PURPOSES : This study establishes a methodology for evaluating traffic safety in response to the introduction of one-way traffic using surrogate safety measures and analyzes the impact of one-way traffic safety through a case analysis. METHODS : The SSAM(Surrogate Safety Assessment Measure) was used to analyze traffic conflicts (TTC(Time to Collision) and PET(Post Encroachment Time)), which are safety indicators. The SSAM input variable dataset was constructed using a VISSIM(Verkehr In Städten - SIMulationsmodell) simulation. RESULTS : Introducing one-way traffic rather than the pending issue (two-way operation) improved traffic safety as the possibility of TTC or PET was reduced. In addition, the analysis results showed that the average TTC time and average PET time increased with the introduction of the one-way system. It is anticipated that the avoidance action time taken by the driver to avoid dangerous situations will also increase, which will help improve traffic safety. CONCLUSIONS : As an alternative to solving traffic safety and communication problems occurring at the study site, it was determined that a one-way system would be effective. Furthermore, a one-way system that allows two-lane roads on both sides to move one-way and allows parking in pockets on both sides of the road would be appropriate.

PURPOSES : This paper proposes an artificial neural network (ANN)-based real-time traffic signal time design model using real-time field data available at intersections equipped with smart intersections. The proposed model generates suitable traffic signal timings for the next cycle, which are assumed to be near the optimal values based on a set of counted directional real-time traffic volumes. METHODS : A training dataset of optimal traffic signal timing data was prepared through the CORSIM Optimal Signal Timing program developed for this study to find the best signal timings, minimizing intersection control delays estimated with CORSIM and a heuristic searching method. The proposed traffic signal timing design model was developed using a training dataset and an ANN learning process. To determine the difference between the traditional pre-time model primarily used in practice and the proposed model, a comparison test was conducted with historical data obtained for a month at a specific intersection in Uiwang, Korea. RESULTS : The test results revealed that the proposed method could reduce control delays for most of the day compared to the existing methods, excluding the peak hour periods when control delays were similar. This is because existing methods focus only on peak times in practice. CONCLUSIONS : The results indicate that the proposed method enhances the performance of traffic signal systems because it rapidly provides alternatives for all-day cycle periods. This would also reduce the management cost (repeated field data collection) required to increase the performance to that level. A robust traffic-signal timing design model (e.g., ANN) is required to handle various combinations of directional demands.

PURPOSES : This study aims to develop and validate timing transition techniques for real-time traffic signal operations, departing from conventional methods based on past commuting traffic patterns. METHODS : In this study, we propose two traffic signal transition techniques that can perform transitions while minimizing disruptions within a short period. The Proposed 1 technique involves an unconditional transition within one cycle and allows for the allocation of offset changes to both the coordinated and non-coordinated phases. The Proposed 2 technique performs transitions within 1-2 cycles based on the offset change rate and considers the non-coordinated phase for allocating offset changes. RESULTS : Functional improvements of the proposed techniques were validated. For validation, simulated traffic signal transition scenarios were created, and a comparative analysis of the transition techniques was performed based on the selected analysis approaches. The results showed that the Proposed 1 technique exhibited the lowest delay during the approximated saturated transitions, whereas the Subtract technique showed the lowest delay during the non-saturated transitions. CONCLUSIONS : These findings emphasize the importance of selecting and applying appropriate transition techniques tailored to individual traffic scenarios. The proposed transition techniques provide valuable insights for improving real-time traffic signal operations, and contribute to the overall efficiency and effectiveness of traffic management in highway corridors.

PURPOSES : Most Red bus1) (metropolitan bus) routes to Seoul need to increase supply by increasing the number of buses and number of trips because of the high level of congestion in buses, which also accommodate standing passengers. Due to the recent Itaewon disaster, people have been banned from standing on Red buses due to concerns over the excessive use of public transportation, adding to the inconvenience of passengers, such as increased travel time. However, some routes incur a large deficit owing to excess vehicles and trips relative to the number of passengers, thereby increasing the financial burden of Gyeonggi. Therefore, in this study, a reasonable operation plan is required based on the demand on Red bus routes. METHODS : Using accurate data from smart cards and a Bus Management System, the model was applied to consider bus usage, bus arrival distribution, waiting time, and operating conditions, such as actual bus usage time and bus dispatch interval. RESULTS : As a result of applying the model, buses between 7:00 and 9:00 and 16:00 and 18:00 were very crowded because of standing passengers, and passenger inconvenience costs decreased because of the longer waiting times for bus stops in Seoul. Currently, there are 15 buses in operation for the red bus G8110. However, considering the annual transportation cost, transportation income, and support fund limit, up to 12 buses can be operated per day. The G8110 route was analyzed at 23.6 million won for passenger discomfort cost, as 15 buses operated 97 times per day on weekdays. However, when establishing optimal scheduling, 12 buses per day operated 75 times per day, with a 19.7 million won passenger discomfort cost. CONCLUSIONS : As all red buses run from the starting point, passengers at the bus stop wait for more than an hour before entering Seoul, and the passenger discomfort cost of using demand-responsive chartered buses decreases only when commuting from Jeongja Station and Namdaemun Tax Office stops. Currently, many people commuting from Gyeonggi-do to Seoul are experiencing significant inconvenience owing to the ban on standing in Red buses; a suitable level of input can be suggested for the input and expansion of chartered buses.

PURPOSES : Because a driving simulator typically focuses on analyzing a driver’s driving behavior, it is difficult to analyze the effect on the overall traffic flow. In contrast, traffic simulation can analyze traffic flow, that is, the interaction between vehicles; however, it has limitations in describing a driver’s driving behavior. Therefore, a method for integrating the simulator and traffic simulation was proposed. Information that could be controlled through driving experiments was used, and only the lane-change distance was considered so that a more natural driving behavior could be described in the traffic flow. METHODS : The simulated connection method proposed in this study was implemented under the assumption of specific traffic conditions. The driver’s lane-changing behavior (lane-changing distance, deceleration, and steering wheel) due to the occurrence of road debris was collected through a driving study. The lane-change distance was input as a parameter for the traffic simulation. Driving behavior and safety were compared between the basic traffic simulation setting, in which the driver's driving behavior information was not reflected, and the situation in which the driving simulator and traffic simulation were integrated. RESULTS : The number of conflicts between the traffic simulation default settings (Case 1) and the situation in which the driving simulator and traffic simulation were integrated (Case 2) was determined and compared for each analysis. The analysis revealed that the number of conflicts varied based on the level of service and road alignment of the analysis section. In addition, a statistical analysis was performed to verify the differences between the scenarios. There was a significant difference in the number of conflicts based on the level of service and road alignment. When analyzing a traffic simulation, it is necessary to replicate the driving behavior of the actual driver. CONCLUSIONS : We proposed an integration plan between the driving simulator and traffic simulation. This information can be used as fundamental data for the advancement of simulation integration methods.

This study aims to understand the current status of exemptions for traffic accidents during the return of emergency vehicles and to provide suggestions for improvement. A survey was conducted on 3,500 firefighters to investigate the perception of traffic accidents during the return of emergency vehicles, and responses from 505 participants were analyzed. Based On the demographic characteristics and perception of the participants, frequency analysis and variance analysis were used as research methods to analyze basic statistics and the current situation. The results showed that firefighters have concerns and anxieties about traffic accidents during the return of emergency vehicles, and the need for applying exemptions and enacting explicit legal provisions was statistically confirmed. Based on these results, we suggest a policy for exemptions to improve the preparation for re-deployment and to alleviate the concerns and anxieties of firefighters.

Ensuring the safe arrival of delivery cargo at its intended destination is of utmost importance. Truck drivers play a crucial role in guaranteeing the secure delivery of cargo without any mishaps. However, there are various factors that may lead to delayed arrival of trucks at their destination, such as late departures or prolonged loading operations. The timely departure of cargo transportation is contingent upon several variables, including the driver's experience, cargo volume, and loading time. If the transportation commencement is delayed, it may increase the risk of accidents due to an elevated operating speed. Consequently, we conducted a study to investigate the correlation between cargo loading time, cargo volume, driving experience, and the likelihood of accidents. Our findings indicate that both cargo volume and driver experience can impact the likelihood of vehicle accidents. Furthermore, all factors can have an interactive effect on the occurrence of accidents. However, extending the loading time may mitigate the impact on the likelihood of accidents.

기상불량으로 인해 발생하고 있는 해양사고 중 해무 발생에 따른 시계제한은 선박의 좌초, 선저 파손 등의 사고를 유발하는 것과 동시에 사고에 따른 인명피해를 동시에 수반하고 있으며 이는 매년 지속적으로 발생하고 있다. 또한 해상에서의 저시정은 지역간 국소적으로 차이가 존재하는 경우에도 일괄적으로 여객선에 대한 운항 지연 및 통제 조치를 하고 있어 섬주민들의 교통수단 이용에 상당 한 불편을 초래하는 등의 사회적 문제로 대두되고 있다. 더욱이 이와 같은 조치는 지역적 편차나 사람마다 관측의 판단 기준이 상이하여 이를 객관적으로 정량화하지 못하고 있어 더욱 문제가 심화되고 있는 실정이다. 현재 각 항만의 VTS에서는 시정거리가 1km 미만인 경우 선박의 운항을 통제하고 있으며, 이 경우 저시정에 따른 해무 가시거리를 시정계 혹은 육안에 의한 목측(目測)에 의존하고 있을 정도로 객관적인 데이터 수집을 통한 평가에 있어서는 한계가 있다. 정부에서는 이와 같은 해양교통안전 저해요소를 해결하기 위한 일환으로 해 무 탐지 및 예측을 위한 해양기상신호표지 및 해상안개관측망을 구축하여 운용하고 있으나, 국지적으로 발생하는 해무를 관측하기 위한 시스템은 매우 부족한 현실적 어려움에 놓여있다. 이에 따라 본 논문에서는 해상에서의 저시정으로 인해 발생하고 있는 여러 사회적 문 제를 해결하기 위한 국내․외 정책동향에 대해 살펴보고, 이와 관련한 일반국민 및 현장 이해관계자의 인식 정도를 조사․분석하여 해무 에 따른 해상교통안전을 확보하기 위한 정부지원(해무 탐지 및 예측 기술을 기반으로 한 해상교통운영 체계 개발 등)의 필요성에 대한 기 초자료를 제공하고자 한다. 또한 이는 궁극적으로 해무로 인해 발생할 수 있는 해상안전 위험요소를 사전에 차단함으로써 보다 안정된 해상교통운영체계를 마련하는데 그 목적을 두고 있다.