The purpose of this study was to analyze changes to body measurements and silhouettes after wearing an early 19th century women’s corset. Two types of corsets were tested. Changes in body size and silhouette were compared based on the levels of tightening strength of the corset. The tightening strength was adjusted in 4 steps by making the length of back fastening string 10-40 cm shorter than the standard. The silhouette was compared with the front silhouette and the side silhouette. The results were as follows. After wearing the experimental 19th century corsets, the chest circumference and front interscye length increased. However, the chest circumference did not increase proportionally to the tightening strength. The underbust circumference, waist circumference, and back interscye length also decreased. The waist width was decreased to create a slim front silhouette. The change in the body silhouette differed depending on the style of the experimental corset. The experimental corset made with the six-piece torso pattern changed the posture so that the shoulders were pulled back and the chest was pushed forward. The experimental corset with the side bodice pattern resulted in the subject’s shoulders reclining backward and the chest and abdomen extending forward. The results of this study show that women’s body sizes and silhouettes could be changed by wearing the early 19th century corsets, but the changes in body size and silhouette vary depending on the wearer's individual body type or corset style.

A powder mixture of 70 wt% Al2O3 and 30 wt% hydroxyapatite (HA) is sintered at 1300 ℃ or 1350 ℃ for 2 h at normal pressure. An MgF2-added composition to make HA into fluorapatite (FA) is also prepared for comparison. The samples without MgF2 show α & β-tricalcium phosphates (TCPs) and Al2O3 phases with no HA at either of the sintering temperatures. In the case of 1,350 ℃, a CaAl4O7 phase is also found. Densification values are 69 and 78 %, and strengths are 156 and 104MPa for 1,300 and 1,350 ℃, respectively. Because the decomposition of HA produces a H2O vapor, fewer large pores of 5-6 μm form at 1,300 ℃. The MgF2-added samples show FA and Al2O3 phases with no TCP. Densification values are 79 and 87%, and strengths are 104 and 143 MPa for 1,300 and 1,350 ℃, respectively. No large pores are observed, and the grain size of FA (1-2 μm) is bigger than that of TCP (0.7 μm ≥) in the samples without MgF2. The resulting TCP/Al2O3 and FA/Al2O3 composites fabricated in situ exhibit strengths 6-10 times higher than monolithic TCP and HA.

Because of the changing educational environments, Korean universities have to stand up to the challenge of enhancing their performances in educational activities. Therefore, Korean universities should seek ways to improve its competitiveness. The evaluation of Korean universities has been conducted by the Government and other media agencies like JoongAng’s Daily to promote the development of universities. The purpose of this study is to evaluate and compare the relative efficiency of Korean universities using DEA (Data Envelopment Analysis) and AHP (Analytic Hierarchy Process) models. To produce reasonable results, major input and output variables have been determined in a step using a Profiling method, Spearman correlation analysis and AHP model. Also, this study shows that the relative efficiency for Korean universities is obtained not only based on quantity of output, but also on the basis of the quality of the output. Drawing upon the results of the analysis, this study provides a comprehensive and practical method for evaluating the performance of universities in terms of efficiency.