In this study, the loading rates (or emission rate) and concentrations of air pollutants (ammonia, hydrogen sulfide, carbon dioxide, methane, nitrous oxide, and particulate matter (PM2.5, PM10 and TSP)) emitted from a naturally ventilated dairy facility were analyzed and compared to enable a better understanding that are in close proximity to each other, air pollution status. In general, the pollution patterns should be similar in measurement sites that are in close proximity to each other, and this hypothesis was fundamental to our approach in this study. For the comparison in nearby different sites, monitoring points were located at inside (source site) and outside the dairy building (ambient site), and concentrations and wind velocity were simultaneously monitored in real time. The patterns of PM2.5 emission rate and loading rate were similar in the source site and the ambient site which was consist with the hypothesis, while the PM2.5 mass concentration were not similar in both sites. As well as PM2.5, the emission rates (source site) of gaseous carbon dioxide (CO2) and nitrous oxide (N2O) were highly correlated to their loading rates (ambient site), while the concentrations of CO2 and N2O were not similar. Therefore, wind velocity, which is included in the emission or loading rate, should be simultaneously monitored with the concentration at the same measurement points for better understanding of the air pollution status.

Urban areas (residential, commercial, transportation), each of the points during the same rainfall in the same area, this study was evaluated by a survey to find out the basic data and the characteristics of non-point pollution on local characteristics was performed. To evaluate and compare a non-point source pollution concentrations. The conclusion of this study was to know the influence of non-point pollutants in initial rainfall. There was a difference during the same point was compared. The pollution levels were differences in the point-specific characteristics, the same point compared by rainfall when rainfall is low, the contaminant concentrations were high. Finally, when compared to the number of rainy days. The shorter the number of rainy days, the non-point pollutants were high.

비점오염원은 점오염원과 다르게 불특정하게 배출되며 유출특성에 대하여 명확한 제시를 하기에 어려움이 있다. 이에 정부는 최근 비점오염원에 대한 문제의 심각성을 인식하고, 비점오염원 관리제도와 관리대책을 마련하는 노력을 기울이고 있다. 본 연구에서는 자연형 비점오염 저감시설인 식생수로의 저감효율을 제거 효율법(Efficiency Ratio, ER)과 부하량 합산법(Summantion of Loads, SOL)으로 산정하였다. ER 방법에 의한 T-N, T-P의 저감효율값은 2012년도에 T-N 80 %, T-P 83 %가 2013년도에 T-N 75 %, T-P 85 %, SOL 방법은 2012년도에 T-N 79 %, T-P 87 %, 2013년도에 T-N 71 %, T-P 73 %로 나타났다. 본 연구에서는 하계와 추계에 대한 저감효율 비교분석을 통해 식생수로의 효율평가를 하였으며, 시설의 계절별 관리방안과 설계에 도움이 될 것이라 판단된다.

This study was to investigate the runoff characteristics of non-point pollutants source at the urban area in Suwon city. The highest T-N and T-P concentration of rainfall runoff observed in agricultural area. In residential area, the highest BOD5 and SS concentration of rainfall runoff was investigated. During rainfall events, the peak concentrations of SS and BOD5 were observed after 1~2 hours of rainfall in urban area. Whereas, the peak concentrations occurred within 1~2 hours after rainfall and then the highest concentrations of SS and BOD5 sharply decreased, showing strong first flush effect in urban area. The EMC results indicated that the highest value of T-N and T-P in agricultural area was observed. While residential area was shown the lowest EMC value as T-N and T-P. Non-point pollutant loads on the land use types in urban area were investigated in the order of residential>industrial>agricultural>highway. BOD5 and SS loads on urban watershed were investigated in the order of Suwon>Hwangguji>Seoho>Wonchunri. Whereas, T-N and T-P loads on urban watershed were investigated in the order of Hwangguji>Suwon>Wonchunri>Seho.

Road runoff, one of non-point source pollutants, contains various heavy metals, most of which flow into discharge waters without being treated. The mechanism of removing the heavy metals in water is similar to that of removing micro-particles. Therefore, it is considered that it is possible to remove a lot of the heavy metals contained in the road runoff by filtering or absorbing them. In this paper, performed has been a basic study on the characteristics of UNFS (Up Flow Non-Point Source Filtering System) using carbide pellet and zeolite pellet as double-layer filtering mediums to treat the road runoff. The removal rate with filtering and absorption time has been shown as follows: 29.0% for Cr; 27.8% for Cd; 25.7% for Fe; 25.4% for Co; 21.2% for Pb; 19.6% for Zn; 18.2% for Al; 17.0% for Mn; 11.3% for Ni; 7.5% for Cu. The overall removal rate according to influx change has been shown to be approximately 30%, and the load of heavy metals flowing out in initial precipitation could be reduced by using carbide as a recycling filtering medium. When the removal as coarse particles settle is added up, it is expected that UNFS will result in a higher removal rate.