Diesel engine has the advantages of strong power, low fuel consumption and good durability, so it has been widely used in transportation, automobile, ship and other fields. However, the nitrogen oxides(NOx) and particulate matter(PM) emitted by diesel engines have become one of the main causes of air pollution. Especially during idling, the engine temperature is low, and there are more residual exhaust gases in the combustion chamber, resulting in the formation of more harmful emissions. In this study, performance of a single cylinder, four-stroke, direct injection (DI) diesel engine fueled with diesel–biodiesel mixtures has been experimentally investigated.

In this study, the combustion characteristics of low calorific gas (LCG) fuels are investigated by numerical simulation. PREMIXED code is used to predict the flame structure and NO emission with two mechanisms, which are GRI 3.0 and USC II chemical reaction mechanisms for CH4 and LCG 8000 and LCG 6000, respectively. Also, elementary reactions related with production and destruction for OH radical are studied because OH radical is dominant for burning velocity and NO emission. As results, the production and the destruction of OH radical for CH4 and LCG 8000 using GRI 3.0 are dominated by reactions of No. 4, No. 2 and No. 3 and by No. 5, No. 3 and No. 7, respectively. For LCG 6000 using USC II, reactions of No. 3, No. 4 and No. 11 and of No. 7, No. 8 and No. 12 dominates to the production and the destruction, respectively. In addition, NO emissions for LCG gas fuel are generated by thermal NO because the flame temperatures are over 1800 K.

In this study, the laminar burning velocity of low calorific gas fuels are verified through the comparison and examination of experimental and predicted results. The bunsen burner which has contraction nozzle is used to measure the laminar burning velocity with the cone angle method. In addition, PREMIXED code combined with two mechanism, i.e., the GRI 3.0, and USC II reaction mechanisms is used to predict the laminar burning velocity. As heating value decrease, the laminar burning velocity correspondingly decreases due to inert gases in the fuels. Through the comparison and analysis of the experimental results and the predicted results, it is confirmed that LCF 9000 and LCF 8000 with the GRI 3.0 reaction mechanism and LCF 7000 and 6000 with the USC II reaction mechanism have a similar distribution of laminar burning velocity between the experimental result and the predicted result. This similarity is due to a large amount of propane, which is not suitable for the GRI 3.0 reaction mechanism in LCF 7000 and 6000.

In this study, we investigated the effects of diesel-palm oil biodiesel-ethanol blends on combustion and emission characteristics in a 4-cylinder common rail direct injection (CRDI) diesel engine at low idling operations. The engine speed and engine load was 750 rpm and 40 Nm, while the main and pilot injection timing was respectively fixed at 2 °CA before top dead center (BTDC) and 20 °CA BTDC. The experimental results showed that the cylinder pressure increased with the increasing of palm oil biodiesel ratio from 20% to 100%. In addition, the peak value of cylinder pressure increased by 4.35% compared with pure diesel fuel when 5 vol.% ethanol oil added to diesel oil. Because the palm oil biodiesel and ethanol are the oxygenated fuel, the oxygen content played an important role in improving combustion. Based on the high oxygen content of biodiesel and ethanol, their mixing with diesel fuel effectively reduced PM emissions but increased NOx slightly, while CO and HC had no significant changes.

In this study, to investigate the effect of physical and chemical properties of butanol on the engine performance and combustion characteristics, the coefficient of variations of IMEP (indicated mean effective pressure) and fuel conversion efficiency were obtained by measuring the combustion pressure and the fuel consumption quantity according to the engine load and the mixing ratio of diesel oil and butanol. In addition, the combustion pressure was analyzed to obtain the pressure increasing rate and heat release rate, and then the combustion temperature was calculated using a single zone combustion model. The experimental and analysis results of butanol blending oil were compared with the those of diesel oil under the similar operation conditions to determine the performance of the engine and combustion characteristics. As a result, the combustion stabilities of D.O. and butanol blending oil were good in this experimental range, and the indicated fuel conversion efficiency of butanol blending oil was slightly higher at low load but that of D.O. was higher above medium load. The premixed combustion period of D.O. was almost constant regardless of the load. As the load was lower and the butanol blending ratio was higher, the premixed combustion period of butanol blending oil was longer and the premixed combustion period was almost constant at high load regardless of butanol blending ratio. The average heat release rate was higher with increasing loads; especially as butanol blending ratio was increased at high load, the average heat release rate of butanol blending oil was higher than that of D.O. In addition, the calculated maximum. combustion temperature of butanol blending oil was higher than that of D.O. at all loads.

본 연구에서는 국내외 저탄소 녹색성장을 위한 대안으로서 수소에너지와 그 이용 기술에 대한 관심이 높아지는 추세에 발맞춰 무탄소 연료인 수소를 LNG 의 주성분인 메탄, 메탄-프로판, 메탄-프로판-에탄 동축류 확산화염 내에 첨가하여 화염형상 및 연소생성물에 미치는 영향을 확인하였다. 상온상압 조건의 확산화염에 수소를 단계적으로 첨가하여 실제 생성되는 연소생성물의 변화 추이를 가스 분석기를 이용하여 실험적으로 관찰하였고 확산화염의 형상은 디지털카메라를 이용하여 단계적으로 관찰 하였다. 실험결과에서 확산화염에 수소를 첨가함에 따라 질소산화물의 생성량이 선형에 가깝게 증가하는 경향을 보였다. 이것은 수소의 상대적으로 높은 단열화염온도와 빠른 연소속도가 Thermal NOx의 생성을 촉진했기 때문이다. 반면 이산화탄소의 생성량은 감소하는 경향이 나타났는데 수소를 첨가함에 따라 메탄, 메탄-프로판, 메탄-에탄-프로판의 혼합 확산화염에 포함되어있는 전체 탄소비율이 줄어들어 이산화탄소의 생성량이 감소한 것이다. 이는 선박에서 LNG-수소의 혼합 연료사용으로 인해 온실가스인 이산화탄소를 저감할 수 있는 하나의 방안으로 고려될 수 있다는 것을 의미한다.

There are increased in using the bio-ethanol, as the carbon neutral attracts many researchers due to a reduction in carbon dioxide spotted as the global warming gas. A gasoline engine with 100% of the bioethanol was developed and used in Brazil already, but researches of using the bio-ethanol in diesel engines are lack. In this study, combustion tests with blend fuel of the gas oil and bio ethanol by 50% maximally due to a low cetane number of bio-ethanol were accomplished as a basic study of introduction of using the bioethanol in diesel engines. The result was that smoke emission was decreased with increase in proportion of the bio-ethanol, due to the increase of a amount of pre-mixed combustion with ignition delay. Although the amount of CO2 is reduced according as the bio-ethanol is used(carbon neutral), the emission of CO2 with increase in the proportion of the bio-ethanol was more increased due to lower a heat value of bio-ethanol than gas oil.