Using a high pressure homonizer, we report on the electrochemical performance of Li4Ti5O12(LTO) particles manufactured as anode active material for lithium ion battery. High-pressure synthesis processing is performed under conditions in which the mole fraction of Li/Ti is 0.9, the synthesis pressure is 2,000 bar and the numbers of passings-through are 5, 7 and 10. The observed X-ray diffraction patterns show that pure LTO is manufactured when the number of passings-through is 10. It is found from scanning electron microscopy analysis that the average size of synthesized particles decreases as the number of passings-through increases. LiCoO2-based active cathode materials are used to fabricate several coin half/full cells and their battery characteristics such as lifetime, rate capability and charge transfer resistance are then estimated, revealing quite good electrochemical performance of the LTO particles as an effective anode active material for lithium secondary batteries.

The present work reports a systematic study of using carboxymethylated cellulose (CMC) as water-bornebinder to produce Li4Ti5O12-based anodes for manufacture of high rate performance lithium ion batteries. When theLTO-to-CB-to-CMC mass ratio is carefully optimized to be 8:1:0.57, the special capacity of the resulting electrodes is144 mAh·g−1 at 10 C and their capacity retention was 97.7% after 1000 cycles at 1C and 98.5% after 500 cycles at5C, respectively. This rate performance is comparable or even better than that of the electrolytes produced using con-ventional, organic, polyvinylidene fluoride binder.

One of the greatest challenges for our society is providing powerful electrochemical energy conversion and storage devices. Rechargeable lithium-ion batteries and fuel cells are among the most promising candidates in terms of energy and power density. As the starting material, TiCl4·YCl3 solution and dispersing agent (HCP) were mixed and synthesized using ammonia as the precipitation agent, in order to prepare the nano size Y doped spherical TiO2 precursor. Then, the Li4Ti5O12 was synthesized using solid state reaction method through the stoichiometric mixture of Y doped spherical TiO2 precursor and LiOH. The Ti mole increased the concentration of the spherical particle size due to the addition of HPC with a similar particle size distribution in a well in which Li4Ti5O12 spherical particles could be obtained. The optimal synthesis conditions and the molar ratio of the Ti 0.05 mol reaction at 50˚C for 30 minutes and at 850˚C for 6 hours heat treatment time were optimized. Li4Ti5O12 was prepared by the above conditions as a working electrode after generating the Coin cell; then, electrochemical properties were evaluated when the voltage range of 1.5V was flat, the initial capacity was 141 mAh/g, and cycle retention rate was 86%; also, redox reactions between 1.5 and 1.7V, which arose from the insertion and deintercalation of 0.005 mole of Y doping is not a case of doping because the C-rate characteristics were significantly better.

This study aims to reveal how EA affects BAX and NF-kB involved in cell deaths from global ischemia, and to do this, observes the changes of BAX and NF-kB caused by EA application after transient global ischemia. The experimental method is to give rise to global ischemia and apply EA to 27 SD rats with the particulars of being six-week-old, male, around-300 gram-weighing, and adapted to laboratory environment for more than a week, and divide them into three groups, that is, GV20 EA group(n=9), L14 EA group(n=9), no-treatment GI group(n=9), and then observe their changes of BAX and NF-kB at the time lapse of 6 hours, 9 hours and 12 hours after ischemia, using western blotting. The numerical decrease of BAX expression at the time lapse of 9 hours after EA application, though not statistically significant, was observed in GV20 EA group and L14 EA group, and the NF-kB expression appeared statistically significant decrease in GV20 EA group and L14 EA group, but the expression was higher in the group with EA application. Therefore, EA application at the early phase of global ischemia is considered to affect BAX and NF-kB and play a positive role in decreasing apoptosis and cell deaths by inflammation.

We investigated skin thermal changes after acupuncture stimulation for Meridian mechanism. So non-acupuncture group, acupuncture at left LI4 and acupuncture at left, right acupuncture group were observated in 0 min, 5 min and 10 min. And results was acupuncture group of left LI4 was increased in 0 min, 5 min and 10 min significantly. We proposed that increasing thermal changes was caused by Meridan and Gi reaction.