재고량을 측정하였다. 연소도가 GWD/MTU를 갖는 연료봉에서 얻은 펠렛들에서 세슘의 갭 재고량이 로 나타났으며, 이는 핵분열 생성기체 유출률의 에 해당하였다. 그러나 핵분열 생성기체 유출 률이 1%이하인 연료봉에서 취한 40 GWD/MTU이하의 연소도를 갖는 펠렛들의 경우, 세슘의 갭 재고량들을 핵분열 생성기체 유출률과 연관시키기는 곤란하였다. 갭 및 입계내 스트론튬의 재고량은 동일 연료봉내 펠렛에서는 크게 다르지 않았으며, 요오드의 갭 재고량은 핵분열 생성기체 유출률보다 작거나 유사한 값을 갖는 것으로 평가되었다.

Co-Fe-Ni-B-Si-Cr based amorphous strips containing nitrogen were manufactured via melt spinning, and then devitrified by crystallization treatment at the various annealing temperatures of for up to 30 minutes in an inert gas atmosphere. The microstructures were examined by using XRD and TEM and the magnetic properties were measured by using VSM and B-H meter. Among the alloys, the amorphous ribbons of containing 121 ppm of nitrogen showed relatively high saturation magnetization. The alloy ribbons crystallized at showed that the grain size of alloy containing 121 ppm of nitrogen was about f nm, which exhibited paramagnetic behavior. The formation of nano-grain structure was attributed to the finely dispersed Fe4N particles and the solid-solutionized nitrogen atoms in the matrix. Accordingly, it can be concluded that the nano-grain structure of 5nm in size could reduce the core loss within the normally applied magnetic field of 300A/m at 10kHz.

본 연구는 우리나라 고유의 유전자원인 재래산양의 체내수정란 생산기술을 확립하고자 수행하였다. 흡입법(aspiration)과 세절법(slicing)에 의해 난소 한 개당 회수된 난자의 수는 3.9개와 4.1개를 나타내어 slicing방법이 aspiration방법보다는 많은 숫자의 난자를 회수하였으나 유의적인 차이는 나타내지 않았다. 회수된 난자의 등급별 분포는 aspiration방법에서 Grade I, Grade II, Grade III, Grade IV

한국 재래산양 체내수정란 생산에 대한 발정동기화 및 과배란 유도방법과 회수된 수정란의 동결 융해 후 생존율을 조사하였다. 발정동기화를 위해 CIDR+FSH 및 CIDR+PMSG의 방법을 이용한 결과, 배란점 및 회수된 수정란의 수는 CIDR+FSH 처리구에서 16.3개 및 9.4개, CIDR+PMSG 처리구에서 16.4개 및 8.7개를 나타내어 두 처리구간에 유의적 차이는 인정되지 않았다. 회수된 수정란을 형태학적으로 평가한 결과 CIDR+FSH 처리구

복숭아혹진딧물(Myzus persicae Sulzer)은 두가지 서로 다른 기주선호성을 가지는데 이 기주선호성과 형태적 특징에 기초하여 담배진닷물(Myzus nicotinae Blackman)과 담배 이외의 다른 채소류에 서식하는 복숭아 혹진딧물(M. persicae)로 분류하였지만(Blachmean, 1987) 이 분류 방법에 동의하지 않는 학자들도 많다. 이런 이유로 RAPD-PCR 기법을 이용하여 한국에 서식하는 복숭아혹진딧물에 대하여 그들의 2차 숙주선호성에 따른 DNA의 변이 정도를 살펴보았다. 실험곤충으로는 담배와 배추에서 채집하여 사육한 진딧물 각 4 clones 씩을 사용하였다. 각 clone은 한 개체를 사육하여 얻은 자손들과 그들의 후손으로 이루어졌으며, 사육한 진딧물에서 핵 DNA를 추출하고, 10개 nucleotide 길이의 random primer 100가지를 사용하여 PCR한 후 1 % agarose gel 전기영동법으로 분석하였다. 사용한 100종류의 random primer 중 83가지에서 DNA 단편이 합성되었다. 증폭된 1개의 primer당 단편의 수는 1개에서 22개였고 평균 단편 수는 약 13개였으며, 각 각 단편의 길이는 500에서 20,000 base pair사이에 분포하였다. 82가지 primer의 경우에 일부 단편의 짙기에는 차이가 있었으나 단편종류의 분포는 동일하게 나타났다. 한가지 primer경우에만 담배섭식형 1개 c clone에서 다른 7가지 clones에 없는 band가 1개 나타났다. 이때 나머지 7 clones의 단편 분포 형태는 모두 동일하였다. 따라서 이 band는 숙주 선호성과는 무관한 것으로 보인다. 결국 이 실험에 사용한 100종류의 primer에 기초하여 RAPD-PCR기법으로 DNA를 증폭한 결과 복숭아혹진딧물의 숙주선호성이 개체군간의 유전적인 차이점에 기인한다는 가설을 뒷받침할 만한 증거를 찾지 못하였다.