A demand for bio-diesel oil increases as one of solution for exhaustion of fossil fuel and reduction of CO2 emission, and research on bio-diesel is being carried out. Bio-diesel oil is mainly esterified from vegetable oil with methanol in order to use for fuel on diesel engine and has demerit that costs are increased as compared with directly using like non-esterified one. Bio-diesel oil within 3% mixed with gas oil is used at present, proportion of bio-diesel oil will be increase by 5% in future. We judged that wasted soybean oil non-esterified could be used on diesel engine with an electronic fuel injection according to previous researches with a mechanical fuel injection. A performance test using only gas oil, gas oil with esterified bio-diesel oil 5% and wasted soybean oil non-esterified 5% on diesel engine with the electronic fuel injection were carried out. It is noticed that gas oil with wasted soybean oil non-esterified 5% has more similar characteristics to gas oil than gas oil with esterified bio-diesel oil 5%.

This paper presents a description and evaluation of a detailed mathematical simulation for the steady and unsteady flow in a radial inflow-turbine which is most frequently used, at present, for exhaust gas turbochargers of internal combustion engines. As a method of computation, the two-step differential Lax-Wendroff method and the characteristic method were used. The turbine characteristics, the mass flow rate, the power output and fluid movements at the turbine scroll inlet were compared with the experiment data. The results of the simulation were in good agreement with experimental values under both steady and unsteady flow conditions.

In this paper, the relationship between static pressure recovery and turbulent energy was presented in case of swirling flows into a conical diffuser. The distributions of turbulent energy in a diffuser sectional area were measured by a hot wire anemometer. The following conclusion can be drawn from the experiment. Diffuser loss is constituted by a dynamic pressure loss and total pressure loss. The static pressure recovery depends strongly on the total pressure loss. The static pressure recovery depends strongly on the total pressure loss, and the turbulent energy varies inversely as the static pressure recovery coefficient.

The purpose of this paper is to investigate the relationship between static pressure recovery and velocity distributions in case of swirling flow into a conical diffuser. In this research, velocity distribution is measured by a multi-hole yaw-meter. The following conclusions can be drawn from the experiments. (1) The static pressure recovery depends strongly on the strength of a swirl. (2) A high pressure recovery coefficient is achieved by inserting a solid core into the diffuser center.

1986년부터 1988년까지 3년 동안 우리나라 주변 해역에서 발생한 1680건의 해난사고를 주성분분석법에 의한 전산프로그램을 작성하여 분석한 결과를 요약하면 다음과 같다. 1. 해난사고의 주된 원인은 운항부주의, 기관 정비불량 등 인적요인에 있으며, 사고유형으로서는 기관고장이, 선종으로서는 어선이 특히 해난사고의 큰 비중을 차지한다. 2. 어선, 관공선의 경우에는 기관고장이나 추진기장애 등이 경미한 해난사고가 많은 경향인데 비해 화물선, 여객선, 유조선의 경우에는 좌초, 충돌, 전복, 침수 등 재산과 인명의 피해가 큰 대형해난사고가 많은 경향이다. 3. 대형해난사고 중 좌초, 충돌, 전복 등은 그 주된 원인이 운항부주의에 있고, 침수의 경우는 재질구조결함에 기인하는 바가 크다.

국산 소형어선용 예연소실식 디젤기관의 연료유를 가열할 경우, 연소특성 및 기관성능에 미치는 영향에 관하여 실험한 결과를 요약하면 다음과 같다. 1) 연료유 분사시작점은 연료유 가열온도의 증가에 따라 늦어지는 경향을 나타냈으며, 특히 저부하 운전시 늦어지는 경향이 현저했다. 2) 연소최고압력점은 연료유 가열온도의 증가에 따라 늦어졌으며, 연소최고압력은 연료유 가열온도 증가에 따라 감소하였으나 부하의 증가에 따라 증가하는 경향을 나타내었다. 3) 연료소비율은 부하의 증가에 따라 감소하였으며, 연료소비율이 가장 작은 연료유의 최적가열온도는 150℃부근임을 나타내고 있다. 4) 그을음농도는 부하와 연료유 가열온도의 증가에 따라 증가하는 경향을 나타냈다.

Boilers and diesel engines have many problems because their exhaust particles, i.e., soot have lots of bad influence on environment. And it's spray and flame have fundamentally axial symmetric shape. To investigate the relationship between fuel concentration distribution of spray and soot concentration distribution as well as temperature distribution of flame, we made a axial symmetric two phase spray-flame and analyzed the structure of is. The measuring method is the principle of the light extinction method for the spray-flame and onion peeling model is applied to analyze the radial distribution of fuel and soot concentration. The temperature of flame is measured by ø 0.4mm Pt-Pt.RH 3% thermocouple. The oils for the experiments are diesel oil and 10% water emulsified diesel oil. It was found that the soot concentration becomes higher as it comes near to the center of flame, and the fuel concentration does, too. And the soot concentration level of diesel oil is generally higher than that of the 10% water emulsified fuel. The maximum flame temperature of diesel oil is 1,170℃, however, 10% water emulsified diesel oil is 1,270℃.

열선유속계를 이용하여 디이젤 기관 연소실내의 한점에서 유속을 측정한 결과는 다음과 같은 결론을 얻었다. 1. 연소실내의 유동은 cylinder의 원주방향의 속도 성분이 크며, 유속변화는 밸브 timing과 피스톤 속도등에 밀접한 관계가 있다. 2. 유속은 흡입시부터 증가하여 압축행정중 흡입밸브가 닫히는 60˚ABDC에서 최대치를 갖고 이후 피스톤의 속도가 감소함에 따라 유속도 감소하여 팽창행정중 배기 밸브가 열리는 120˚ATDC에서 다시 증가하였다. 3. 평균유속은 shroud 밸브 사용시가 no shroud 밸브 사용시보다 낮지만 shroud 밸브 사용시 흡입행정에서 난류강도가 가장 크게 나타났다. 4. 90˚shroud 밸브 사용시가 120˚shroud 밸브 사용시보다 난류강도는 더 크고, 90˚shroud의 180˚위치에서 난류강도가 제일 크게 나타났다.(이 논문의 결론부분임)

국산 소형어선용 예연소실식 디이젤기관에 혼합연료유(정유+중유)를 사용할 경우 혼합연료유의 성질, 연소특성 및 기관성능에 관하여 실험한 결과를 요약하면 다음과 같다. 1) 혼합연료유의 혼합비율(중량비율)이 증가함에 따라 비중은 선형적으로 증가하였고, 점도-온도 곡선은 Walther-ASTM 식과 일치하였으며, 착화성지수인 CCAI의 값은 기울기 1.0에 가까운 직선으로 증가하였다. 2) 동일운전조건에서 착화지연은 CCAI의 값이 810(혼합비율 60%)까지는 미소하게 증가하였으나, 그 이상의 값에서는 현저하게 증가하였다. 따라서, 혼합연료유의 착화성을 나타내는 CCAI의 값은 810 이상에서 적용하는 것이 타당하다. 3) 연소최고압력은 혼합비율 40%까지 증가하다가 감소하였으며, 그을음농도는 60%부터 현저하게 증가하였으므로, 본 실험에서 무그을음 연료비절감의 안전운전 혼합비율은 50%가 적당하다

The typical characteristics of seasonal winds were studied around the Pohang using two-stage (average linkage then k-means) clustering technique based on u- and v-component wind at 850 hpa from 2004 to 2006 (obtained the Pohang station) and a high-resolution (0.5 km grid for the finest domain) WRF-UCM model along with an up-to-date detailed land use data during the most predominant pattern in each season. The clustering analysis identified statistically distinct wind patterns (7, 4, 5, and 3 clusters) representing each spring, summer, fall, and winter. During the spring, the prevailed pattern (80 days) showed weak upper northwesterly flow and late sea-breeze. Especially at night, land-breeze developed along the shoreline was converged around Yeongil Bay. The representative pattern (92 days) in summer was weak upper southerly flow and intensified sea-breeze combined with sea surface wind. In addition, convergence zone between the large scale background flow and well-developed land-breeze was transported around inland (industrial and residential areas). The predominant wind distribution (94 days) in fall was similar to that of spring showing weak upper-level flow and distinct sea-land breeze circulation. On the other hand, the wind pattern (117 days) of high frequency in winter showed upper northwesterly and surface westerly flows, which was no change in daily wind direction.