This short review focuses on fouling by proteins and macromolecules in microfiltration/ultrafiltration. First, an experimental system that enables investigation of how the extent of the adsorption of proteins and macromolecules on membrane surfaces contributes to a decrease in filtrate flux in microfiltration/ultrafiltration is described. Using this system, a causal relationship - not a correlation - indicating that adsorption results in a decrease in filtrate flux could be clearly demonstrated in some cases. Second, a hydration structure at the membrane surface that can suppress adsorption is discussed, inspired by biomaterial research. In their hydrated states, polymers with low-fouling properties have water molecules with a particular structure. Finally, some successful examples of the development of low-fouling membranes via surface modification using low-fouling polymers are discussed.

Herein, the edges in carbon materials were quantitatively evaluated by summing the amount of hydrogen and the amount of functional groups without hydrogen in the material. The amount of hydrogen in the carbon material was quantitated via temperature-programmed oxidation (TPO) under an oxygen atmosphere, whereas the amount of functional groups was determined via temperature-programmed desorption (TPD) of the sample under an inert atmosphere. Consequently, the amount of edges in exfoliated carbon fibers prepared from polyacrylonitrile (PAN) (referred to as PAN-1000) was 9.4 mmol g−1. In addition, Ketjen Black (KB) and activated carbon (AC) had edge content of 1.3 and 3.6 mmol g−1, respectively. Because the total amount of functional groups of PAN-1000, KB and AC were estimated to be 8.18, 0.082 and 1.02 mmol g−1 via TPD, the total amount of edges and oxygen-containing functional groups of each sample could be quantified. The difference between amount of edges and the amount of functional groups is speculated to correspond to the amount of edges terminated with hydrogen. This study revealed that detailed information about the edges such as their proportion terminated with oxygen-containing functional groups, the species and amount of oxygen-containing functional groups via a combination of TPO and TPD.

Pulsed Current Sintering (PCS) process possesses some problems that need to be resolved. We, therefore aims at understanding phenomena of PCS process by presenting some basic data on in situ sintering behavior of PCS. Special graphite mold equipped with thermo couple and electrodes were designed to measure the temperature, electric current and voltage inside the powder during PCS process. We apply three types of raw materials, especially for ZnO as semiconductor, Al2O3 as non-conductor and WC as good conductor. The electric current and voltage were measured for each powder during PCS process. In addition, their electric resistance properties were calculated.

Mechanical properties of metal injection molded titanium and titanium alloy parts were investigated in this study. Material powders with low oxygen content and spherical shape were obtained by electrode induction-melting gas atomization which could melt and atomize titanium and titanium alloy bars with no touch on crucible or tundish. Tensile specimens were fabricated from obtained powders by metal injection molding process. Tensile strength of the specimens increases with increasing oxygen content. This result corresponds to a tendency of wrought metal.

Austenitic stainless steel has been used as a corrosion resistance material. However, austenitic stainless steel has poor wear resistance property due to its low hardness. In this investigation, we apply powder composite process to obtain hard layer of Stainless steel. The composite material was fabricated from planetary ball milled SUS316L stainless steel powder and WC powder and then sintered by Pulsed Current Sintering (PCS) method. We also added TiC powder as a hard particle in WC layer. Evaluations of wear properties were performed by pin-on-disk wear testing machine, and a remarkable improvement in wear resistance property was obtained.