This study focused on improving the solubility of silodosin, a drug poorly soluble in water, by utilizing solid dispersions. Three types of dispersions were examined and compared against the drug powder: surface-attached (SA), solvent-wetted (SW), and solvent-evaporated (SE). Polyvinyl alcohol (PVA) was identified as the most effective polymer in enhancing solubility. These dispersions were prepared using spray-drying techniques with silodosin and PVA as the polymer, employing solvents such as water, ethanol, and a water-acetone mix. The physicochemical properties and solubility of the dispersions were evaluated. The surface-attached dispersions featured the polymer on a crystalline drug surface, the solvent-wetted dispersions had the amorphous drug on the polymer, and the solvent-evaporated dispersions produced nearly round particles with both components amorphous. Testing revealed that the order of improved solubility was: solvent-evaporated, solvent-wetted, and surface-attached. The results demonstrated that the preparation method of the solid dispersions significantly impacted their physicochemical properties and solubility enhancement.

A liquid chromatographic method, using matrix solid-phase dispersion (MSPD) is developed for the extraction of residual furazolidone in chicken eggs. Blank or fortified egg samples (0.5 g) were blended with Octadecylsilyl (Bulk C,,, 40 pm, 18%. load, endcapped. 2 g) derivatized silica. After homogenization, C,,/egg and Na2S0, matrix were transferred to a column made of 10 ml glass synnge and filter paper and compressed 4.0-4.5 ml volume. The column was washed with 8 ml of hexane and dried under N, gas. Furazolidone was eluted with acetonitrile (8 ml) under gravity. The eluate containing furazolidone was free from interfering compounds when analyzed by HPLC with UV detection (365 nm, photodiode array). Calibration curves were linear (r = 0.99985) and inter- (1.47%) and intra-assay (5.29%) variabilities for the concentration range examined (7.8-497 ngig of eggs, 20 pl injection volume) were indicative of an acceptable methodology for the analysis of furazolidone. Average recovery of furazolidone added to egg was 96.2%. The limit of detection for the proposed method was 1 ng/g for furazolidone. The method using MSPD is proposed as an alternative assay to the classical method which involves the use of large volumes of a harmful solvent and requires a long tedious separation and clean-up processes prior to its determination.

A simple, rapid and simultaneous analytical method is described for the detection of Sulfonamide and Tetracycline residues, i.e., Sulfamerazine (SMR), Sulfamethazine (SMT), Sulfamonomethoxine (SMM), Sulfadimethoxine (SDM), Sulfaquinoxaline (SQN), Oxytetracycline (OXY), Tetracycline (TC), Chlortetracycline (CTC). Blank control and sulfonamide and tetracycline fortified fish muscle samples (0.5 g) were blended with octadecylsilyl (C,e, 40 gm, 21% load, 60Å) derivatized silica packing material (2 g). Blended fish samples were washed with hexane, then, benzene and dichloromethane were used for the elution of tetracycline and sulfonamide, respectively, The eluants containg tetracycline and sulfonamide were analyzed by HPLC. Correlation coefficients of standard curves for individual sulfonamide and tetracycline isolated from fortified samples were linear (0.9993±0.0003-0.9997±0.0003, 0.9493±0.078-0.9753±0.036), respectively, The average percentage recoveries of sulfonamide and tetracycline ranged as 80.86-96.52% to 85.88-92.23%, and 30.01-37.12% to 65.89-73.40%, for the concentration range (0.1--1.0 ppm) examined, respectively. Limit of detection for sulfonamide was 0. 05 ug/g, then, tetracycline was 0.1 ug/g. Detection of quantitation of sulfonamide residue was 0.0012 ppm for SMR in Paralichthys Odiuacleus and 0.0020 ppm for SMR, 0.015 ppm for SMM in Cyprinus Carpio. The applicability of this procedure is demonstrated by separation and detection of incurred tetracycline and sulfonamide residues in fish muscle tissue.

In this outline, the stability of solid/liquid dispersion was theoretically investigated the matter from all angles by using the modified DLVO theory. The stability was handled various considerations such as a production and characteristics of electrical double layer, total interaction(VT) that consisting of attractive force(VA) and repulsion(VR). coagulation, the stability ratio(W), critical flocculation concentration (cfc) and zeta potential(ξ) etc. It was possible for us to examine with the stability ratio(W), critical flocculation concentration (cfc) and zeta potential(ξ) that may estimation of stability of solid/liquid dispersion experimentally.