This study investigates the safety and life during the fatigue load by the configuration of seat frame. On back frame at seat frame, the life and damage are analyzed. The deformation and equivalent stress are compared with each other through the vibration analysis, The result of this study through the analysis can be applied to develop the automotive seat frame with durabilty and safety.
An aluminum with the light weight has been used at the automotive car body. As the aluminum is applied to the automotive seat, the optimum design becomes important by investigating the mechanical properties. This study aims at suggesting the basic data for the optimum design of automotive seat frame. In this study, the mechanical properties are investigated through the simulation analysis on the entire structure of seat frame. Two study models using the real commercial vehicles are designed with CATIA program and analyzed with ANSYS program. The harsh condition during the driving state is supposed by using the analyses of natural frequencies and harmonic responses. As the real frequency ranges in this study are set by selecting the natural frequencies through modal analysis. The critical frequencies are analyzed by harmonic response on which the driver is seated. The values of maximum equivalent stresses at models 1 and 2 are shown to be 18.073MPa and 2259.2MPa respectively. The critical frequency at models 1 and 2 are also shown to be 77 Hz and 206 Hz. The maximum stress at model 1 becomes far bigger than model 2. By comparing two models, model 1 has more critical condition than model 2. At the design of automotive seat frame at the dynamic vibration condition, the material of design with the durability and safety can be secured through this study result.
In this study, the analyses of structure, fatigue and vibration with two models of 1 and 2. As the result of structural analysis, the equivalent stress and the total deforamtion of model 1 become higher than those of model 2.Model 1 shows fatigue life more than model 2. As the vibration analysis, model 1 has the safety better than model 2. As shown by these results, the main parts ofdamage and the weak areas can be investigated to differ from each other according to the configuration of model though these models have the same material property. The result of this study through the analysis can be applied to develop the optimal design of automotive seat frame with durabilty and safety.
In this study, analysis on the stiffness of the headrest, the stiffness of front-rear load and the torsion of cushion frame was performed using finite element method in order to investigate the properties of the stress-deformation by material characteristics according to the test requirements of FMVSS (Federal Motor Vehicle Safety Standard). The results are shown that AZ31 (Mg alloy) and A365 (Al alloy) with low modulus of elasticity and density have higher strain rate than steel in terms of stress-deformation and meet the standards for safety within 108 mm of the maximum amount of deformation. Considering it’s safety and durability, however, the selection of AZ31 for light weight seems difficult to gain the reliability because it causes an excessive deformation, and therefore it is not expected to be used for recliner where stress is concentrated and also the bracket linking rail and cushion frame.