본 연구는 가스추진 174K급 LNG 운반선의 가스 압축기실에서 발생하는 가스누출 모사를 통해 가스탐지기의 최적 위치를 분석 하였으며, 새로 개정된 IGC 코드에 명시된 안전규정을 만족하는 합리적인 방법도 함께 제안하였다. 가스압축기실에서의 LNG 가스누출 수치해석을 위해, 실제 ME-GI 엔진이 장착된 174K급 LNG 운반선의 압축기실 형상과 장비, 배관의 배치와 같은 치수로 3D 설계되었다. 가 스누설에 대한 시나리오는 305 bar의 높은 압력과 1 bar의 낮은 압력을 적용하여 진행하였다. 고압용 핀홀의 크기는 4.5, 5.0, 5.6 mm이고 저압용은 100, 140 mm이다. 해석 결과, 5.6 mm 핀홀(고압)과 100, 140 mm 핀홀(저압) 상태의 누출에 대한 환기평가에서 가연성 가스농도는 심 각한 위험이 없음을 확인하였다. 그러나 개정된 IGC 코드에 따라 설치된 압축기실의 가스 감지 센서의 실제 위치는 다른 지점으로 이동 해야 하고, 측정 지점이 현 규정에서 요구하는 것보다 더 추가되어야 함을 확인하였다.
We report on the efficient detection of NO gas by an all-oxide semiconductor p-n heterojunction diode structure comprised of n-type zinc oxide (ZnO) nanorods embedded in p-type copper oxide (CuO) thin film. The CuO thin film/ZnO nanorod heterostructure was fabricated by directly sputtering CuO thin film onto a vertically aligned ZnO nanorod array synthesized via a hydrothemal method. The transport behavior and NO gas sensing properties of the fabricated CuO thin film/ ZnO nanorod heterostructure were charcterized and revealed that the oxide semiconductor heterojunction exhibited a definite rectifying diode-like behavior at various temperatures ranging from room temperature to 250 oC. The NO gas sensing experiment indicated that the CuO thin film/ZnO nanorod heterostructure had a good sensing performance for the efficient detection of NO gas in the range of 2-14 ppm under the conditions of an applied bias of 2 V and a comparatively low operating temperature of 150 oC. The NO gas sensing process in the CuO/ZnO p-n heterostructure is discussed in terms of the electronic band structure.
H2S is a flammable toxic gas that can be produced in plants, mines, and industries and is especially fatal to humanbody. In this study, CuO nanowire structure with high porosity was fabricated by deposition of copper on highly porous single-wall carbon nanotube (SWCNT) template followed by oxidation. The SWCNT template was formed on alumina substrates bythe arc-discharge method. The oxidation temperatures for Cu nanowires were varied from 400 to 800oC. The morphology andsensing properties of the CuO nanowire sensor were characterized by FESEM, Raman spectroscopy, XPS, XRD, and current-voltage examination. The H2S gas sensing properties were carried out at different operating temperatures using dry air as thecarrier gas. The CuO nanowire structure oxidized at 800oC showed the highest response at the lowest operating temperatureof150oC. The optimum operating temperature was shifted to higher temperature to 300oC as the oxidation temperature waslowered. The results were discussed based on the mechanisms of the reaction with ionosorbed oxygen and the CuS formationreaction on the surface.
In this study, highly sensitive hydrogen micro gas sensors of the multi-layer and micro-heater type were designed and fabricated using the micro electro mechanical system (MEMS) process and palladium catalytic metal. The dimensions of the fabricated hydrogen gas sensor were about 5mm×4mm and the sensing layer of palladium metal was deposited in the middle of the device. The sensing palladium films were modified to be nano-honeycomb and nano-hemisphere structures using an anodic aluminum oxide (AAO) template and nano-sized polystyrene beads, respectively. The sensitivities (Rs), which are the ratio of the relative resistance were significantly improved and reached levels of 0.783% and 1.045 % with 2,000 ppm H2 at 70˚C for nano-honeycomb and nano-hemisphere structured Pd films, respectively, on the other hand, the sensitivity was 0.638% for the plain Pd thin film. The improvement of sensitivities for the nano-honeycomb and nano-hemisphere structured Pd films with respect to the plain Pd-thin film was thought to be due to the nanoporous surface topographies of AAO and nano-sized polystyrene beads.
Recently, claims have been made of the detection of 'warm-hot' gas in the intergalactic medium. Kaastra et al. (2003) claimed detection of ~ 106K material in the Coma Cluster but studies by Arnaud et al. (2001), and our analysis of the Chandra observations of Coma (Vikhlinin et al. 2001), find no evidence for a 106 K gas in the cluster. Finoguenov et al. (2003) claimed the detection of 3 X 106 gas slightly off-center from the Coma Cluster. However, our analysis of ROSAT data from this region shows no excess in this region. We propose an alternative explanation which resolves all these conflicting reports. A number of studies (e.g. Robertson et al., 2001) have shown that the local interstellar medium undergoes charge exchange with the solar wind. The resulting recombination spectrum shows lines of O VII and O VIII (Wargelin et al. 2004). Robertson & Cravens (2003) have .shown that as much as 25% of the Galactic polar flux is heliospheric recombination radiation and that this component is highly variable. Sporadic heliospheric emission could account for all the claims of detections of 'warm-hot' gas and explain the conflicts cited above.
It is well known that the metallo- phthalocyanine (MPcs) are sensitive to toxic gaseous molecules such as NO2 and also chemically and thermally stable, Therefore, lots of MPcs have been studied for the potential chemical sensor for NO2 gas using quartz crystal microbalance(QCM) or electrical conductivity. In this study, ultra-thin films of octa(2-ethylhexyloxy)copper-phthalocyanine were prepared by Langmuir-Blodgett method and characterized by using UV-VIS absortion spectroscopy and ellipsometry. Transfer condition, and characterization of LB films were investigated and preliminary results of current-voltage(I-V) characteristics of these films exposed to NO2 gas as a function of film thickness and temperature were discussed.
네일락카와 헤어스프레이 같은 화장품에 존재하는 미량의 프탈레이트를 정량분석하기 위하여, 가스크로마토그래피와 질량분석기를 사용한 효과적이면서 환경친화적인 분석방법을 개발하였다. 이들 화장품들은 다량의 유기용매를 함유되어 프탈레이트를 분석하기 위하여 널리 사용되는 시료의 클린업 방법이 적합하지 않았다. 더군다나 미량의 프탈 레이트 분석시에는 실험과정 중에서의 오염으로 인해 실제보다 높은 분석값을 산출하게 되는 경우가 매우 많다. 이에 정확한 함량분석 및 이차오염을 방지하기 위해 유기용매를 사용하여 시료를 직접 희석하는 시료 전처리를 적용하였다.이 분석방법은 높은 정확성, 분석감도, 그리고 시료전처리를 간략히 할 수 있는 이점을 가진다. 화장품에서의 검출되는 빈도가 높고, 사람과 동물에 영향을 미치는 환경호르몬으로 보고되는 dibutyl phthalate (DBP)와 di (2-ethylhexyl) phthalate (DEHP) 두 종의 프탈레이트를 분석대상으로 선정하였다. 정량시 그 정확도 향상을 위해서 내부표준물질로두 물질의 중수소치환체인 DBP-d4,와 DEHP-d4를 사용하였다. 시험법의 유효화를 시행한 결과 본 시험법이 ppm 농도의 프탈레이트 정량분석에 적합함을 확인하였으며, 네일락카와 헤어스프레이 제품에 약 25 μg/g의 농도로 표준물질을 첨가하여 분석한 회수율은 95 ∼ 106.1 % 범위였고, % 상대표준편차 값은 3.9 % 이하였다.