A comprehensive understanding of actinide coordination chemistry and its structure is essential in many aspects of the nuclear fuel cycle, such as fuel reprocessing, waste management, reactor safety, and non-proliferation efforts. Managing radioactive waste generated during the nuclear fuel cycle has recently become more important, accordingly increasing the importance of designing appropriate waste forms and storage solutions for long-term waste disposal. Compared to the increase in the need for understanding the chemistry of major radioactive elements, the information on the local structure of the radioactive elements, especially actinides, remains unknown. To probe this issue, X-ray absorption fine structure (XAFS) can be applied. By analyzing the EXAFS (extended X-ray absorption fine structure) and XANES (X-ray absorption near edge structure), the local structure around atoms can be determined. However, the radioactive properties of the nuclides hindered the measurement of EXAFS and XANES, due to the difficulties of preparation, containment, and transfer of the sample. To measure the EXAFS of various compounds regarding the back-end nuclear fuel cycle, laboratory-based EXAFS (hiXAS, HP spectroscopy) has been introduced which can measure the EXAFS and XANES at the energy range of 5-18 keV. Compounds of Copper (Cu foil, CuO samples), Zirconium (Zr foil), and Europium (Eu2O3) were used for the verification of the laboratory -based EXAFS at a given energy range. The measured EXAFS spectrum of various compounds exhibit good agreement with the theoretical data, showing an R-factor of less than 0.02. It was found that each graph has a first peak corresponding to 2.55Å for Cu foil (Cu-Cu), 1.93Å for CuO samples (Cu-O), 3.23Å for Zr foil (Zr-Zr), and from 2.32Å to 2.34Å for Eu2O3 (Eu-O), which agree well with other values from the literature. From the result, it can be implied that this equipment can be used especially in the back-end nuclear fuel cycle field to enhance the understanding of local structure in radiochemistry.

Disposal of radioactive waste requires radiological characterization. Carbon-14 (C-14) is a volatile radionuclide with a long half-life, and it is one of the important radionuclides in a radioactive waste management. For the accurate liquid scintillation counter (LSC) analysis of a pure beta-emitting C-14, it should be separated from other beta emitters after extracted from the radioactive wastes since the LSC spectrum signals from C-14 overlaps with those from other beta-emitting nuclides in the extracted solutions. There have been three representative separation methods for the analysis of volatile C-14 such as acid digestion, wet oxidation, and pyrolysis. Each method has its own pros and cons. For example, the acid digestion method is easily accessible, but it involves the use of strong acids and generates large amount of secondary wastes. Moreover, it requires additional time-consuming purification steps and the skillful operators. In this study, more efficient and environment-friendly C-14 analysis method was suggested by adopting the photochemical reactions via in-situ decomposition using UV light source. As an initial step for the demonstration of the feasibility of the proposed method, instead of using radioactive C-14 standards, non-radioactive inorganic and organic standards were investigated to evaluate the recovery of carbon as a preliminary study. These standards were oxidized with chemical oxidants such as H2O2 or K2S2O8 under UV irradiations, and the generated CO2 was collected in Carbo-Sorb E solution. Recovery yield of carbon was measured based on the gravimetric method. As an advanced oxidation process, our photocatalytic oxidation will be promising as a time-saving method with less secondary wastes for the quantitative C-14 analysis in low-level radioactive wastes.

The decommissioning of nuclear facilities produces various types of radiologically contaminated waste. In addition, dismantlement activities, including cutting, packing, and clean-up at the facility site, result in secondary radioactive waste such as filters, resin, plastic, and clothing. Determining of the radionuclide content of this waste is an important step for the determination of a suitable management strategy including classification and disposal. In this work, we radiochemically characterized the radionuclide activities of filters used during the decommissioning of Korea Research Reactors (KRRs) 1 and 2. The results indicate that the filter samples contained mainly 3H (500–3,600 Bq·g−1), 14C (7.5–29 Bq·g−1), 55Fe (1.1– 7.1 Bq·g−1), 59Ni (0.60–1.0 Bq·g−1), 60Co (0.74–70 Bq·g−1), 63Ni (0.60–94 Bq·g−1), 90Sr (0.25–5.0 Bq·g−1), 137Cs (0.64–8.7 Bq·g−1), and 152Eu (0.19–2.9) Bq·g−1. In addition, the gross alpha radioactivity of the samples was measured to be between 0.32–1.1 Bq·g−1. The radionuclide concentrations were below the concentration limit stated in the low- and intermediatelevel waste acceptance criteria of the Nuclear Safety and Security Commission, and used for the disposal of the KRRs waste drums to a repository site.