WAAM(Wire Arc Additive Manufacturing) has gained attention as an innovative technology in small-batch, multi-product production due to its advantages of low production costs, rapid build rates, and design flexibility. However, challenges such as relatively low geometric accuracy, surface finish defects, residual stresses, and distortion due to high heat input persist and require improvement. This study analyzes the influence of deposition path angles on deposition performance in the WAAM process. Experiments were conducted using stainless steel (STS309MoL) wire, known for its excellent heat resistance and corrosion resistance due to its relatively high ferrite content within the austenitic structure. To mitigate residual stresses and distortion caused by high heat input, the CMT(Cold Metal Transfer) process was employed for five layers of deposition. Five different deposition path angles were selected as process variables, and the impact of deposition path angles on deposition performance was evaluated based on experimental results.

This study was conducted to compare the mechanical properties of NAB (Ni-Al-Bronze) material manufactured using WAAM (wire arc additive manufacturing) technology and cast NAB that has been used. Two types of mechanical property test pieces were collected from the deposited bulk NAB material according to the direction of deposition, and compared with each other. As a result of mechanical property evaluation, the deposited NAB exhibited anisotropy according to the direction of deposition, and showed high tensile strength, hardness, and shock absorption in the longitudinal direction of the welding line.

A basic metal deposition experiment for manufacturing aluminum parts was performed using WAAM (Wire arc additive manufacturing), and the cross-sectional shape of the laminate according to nine deposition conditions. The effect of heat input was analyzed for the bead shape according to the deposition conditions, and the deposition efficiency was calculated by analyzing the cross-sectional shape of thin-wall parts made of aluminum. The amount of heat input was used in the experiment from about 2.7 kJ/cm to 4.5 kJ/cm, and the closer the heat input was to 4.5kJ/cm, the higher the deposition efficiency was. The maximum lamination efficiency obtained through this study reached 76%.