In this study, using coke dust from ironwork, the pulse pressure on a pulse air jet bag filter was investigated considering the influence of the pressure loss due to filtration velocity and pressure intervals. The research on the optimal pulse pressure prediction of a pulse air jet type bag filter using coke dust showed the following results. Pressure loss volatility produced by the pulse pressure under low dust concentration(0.5, 1 g/m3) and low face velocity(1.25 m/min) was less than 10 mmH2O. This suggests that the pulse pressure has a low impact on the pressure loss. In contrast, pressure loss volatility under high dust concentration(3 g/m3) and high face velocity(1.75 m/min) was 25 mmH2O. Therefore, pulse pressure with high dust concentration and high face velocity has a strong influence on the pressure loss volatility, compared to the condition of low dust concentration and low face velocity. The optimal pulse pressure of inlet dust concentration(0.5 g/m3) was 6 kg/cm2 under the same face velocity(1.75 m/min). As concentration increased from 1 to 2 g/m3, the pulse pressure gradually reached 5 kg/cm2 thus indicating that the pulse pressure(5 kg/cm2) is pertinent at a high concentration(3 g/m3). The pulse intervals: 20, 25 and 30 sec, which are relatively longer than 10 and 15 sec, corresponded to high pressure loss volatility produced by the pulse pressure. Furthermore, low pressure loss volatility was noted at 5 kg/cm2 of the overall pulse pressure.

Generally, metal working fluids (MWFs) are used to reduce friction in metalworking processes. In addition to mineral oils, MWFs contain many chemical substances, such as anticorrosive agents, extreme-pressure additives, and stabilizers, as well as high concentrations of organics and ammonia nitrogen. Accordingly, MWFs must be managed to advanced treatment for hydro-ecological conservation. This study investigated the removal efficiency of ammonia nitrogen from MWFs according to operating time, applied voltage, distance between electrodes, and NaCl concentration using aluminum in a batch-type reactor. The experimental results were as follows: First, without NaCl, removal efficiencies of ammonia nitrogen were 69.6%, 37.9%, and 22.7%, when the distance between electrodes was adjusted to 1, 4, and 7 cm, respectively, at 15 V for 60 min. Secondly, without NaCl, removal efficiencies of ammonia nitrogen were 49.5 and 90.9% when the voltage was adjusted to 5 V and 10 V, respectively, for 60 min and 94.6% at 15 V for 40 min. Lastly, with the addition of NaCl 10 mM, the removal efficiency of ammonia nitrogen was 40.3% and 11.5% greater than that of no addition of NaCl at 5 V for 60 min and at 10 V for 30 min.

The purpose of this article is analyzing the economic impacts of abnormal climate on total revenue of red pepper in Korea, with employing the equilibrium displacement model. Our simulation results show the rate of yield change, price change, and total revenue change according to the climate change scenarios. In th case of by RCP 8.5 Scenario, red pepper production volume would be expected to decrease by 77.2% compared to 2012 while price increasing by 29.6%. As a result, total revenue to be returned to farmers would be reduced by 47.6% than it was in 2012. In contrast, total revenue would be expected to decline by 29.6% according to RCP 4.5 scenario.

The purpose of this article is analyzing the economic impacts of abnormal climate on fall chinese cabbage farmers and consumers in Korea, with employing the equilibrium displacement model. Our results show that there were little difference in gross farm income, even though there were significant yield reductions due to abnormal climate changes. However periodic occurrences of abnormal climates caused serious damage to consumption levels which had declined by 10.6~17.1 percent with higher prices by 15.3~24.6 percent than normal climate years since 1990.

So far, most studies associated with soil carbon sequestration have been focused on long term aspect. However, information regarding soil carbon sequestration in short term aspect is limited. This study was conducted to determine changes of soil organic carbon content and stability of carbon in response to compost application rate and tillage management during rice growing season(150 days) in short term aspect. Under pot experiment condition, compost was mixed with an arable soil at rates corresponding to 0, 6, 12, and 24 Mg/ha. To determine effect of tillage on soil carbon sequestration, till and no-till treatments were set up in soils amended with application rate of 12 Mg/ha. Compost application and tillage management did not significantly affect soil organic carbon(SOC) content in soil at harvest time. Bulk density of soil was not changed significantly with compost application and tillage management. These might result from short duration of experiment. While hot water extractable organic carbon(HWEOC) content decreased with compost application, humic substances(HS) increased. Below ground biomass of rice increased with application of compost and till operation. From the above results, continuos application of compost and reduce tillage might improve increase in soil organic carbon content and stability of carbon in long term aspect.

This study has been carried out to examine the feasibility of soil washing process for reducing arsenic contamination level of soil around Dalchên Mine. The results of physicochemical tests of the target soil showed that pH was weak alkalic (pH ~- 7.8), soil texture was coarse sand, and organic contents (5.7%) and CEC (Cation exchange capacity; 21.5 meq/100 g) were similar with those of soils generally found in Korea. Contamination levels of arsenic were found to over 201 mg/kg which exceed the Korea standard levels of countermeasure and concern. To investigate chemical partitioning of heavy metals, sequential extraction procedures were adopted and it was found that arsenic was predominantly associated with the residual fraction among five fractional forms as much as over 85%, which is demonstrating that only less than 15% of all might be vulnerable to a selected washing agents. Among 6 kinds of washing agents applied on the screening for arsenic-contaminated soil, HCl and H3PO4 solution were selected as promising washing agents. In comparison with HCl and H3PO4 solutions for arsenic washing by kinetic experiment in the change of pH, soil-solution ratio, temperature, and washing solution concentration, H3PO4 solution was determined to best one of agents tested, which showed faster washing rate than HCl to accomplish regulatory goal.

In the removal of heavy metals from the mine deposit using electrokinetic processes, the effects of operation under both constant current and constant potential conditions were estimated. The results of soil pH distributions for DDW-20 V and DDW-100 ㎃ cases after the electrokinetic remediation tests were observed. In the former case, soil pH was not much changed and kept to almost constant value just little higher than initial soil pH of 3.52, except near the cathode, which was about pH 5. While in the latter case, soil pHs of anode and the cathode regions were less than pH 3 and about 6, respectively. The electroosmotic flow to the cathode increased rapidly till 10 hrs and decreased steadily and then maintained to constant rate until the end of operation at constant current condition. Electric potential gradient was continuously increased to as much as 34.375 V/cm. At the steady state, values of the apparent electric conductivity for DDW-20 V and DDW-100 ㎃ were around 40 ㎲/㎝ and 30 ㎲/㎝, respectively. In the DDW-100㎃ test, Cu, Cd, and Zn except Pb showed the tendency of moving toward the cathode. While in the DDW-20 V case, it was observed that Cu, Zn, and Pb except Cd were not moved to any directions. The results of the tests demonstrated that the electrokinetic soil remediation process could be operated better under constant current condition than constant electric potential condition.

An author has been known that A-type zeolite supported with silver ions has excellent antibacterial activity. However, it is no research of concern in the antibacterial activity of eluted silver ions. This study tested the elution of silver ions from A-type zeolite silver ions in deionized distilled water and NaNO3 aqueous solution. In NaNO3 aqueous solution of 74mM to 588mM, it was found that the concentration of silver ions and electric conductivity increased with the increasing concentration of sodium ions, and equilibrated at 15 min, and the ion exchange equilibrium coefficient, k, is 1.3×10-3. However, deionized distilled water is not equilibrated to pass 6 months. A-type zeolite sodium ions showed no antibacterial activity. It was found that antibacterial activity was exhibited even at the concentration of 10 nM of eluted silver ions, and E-coli died with the incorporation of 2.43×108 Ag ion/cell. antibacterial activity of A-type zeolite silver ions were mainly attributed to hydroxyl radical.

Three kinds of toxic heavy metals, such as lead, copper, and cadmium, existing abundantly in contaminated soils were selected to investigate pH change, electroosmotic flow, and the removal rate in the application of electrokinetic process. In the change of pHs, they reached to about 12 and 2 at each cathodic and anodic region, respectively, and maintained for reaction being proceeded. Electroosmotic flow rates were not influenced by the kind of metal species but by electropotential gradient. On the soils contaminated by each metal, the removal rate of Cd was the fastest among three as in the order of Cd>Pb>Cu. While on the soils contaminated by mixed metal species, Cu was the fastest. Metal species transported by electrokinetic processes were distributed in between 0.9 and 1.0 of normalized region. In the case of soils contaminated by one kind of metal. the relative concentrations of Pb and Cd estimated in between normalized region 0.9 and 1.0 were 5.2 and 5.7, respectively.

Two different kinds of cases, with and without addition of noncrystalline silica to the Hadong kaolin were studied to obtain useful information on the synthesis of zeolite. The research was carried out to investigate the formation area and the crystalized degree of zeolite according to a synthetic time, the water content of raw material mixture, KOH concentration, and stirring intensity. In the case of without addition of noncrystalline silica to the Hadong kaolin and the low concentration range of KOH, the structure of the kaolin was not changed. However, when the mole ratio of K2O/SiO2 in natural kaolin was increased, Linde-L zeolite and unknown structure of kaolins, U-1 and U-2 were produced. While in the high concentration range of KOH, the unknown structure of kaolins, U-6 and U-2, were produced and the production rate of U-6 was increased with the increased of K2O/SiO2 mole ratio. In the case of with addition of noncrystalline silica to the Hadong kaolin and treatment with KOH hydrothermal processing, ZSM-5, ZSM-35, and Linde-L zeolites and the mixture of unknown structure of zeolites, U-1, U-2, U-3, and U-4, were obtained. Both cases demonstrated that the synthesis of zeolite from the Hadong kaolin was highly influenced by KOH concentration of raw material mixture.

Laboratory sorption isotherm batch studies have been attempted to elucidate interaction of synthetic pyrethroids (bifenthrin and permethrin) with sediments and their fractions. As a nonlinear isothermal model, the Freundlich equation was applied to sorption results obtained from sediments to investigate the relationship between synthetic pyrethroids and sediments containing different amounts of organic carbon. Results demonstrated that the sorption capabilities of bifenthrin and cis- and trans-permethrin was in the order of bifenthrin, cis-permethrin and trans-permethrin, respectively, indicating that adsorbed bifenthrin was the most stable followed by cis- and trans-permethrin in all sediments. Their sorption capability was closely related to organic carbon contents in sediments. Higher sorption was observed in sediments containing higher organic carbon contents. Sorption study extended into the fractions, clay and humic acids, extracted from a sediment, indicated that higher sorption capacity in humic acids occurred than in the clay of both examined bifenthrin and permethrin. This study demonstrates the sorption of synthetic pyrethroids with sediments, and will help in the understanding of the transport and fate of synthetic pyrethroids existing in field sediments.

Electrokinetic remediation technique offers the opportunity to extract heavy metals from soils with high plasticity. The experiment demonstrated the applicability of electrokinetic remediation on metal-mining deposit and the decision of the enhancement method for four kinds of bench-scale studies. According to the sequential extraction of heavy metals in the "I" mining deposit, Pb and Cu were mostly associated with residual fraction and Zn and Cd were associated with water soluble and residual fraction. Therefore, removable fractions by electrokinetic technology was determined by the sum of the fraction of water soluble and exchangeable, which is Cu : 19.53 %, Pb : 1.42 %, Cd : 52.82 %, Zn : 57.28 %, respectively. When considering electrical potential, volume of effluent, soil pH, and eliminated rate of contaminant, results determined by sum of each weight were Citric aic+SDS (13) > 0.1N HNO3 (10) > HAc (8) > DDW (4). Therefore, citric acid and SDS mixed solution was determined the best enhancing agent for the remediation of metal mining deposit.