PURPOSES : The objective of this study was to evaluate the effectiveness of dust removal by dust removal vehicles by the measuring dust load and PM10 concentrations on the sidewalks of block pavements. METHODS : Field experiments were conducted to determine a dust removal method suitable for the sidewalk conditions, as identified through a literature review. Data collection was followed by the evaluation of the sidewalk dust load with removal vehicles and analysis of the PM10 content within a service road. Moreover, an economic analysis was conducted based on the social costs of dust reduction. RESULTS : When cleaning a sidewalk block by spraying water, the contaminants in small gaps in the block pavement could be reduced, providing a potential solution to void clogging. The dust on the surface of the sidewalk was suspended from a paved road with a high level of traffic volume. Using sidewalk dust removal vehicles with sweeping, spraying water, and inhalation reduced the dust load and PM10 contents by more than 2 and 0.07g/m2, respectively. CONCLUSIONS : According to the economic analysis of the development of dust removal vehicles for sidewalks, the cost-benefit analysis method shows an input effect of 0.4, but if the reduction amount of fine particles such as PM2.5, further experiments are necessary to address the atmospheric fine dust concentrations resulting from cleaning sidewalk block pavements.

PURPOSES : Abroad, road pavement materials vary depending on the speed and traffic volume of vehicles, but owing to the negative perception of block pavements, sidewalks, parking lots, and parks are primarily used in Korea. In addition, since speed restriction policies such as safety speed 5030 have been implemented recently, it is necessary to use block pavements for roadways, which are considered to have the effect of reducing speed. Therefore, it is necessary not only to actively discuss the introduction of block pavements for roadways but to continue research on the effectiveness of the performance evaluation and to change the perception of roads in Korea. METHODS : In this study, five indicators (surface damage, surface temperature, driving speed of vehicle, noise, and suspended dust) were selected for a sustainable road environment. The performance evaluation index of block pavement for roadways was decided according to the domestic and international literature, and the data were collected based on the evaluation index in the section with block pavement for roadways in Korea. RESULTS : The damage rate was calculated 0.35% according to the breakage of block and Maintenance Control Index(MCI) was ranked A~B even though the pavement was used for more than 4~5 years. The surface temperature of block pavement has a temperature reduction effect of 7 ℃ compared with ordinary asphalt pavement and a speed reduction of approximately 4 km/h on average; therefore, the traffic calming effect of block pavements can be expected. The noise of block pavement and asphalt pavement exhibited a similar level, and the noise level experienced by pedestrians did not change significantly as a result of frequency analysis. The measurement of road suspended dust around the road confirmed the possibility of reducing the concentration of road dust in the air owing to the smooth surface drainage and the results indicated the possibility. CONCLUSIONS : The results of this study are expected to contribute to the recognition and functional improvement of domestic block pavements by continuous monitoring to ensure the reliability of blocks. In addition, it is necessary to ensure the reliability of the quality and functional evaluation of paving materials through continuous on-site monitoring.