Fluid motion within the internal combustion engine cylinder plays a major role in controlling the fuel/air mixing and combustion processes in spark-ignition engines, and the combustion processes in compressionignition engines. In-cylinder flow is quite unstable and varies from one cycle to another. Various methods of in-cylinder flow measurement and fuel/air mixing characterization have been developed during the past few decades. In particular, laser based flow diagnostic techniques have been utilized for this purpose. This study will focus on the quantification of spark-ignition engine in-cylinder flow using the laser based flow diagnostic techniques. The measurement methods, including high speed flow visualization and laser Doppler velocimetry (LDV), will be discussed.
Hydrogen has the very high heating value by comparing with other fuels and its combustion exhausts no carbon. But hydrogen causes the very high adiabatic flame temperature which generates thermal NOx. In this study, two cases of experiments were performed to compare engine characteristics. First and second cases are for only diesel combustion engine and mixed hydrogen diesel engine respectively. To verify the effect of mixed hydrogen-diesel combustion engine, the exhausted gas from modified dual fuel diesel engine was analyzed. In addition, diesel consumption per kWh for each case was estimated to validate its economic feasibility. By mixing hydrogen with 5kW brown(hydrogen-oxygen mixture) gas generator, the amount of CO(carbon mono-oxide) decreased from 330ppm to 210ppm by improving combustion and the amount of NOx increased from 390ppm to 520ppm by higher temperature of combustion chamber. Diesel consumption per kWh decreased from 450cc to 410cc but actually increased until 480cc because of the power of brown gas generator
This paper gives a controller design method by Linear Matrix Inequality(LMI) for internal combustion engine with Continuously Variable Transmission(CVT) which satisfies the given H∞ control performance and robust stability in the presence of physical parameter perturbations. To the end, the validity and applicability of this approach are illustrated by simulation in the all engine operating regions.
In this paper, the behaviour of cavitation erosion, influence of corrosion and corrosion control on slide bearing metals for internal combustion engine were investigated, and this experiment was done by the vibratory cavitation erosion tester. The main results obtained are as follows: 1. With decreasing the space between horn and specimen, the weight loss and its rate increased step by step. But the weight loss and its rate of 0.2mm space decreased conversely more than that of 0.4mm space at early stage. 2. The weight loss and its rate with change of pH were appeared to the order of pH2>pH12>pH7>pH4. And the weight loss and its rate at pH 4 decreased at best. 3. The weight loss and its rate by cavitation erosion for bearing metals were shown to the order of W.M7>W.M1>K.M4. 4. There appeared mainly small pit hole at pH2, and appeared the pit of netting thread type at pH12 by the results of the damaged surfaces at pH2 and pH12 environments that were sensitive to cavitation erosion. 5. With increasing the viscosity of lubricating oil, the weight loss rate by cavitation erosion became dull at the space below 0.5mm. 6. The protective efficiency of cavitation erosion-corrosion is superior inhibitor of chormate(25 ppm) to cathodic protection.