This study was performed to establish the early pregnancy diagnosis with evaluation of size of embryonic vesicles and change of crown-rump length (CRL) by transrectal ultrasonography in the Korean black goats. Early pregnancy diagnosis was performed in the 114 goats from 19 to 35 days after coitus by transrectal 5.0 MHz transducer. Embryonic vesicles and CRL in the 142 goats from 19 to 42 days was measured to establish the correlation between gestational age and these parameters. The early pregnancy diagnosis achieved 80% accuracy after days 25 and 100% accuracy after days 28 after breeding. Diameters of embryonic vesicle and CRL were significantly increased with the gestational age. In these facts, early pregnancy diagnosis is possible on Days 25 after breeding and measurement of embryonic vesicles and CRL were useful to predict the gestational age in Korean black goat.

With the capability of net shaping for complex 3D geometry, powder injection molding (PIM) is widely used for automotive parts, electronics and medical industry. In this study, an ultrasonic dental scaler tip produced by machining process was redesigned for the PIM process. An injection mold was designed and machined to produce the dental scaler tip by the PIM process.

Powder Injection Molding (PIM) has recently been recognized as an advanced manufacturing technology for low-cost mass production of metal or ceramic parts of complicated geometry. With this regards, design technology of dental scaler tip PIM mold, which has complex shape, with the help of computer-aided analysis for powder injection molding process was developed. Compter aided analysis results, such as filling pattern, weldline formation, and air vent position prediction were investigated and eventually showed good agreements with experimental results.

To manufacture a flange for a compressor with a relief groove by using powder metallurgy in order to prevent deformation to the compressor in operation, powder material for the flange is charged into a mold; an ablative member having a melting point lower than that of the powder material is positioned at a place where a relief groove is to be formed; the flange is formed by compressing the powder material and the ablative member; and the formed flange is sintered at a temperature between the melting point of the powder material and the ablative member so as to melt and remove the ablative member. It made according to the new method has more excellent strength and airtight property than the conventional one. It is analyzed that the ablative member is melted and penetrated into the flange structure during the sintering process, which results in improvement of the airtight property and increase of the strength.