It has been studied on the disposal area reduction for the used nuclear fuel by the management of high decay-heat nuclides, long-lived nuclides, and highly mobile nuclides. It was investigated on the management of the nuclides in KAERI. Strontium-90 is a high heat-generating nuclide in spent nuclear fuel. It is needed to separate the salt from the salt solution for the recovery of strontium after the chlorination of the strontium oxide in molten salt. Vacuum distillation was used for the separation of strontium from the molten salt. Potassium carbonate was chosen as a reactive distillation reagent for SrCl2 – LiCl – KCl system by the thermodynamic calculation. Reactive distillation experiments were carried out. The residual was mainly SrCO3 in the XRD analysis. It could be concluded that K2CO3 could be one of the suitable reagents for the reactive distillation. The salt in the long–lived nuclide powders should be removed to prepare the block for disposal. Experiments were carried out using W powders (surrogate) and U3O8 powders to develop a process for the removal of the residual salt from UOx powders. The salts were successfully removed from the W and U3O8 powders by distillation.

The effect of Li2O addition on precipitation behavior of uranium in LiCl-KCl-UCl3 has been investigated in this study. 99.99% LiCl-KCl eutectic salt is mixed with 10wt% UCl3 chips at 550°C in the Pyrex tube in argon atmosphere glove box, with 10 ppm O2 and 1 ppm H2O. Then, Li2O chunks are added in mixed LiCl-KCl-UCl3 and the system has been cooled down to room temperature for 10 hours to form enough UO2 particles in the salt. The solid salt has been taken out from the glove box, and cut into three sections (top, middle and bottom) by low-speed saw for further microscopic analysis. Three pieces of solid salt are dissolved in deionized water at room temperature and the solution is filtered by a filter paper to collect non-dissolved particles. The filter paper with particles is baked in vacuum oven at 120°C for 6 hours to evaporate remaining moisture from the filter paper. Further analysis was performed for the powder remaining on the filter paper, and periphery of the powder (cake) on the filter paper. Scanning electron microscopy (SEM), electron diffraction spectroscopy (EDS), and X-ray powder diffraction (XRD) are adopted to analysis the characteristic of the particles. From SEM analysis, the powders are consisted of small particles which have 5 to 10 m diameter, and EDS analysis shows they are likely UO2 with 23 at. % of uranium and 77 at. % oxygen. Cake is also analyzed by SEM and EDS, and needle like structures are widely observed on the particle. The length of needle is distributed from 5 to 20 m, and it has 6 to 10 at. % of chlorine, which are not fully dissolved into deionized water at room temperature. From XRD analysis, the particles show the peak position of UO2, and the result is well matched with the SEM-EDS results. We are planning to add more Li2O in the system for fully reacting uranium in UCl3, and compare the results to find the effect of Li2O concentration on UO2 precipitation.

The purpose of this study was to investigate the impacts of cane-based fruiting position on fruit quality at harvest in a golden-flesh kiwifruit variety, ‘Sweet Gold’ (Actinidia chinensis var. chinensis). The vines were grown on a pergola-trained system, under a protected plastic film house in Jeju, Korea. The cane-based fruiting positions were classified into six sectors with three sectors acropetally from the trunk to the apex of the leader, and two sectors acropetally from the leader to the apex of the cane. Fruits positioned in sectors far away from the trunk (sectors three and six) tended to be heavier, whereas fruits in sectors close to the trunk (sectors one and four) exhibited higher dry matter, soluble solid contents, and flesh coloration. The highest firmness was obtained at the fruits positioned far from the trunk and leader (sector six). Titratable acidity was slightly impacted. The highest starch content was obtained from the fruits of sector six far from the trunk and leader, whereas the highest soluble sugar content was from sector one proximal to the trunk and leader. Results indicate appreciable variations in fruit quality parameters at harvest, among fruits at different fruiting positions within vines. However, these variations were inconsistent over the years, and there were no distinct correlations among these fruit quality parameters.

Minuartia laricina (L.) Mattf. is a Korean native plant with high potential as a commercial flowering potted plant due to its compactness and long flowering duration. However, because this plant is a groundcover, it is susceptible to lodging and leggy growth. Therefore, this study investigated the effects of plant growth retardants (PGRs) on the inhibition of stem elongation and flowering characteristics of M. laricina. Commercial products, Trimmit, Cycocel, and B-Nine, were used for the exogenous PGR application of paclobutrazol (PBZ), chlormequat chloride (CCC), and daminozide (DMZ), respectively. Application concentrations were 50 and 100 mg·L-1 for PBZ; 100, 500, and 1,000 mg･L-1 for CCC; and 500, 1,000, and 2,000 mg·L-1 for DMZ. Paclobutrazol was the only PGR that inhibited stem elongation. The stem lengths of the plants treated with 50 or 100 mg·L-1 PBZ were 2.2 cm (13%) or 9.8 cm (57%) shorter, respectively, than those of the control. 50 mg·L-1 PBZ retarded stem growth effectively without negatively affecting flowering or other growth parameters, whereas 100 mg·L-1 PBZ caused excessive dwarfing and significantly reduced flowering by 59%. CCC and DMZ applications were ineffective for growth control. Flowering time was accelerated with most PGRs, except for 2,000 mg·L-1 DMZ, reducing the time to flowering by 2–8 days. These results indicate that the stem growth of M. laricina was successfully inhibited with PBZ but not with CCC or DMZ. Thus, we concluded that a single application of 50 mg·L-1 PBZ or similar treatment is effective in miniaturizing M. laricina without causing harm to its growth or aesthetic value, such as the flower number. Additionally, because CCC and DMZ are not persistent in the growing medium, testing multiple application times for these PGRs is crucial.

Sustainable capacity building of the rice value chain in Africa is essential in achieving the rice self-sufficiency and poverty alleviation. The breeding capacity enhancement has also been at the heart of AfricaRice’s mandate. Therefore, the Korea-Africa Food and Agriculture Cooperation Initiative (KAFACI) has concentrated breeding capacity enhancement for young breeders or breeding technicians of national research institutes in the KAFACI member countries. Four-month trainings have been conducted at the Regional Training Center located in Saint Louis, Senegal. The actual practice training is as follows; First is to learn practical skills and techniques of key aspects of rice breeding which are field preparation and layout, sowing, transplanting, fertilizer application, weed control, water management, hybridization/crossing, selection, yield and yield components determination, and rice palatability testing. Second is to learn some theoretical aspects of plant breeding through lectures including basic principles of breeding, evaluation for biotic and abiotic stresses, and statistical analysis. Third is to learn about the accurate use of field and lab equipment for rice breeding. Forth is to learn about proper scientific reporting and presentation. The courses were organized twice per year following two rice cultivation seasons in Senegal. From 2019, a total of 24 trainees participated in the 4 month courses. We believe they have acquired the basic knowledge and skills to implement rice breeding activities indpendently in their countries.