Novel Ni- and Fe-based alloys are developed to impart improved mechanical properties and corrosion resistance. The designed alloys are manufactured as a powder and deposited on a steel substrate using a high-velocity oxygen-fuel process. The coating layer demonstrates good corrosion resistance, and the thus-formed passive film is beneficial because of the Cr contained in the alloy system. Furthermore, during low-temperature heat treatment, factors that deteriorate the properties and which may arise during high-temperature heat treatment, are avoided. For the heattreated coating layers, the hardness increases by up to 32% and the corrosion resistance improves. The influence of the heat treatment is investigated through various methods and is considered to enhance the mechanical properties and corrosion resistance of the coating layer.

In this study, STS 316L powders with 3 wt.% Cu and 1 wt.% Sn known as corrosion-resistance reinforce- ment elements, are prepared to make different kinds of specimens, in which, 3 wt.% Cu and 1 wt.% Sn are added in different forms by mixing, alloying and fully alloying. After sintering in the same condition, the corrosion resistance, wear resistance and their mechanical properties of specimens are tested respectively. According to the comparison, STS 316L specimen sintered at 1270o C showed the most excellent mechanical property: HRB 78 (hardness), 1130.7 MPa (RCS), 26.6% (Fraction Wear), It was similar with the specimen made of STS316L and fully alloyed Cu and Sn pow- ders, meanwhile, the latter one appears the best corrosion resistance, 75hrs-salt immersion test results. In addition, the specimens with Cu and Sn powders additive showed relatively worse wear resistance in compared with STS316L spec- imen.

현재 지구온난화 등의 환경문제로 인해 각종 산업분야에서 정량화에 대한 요구가 증대되어 해양산업에도 그 수요가 증가하고 있는 실정이다. 따라서 본 연구에서는 차세대 경량화 재료인 마그네슘이 활용되기 위해서 반드시 극복해야할 가장 중요한 특성인 내식특성에 대하여 고찰하고, 그 내식특성 향상을 위한 마그네슘 박막의 Morphology나 결정배향성의 영향을 해명하고자 하였다. 실험결과로부터 제작한 Mg 박막의 전기화학적 내식특성은 Ar 가스압이 높은 조건에서 제작한 막일수록 내식특성이 우수하였다. 이러한 경향은 표면 및 단면의 Morphology와 결정배향성과의 상관관계를 통하여 설명 가능하였다.

In this thesis, using the 400 series ferrite stainless steel such as 434LD2 which are furter excellent then the existing ferric products in mechanical characteristics, and experiment has been conducted on corrosion resistance of sensor ring. The results are following. 1. The products before sintering are much more corrodible in the condition of spray test of salt water and ammonia than humidity and nitrogen condition. 2. 434LD2 ferrite stainless steel has shown a good corrosion resistance without an addition surface treatment. thus the decreasing production process has been obtained. 3. As hardness value of HRB 80 and tensile test, 434LD2 ferrite stainless steel with show a good endurance when it is combined to constant velocity joint (c/v joint), and has a good hardness properties endurable to sand and pebble impact.