This paper has relatively high technical standard and experimental skill. The fabrication of TCO film with hightransparency, low resistance and low chromaticity require exact control of several competing factors. This paper has resolvedthese problems reasonably well, thus recommended for publication. Indium tin oxide(ITO) thin films were by D.C. magnetronroll-to-roll sputter system utilizing ITO and SiO2 targets of ITO and SiO2. In this experiment, the effect of D.C. power, windingspeed, and oxygen flow rate on electrical and optical properties of ITO thin films were investigated from the view point ofsheet resistance, transmittance, and chromaticity(b*). The deposition of SiO2 was performed with RF power of 400W, Ar gasof 50sccm and the deposition of ITO, DC power of 600W, Ar gas of 50sccm, O2 gas of 0.2sccm, and winding speed of 0.56m/min. High quality ITO thin films without SiO2 layer had chromaticity of 2.87, sheet resistivity of 400ohm/square, and trans-mittance of 88% and SiO2-doped ITO Thin film with chromaticity of 2.01, sheet resistivity of 709ohm/square, and transmittanceof more than 90% were obtained. As a result, SiO2 was coated on PET before deposition of ITO, their chromaticity(b*) andtransmittance were better than previous results of ITO films. These results show that coating of SiO2 induced arisingchromaticity(b*) and transmittance. If the thickness of SiO2 is controlled, sheet resistance value of ITO film will be expected tobe better for touch screen. A four point probe and spectrophotometer are used to investigate the properties of ITO thin films.

Indium Tin Oxide (ITO) thin films on Polyethylene Terephtalate (PET) substrate were prepared by Roll-to-Roll sputter system with targets of 5 wt% and 10 wt% SnO2 at room temperature. The influence of the chromaticity (b*) and transmittance properties of the ITO Films were investigated. The ITO thin films were deposited as a function of the DC power, rolling speed, and Ar/O2 gas flow ratio, and then characterized by spectrophotometer. Their crystallinity and surface resistance were also analyzed by X-ray diffractometer and 4-point probe. As a result, the chromaticity (b*) and transmittance of the ITO films were broadly dependent on the thickness, which was controlled by the rolling speed. When the ITO films were prepared with the DC power of 300 W and the Ar/O2 gas flow ratio of 30/1 sccm using 10 wt% SnO2 target as a function of the rolling speeds 0.01 through 0.10 m/min, its chromaticity (b*) and transmittance were about -4.01 to 11.28 and 75.76 to 86.60%, respectively. In addition, when the ITO films were deposited with the DC power of 400W and the Ar/O2 gas flow ratio of 30/2 sccm used in 5 wt% SnO2 target, its chromaticity (b*) and transmittance were about -2.98 to 14.22 and 74.29 to 88.52%, respectively.

Arsenic is among the heavy metals commonly found in aqueous environments. Iron oxide is known as an efficient adsorbent for the arsenic. A new synthetic method was applied to provide iron oxide giving a large specific surface area. The mixing method affects the formation of iron oxide. Ultrasonic waves assisted the formation of very fine iron oxide in an organic phase. The synthesized iron oxide is amorphous type with a high surface area of more than 181.3 m2/g. Sorption capacity of the synthesized adsorbent was relatively very high for arsenic and varied depending on the oxidation state of arsenic: a higher capacity was obtained with As(V). Lower solution pH provided a higher sorption capacity for As(V). The competitive effect of co-exist anions such as chloride, nitrate, and sulfate was minimal in sorption capacity of the iron oxide for arsenic.

Cd2+ 이온으로 교환된 제올라이트 Y 단결정은 294 K에서 |Na75|[Si117Al75O384]-FAU(Na75-Y, Si/Al = 1.56)에 0.05 M인 Cd(NO3)2(pH = 3.65)수용액으로 교환하여 723 K에서 진공 탈수를 통해 준 비하였고(crystal 1) 두 번째 결정은 첫 번째 결정과 같이 준비한 뒤 294 K에서 건조된 벤젠을 72시간 동안 노출시켜 준비했다(crystal 2). 이들의 구조는 싱크로트론 X-선을 이용하여 결정학적으로 확인하 였고 Fo > 4σ(Fo)를 사용하여 최종 오차 인자를 각각 R1/wR2 = 0.040/0.121 그리고 0.052/0.168로 정 밀화하였다. Crystal 1(|Cd36H3|[Si117Al75O384]-FAU)에서 Cd2+이온은 주로 site I과 site IIa에 점유되어 있었고, 이와 더불어 site I’, II’ 그리고 site IIb에도 Cd2+ 이온이 점유되어졌다. Crystal 2(|Cd35(C6H6)24H5|[Si117Al75O384]-FAU)에서 Cd2+ 이온은 다섯 개의 결정학적 자리에 점유되었다. 24개 의 벤젠분자는 supercage 내부에서 두 개의 뚜렷한 자리에서 발견 되었다. 17개의 벤젠분자는 site IIa 에 있는 Cd2+ 이온과 면상에서 서로 상호작용하였고 supercage 안에서 3회 회전축 상에서 발견되었다. 나머지 7개의 벤젠분자는 12-ring 면상에서 골격(framework)산소들과 함께 약한 다수의 정전기적인 작용과 van der Waals 상호작용으로 안정화되어 있었다.

For the proposal of Microcystis aeruginosa control technique by coagulants, removal effects of coagulants were carried out using isolated strain and collected water bloom of M. aeruginosa on Downstream of the Nakdong River. Both of purified and field-collected M. aeruginosa were entirely sedimented by the addition of the coagulant Ceramic-Zeolite type Co 100 (1.5 ㎎/ℓ) within 24 hr, but Yellow loess (10 ㎎/ℓ) was less effective for the removal of M. aeruginosa within 24hr. Thus it was concluded that Ceramic-Zeolite type Co 100 was the most effective coagulant.