An irradiation hardening of Inconel 718 produced by selective laser melting (SLM) was studied based on the microstructural observation and mechanical behavior. Ion irradiation for emulating neutron irradiation has been proposed owing to advantages such as low radiation emission and short experimental periods. To prevent softening caused by the dissolution of ' and '' precipitates due to irradiation, only solution annealing (SA) was performed. SLM SA Inconel 718 specimen was ion irradiated to demonstrate the difference in microstructure and mechanical properties between the irradiated and non-irradiated specimens. After exposing specimens to Fe3+ ions irradiation up to 100 dpa (displacement per atom) at an ambient temperature, the hardness of irradiated specimens was measured by nanoindentation as a function of depth. The depth distribution profile of Fe3+ and dpa were calculated by the Monte Carlo SRIM (Stopping and Range of Ions in Matter)-2013 code under the assumption of the displacement threshold energy of 40 eV. A transmission electron microscope was utilized to observe the formation of irradiation defects such as dislocation loops. This study reveals that the Frank partial dislocation loops induce irradiation hardening of SLM SA Inconel 718 specimens.

Graphite fibers are materials with a high specific modulus that have attracted much interest in the aerospace industry, but their high manufacturing cost and low yield are still problems that prevent their wide applications in practice. This paper presents a laser-based process for graphitization of carbon fiber (CF) and explores the effect of laser radiation on the microstructure of CF. The obtained Raman spectra indicate that the outer surface of CF evolves from turbostratic structures into a three-dimensional ordered state after being irradiated by a laser. The X-ray diffraction data revealed that the growth of crystallite was parallel to the fiber axis, and the interlayer spacing d002 decreased from 0.353 to 0.345 nm. The results of scanning electron microscopy revealed that the surface of irradiated CFs was rougher than that of the unirradiated ones and there were scale-like small fragments that had peeled off from the fibers. The tensile modulus increased by 17.51% and the Weibull average tensile strength decreased by 30.53% after being irradiated by a laser. These results demonstrate that the laser irradiation was able to increase the graphitization degree of the CFs, which showed some properties comparable to graphite fibers.

We pathologically investigated the effects of water irrigation during Er:YAG laser irradiation on wound healing in mouse skin. Fifty-one 6-week-old ICR male mice were used in the present study. Dermal wounds were generated on the skin of the backs using the Er:YAG laser at 100 mJ/pulse and 10 Hz with (4 ml/min) or without (control) water irrigation. Mice were then sacrificed on 0, 1, and 3 days after laser irradiation, and the crust of the skin and thickness of the thermal coagulation layer were evaluated pathologically. The epidermis extended faster in the water irrigation group than in the control group on 1 day. The epidermis with keratinized layers became thicker and the crust had completely detached after 3 days in the water irrigation group. The thermal coagulation layer was thinner in the water irrigation group than in the control group. Apoptotic cell death was prominent in the control group. Detachment of the crust was observed after 3 days in 50% of the water irrigation group and 20% of the control group. These results demonstrated that Er:YAG laser irradiation with water irrigation promoted faster wound healing

Currently, dental implants are generally used for reconstruction of oromaxillofacial defects. Implants are widely used in dental and medical fields. The materials of implants are variable such as metals and ceramics. The materials of implants must be have not toxicity and biocompatibility to host and mechanical(physical) strength. Bones must be attached to titanium surface without any other tissues. many researcher's had studied for raising the osseointegration through various method which are including implants designs and materials. It was reported over 95% success ratio. many researcher's study the methods which are enhancing the speed of bone remodelling and osseointegration. Thermo dynamic therapy is one of the method to accelerlate the speed of bone remodelling and osseointegration. Thus it raise stability of implants. The purpose of this study was to evaluate the effect of diode laser irradiation for ossoeintegration in implant interface and between the implants threads. 24 New Zealand white rabbits which were about 3kg weight, used for experiment. 2 implant's were implanted every rabbit's tibia. 2 weeks, 4 weeks, 8 weeks after implantation, tissue sample were removed from sacrificed rabbit's tibia. 8 rabbit's were sacrificed every 2, 4, 8 weeks and undecalcified sample were made from tissue sample. We have investigated the undecalcified samples by back scattered electron microscope. We have analysied the length rate and area rate in implant interface and inside the threads. The results were as follows. 2 weeks, 4 weeks, 8 weeks experimental groups which were irradiated low level laser therapy showed rapid bone remodelling than control groups. It was suggested that Initial bone remodelling may be effected by LLLT because of implant bone contact ratio between 4th weeks and 8th weeks had no siginifant difference. Initial bone remodelling may be more influenced than later bone remodelling by LLLT because of new bone formation area ratio between implant threads had no significant differences during 4th to 8th weeks. According to above results, low level laser irradiation accerlate the new bone formation in implant interface and inside the implants threads at initial stage. there were many factors which are increasing the bone remodelling, because there were many differences between experimental and control groups. Low level laser irradiation were helpful for increasing the initial stage of bone remodelling because of above results.

Currently, implants are widely used in dental and medical fields. Especially dental implants are widely used for reconstruction of oral and maxillofacial defects. Many researcher's had studied for raising the osseointegration through various method. It was reported high success rate. Also they study the enhancing the speed of bone remodelling and osseointegration. Low level laser therapy is introduced one of the methods to accelerate the speed of bone remodelling and osseointegration. The purpose of this study was to evaluate the effect of diode laser irradiation about to raise ossoeintegration. Twenty four New Zealand white rabbits which were about 3Kg were used for experiment. Two implants were implanted same side of rabbits tibia. Diode laser was irradiated 1cm diameter, 0.5 watt power, 1 minute duration at periphery of one of implants. Eight rab b its were sacrificed every 2, 4, 8 weeks, made undecalcified sample. We investigated in the undecalcified samples histological and histomorphometrc analysis by light microscope. The results were as follows. 2 weeks, 4 weeks, 8 weeks experimental groups which were showed rapid bone remodelling than control groups. They showed many difference especially in early healing time. Bone Implant contact rate were 47% in 2 weeks experimental group. 28% in 2 weeks control groups, 82% in 4 weeks experimental groups, 62% in 4 weeks control groups, 98% in 8 weeks experimental groups and 84% in 8 weeks control groups then experimental groups show statistically significant difference(p＜0.05). Bone remodelling area rate inside the implant threads were 49% in 2 weeks experimental groups. 31% in 2 weeks control groups, 90% in 4 weeks experimental groups, 82% in 4 weeks control groups, 99% in 8 weeks experimental groups and 97% in 8 weeks control groups then 2,4 weeks experimental groups show statistically significant difference(p＜0.05). Implant-bone contact length rate and bone remodelling area rate were no significant difference of linear regression equation of control and experimental groups then bone remodelling were different at early healing time but there were no differences of time changes. According to above results, one of the low level lasers diode laser irradiation was effected on the volume of new bone formation in implant interface and between the implants threads. Low level laser irradiation were helpful for initial stage of bone remodelling.

Laser is used to prevent the early dental caries in dental f ield and to apply for treatment of stomatitis and hyper sens it ivity , and laser mass Recently it is reported that laser i1'r adiation affect on soft tissue treatment and bone 1'emodelling after dental implantation. The purpose of this study was to examine laser irradia ti on effect on activity of normal human osteoblast on titanium plate in vitro by various laser wave length, and to observe morphologic change of NHost on LiLa nium plate and to a nalysis concentration of Ca"++ , IP and ALP NHost were cultured in DMEM containing 10% FBS, and observed by in verted microscope 1"or attatchment to the surface of titanium plate. Ca ++, I.P. , and a lkaline phosphat ase(ALP) concent ration in medium was calculated during 4 weeks, which was treated with Wilcoxon rank, Anova test and linear regression. The obtained results were as follows Morphologic changes showed rapid growth rate of NHost ++ at 3 days of laser lrradiatlOn ln spite of laser wave type, Ca" and P concentration was decreased at 2 weeks and was the hig hest at 3 weeks, but decreased at 4 weeks In spite of laser wave type, ALP concentration was decreased at 2 weeks but was increased at 3-4 weeks, From the aboving results, in spite of laser wave type, there were rapid growth rat e of NHost a nd no significant of Ca"++ , IP and P concen tr ation but these concentration showed predominant change than that of control