In this study, i machined micro hole to PCB(Printed circuit board) with ultra precision spindle system for mechanical micro drilling. For this i utilized 0.4∼0.6 ㎜ micro drill and observed cutting edge and hole. Results are as follows; in case of drilling with 0.4∼0.6 ㎜ micro drill, micro hole was made specific range of diameter up to 300 times drilling and micro drilled diameter was bigger than micro drill’s diameter at 300 times over. Error ratio of drilled diameter and damaged hole diameter was within 5 % and 17 %. I observed 0.4 ㎜and 0.6 ㎜micro drill’s cutting edge after 500 times drilling and confirm cutting edge width variation and damage, same result found 1000 times drilling with 0.5 ㎜ micro drill.

The optical film for light luminance improvement of back light unit that is used in light emitting diode/liquid crystal display and retro-reflective film is used as luminous sign consist of square and triangular pyramid structure pattern based on V-shape micro prism pattern. In this study, we analyzed machining characteristics of Cu-plated flat mold by shaping with diamond tool. First, cutting conditions were optimized as V-groove machining for the experiment of micro prism structure mold machining with prism pattern shape, cutting force and roughness. Second, the micro prism structure such as square and triangular pyramid pattern were machined by cross machining method with optimizing cutting conditions. Variation of Burr and chip shape were discussed by material properties and machining method.

Micro trench structures are applied in gratings, security films, wave guides, and micro fluidics. These micro trench structures have commonly been fabricated by micro electro mechanical system (MEMS) process. However, if the micro trench structures are machined using a diamond tool on large area plate, the resulting process is the most effective man- ufacturing method for products with high quality surfaces and outstanding optical characteristics. A nonferrous metal has been used as a workpiece; recently, and hybrid materials, including polymer materials, have been applied to mold for display fields. Thus, the machining characteristics of polymer materials should be analyzed. In this study, machining characteristics were compared between nonferrous metals and polymer materials using single crystal diamond (SCD) tools; the use of such materials is increasing in machining applications. The experiment was conducted using a square type diamond tool and a shaper machine tool with cutting depths of 2, 4, 6 and 10 µm and a cutting speed of 200 mm/s. The machined surfaces, chip, and cutting force were compared through the experiment.

High-pressure abrasive entrained jet have rapidly become important machining technology over the last two decades. However, suspension jet by high-pressure has been recently developed for packaging sawing. Ideally, diamond materials should be used for components in abrasive water-jet systems that are subject to high erosive conditions. Using the diamond orifices improve maintenance and extend wear part life. This paper gives insights to using an abrasive suspension jet with diamond orifice. The influences of orifice material and orifice design are evaluated.