Stem and root of elm trees have used as traditional medical materials, but there is little information on the distribution and resources of habitats. Korean native growing Ulmus spp. (U. davidiana var. Japonica, U. parvifolia, U. davidiana, and U. macrocarpa) genetic resources studied through The National Forest Inventory of Korea data and field survey. The distributions of U. davidiana var. japonica according to elevation distributed evenly. Both U. parvifolia and U. davidiana were inhabited mostly at less than 200 m of altitude. Each Ulmaceae species widely were distributed nationwide, but a dominant species was different depending on locals. It observed that Ulmaceae inhabits mainly in steep slopes of 31-45 degrees. Most of the habitats regenerated by natural seeding and the most abundant species were a codominant tree. Distribution of trees in U davidiana var. japonica was 7 m-13 m, and in young U. parvifolia and U. macrocarpa, more than 25% of young trees less than 7 m observed. The distribution of the diameter of breast height of the U. davidiana var. japonica was 46.4% for 11-20 cm, 52.6% for 11-20 cm in U. parvifolia. The average T/R ratio was 0.83, and the mean weight ratio of root bark was 62%. As the results of this study, the domestic Ulmaceae biomassare very small. It is difficult to harvest in that the habitat on the slope. Thus, it is too hard to develop functional materials using biomass at present. Therefore, it is necessary to develop technology for the selection and propagation of elite trees of Ulmaceae.

The black pine bast scale, Matsucoccus thunbergianae Miller et Park, is one of the severe pest to pine forests in South Korea. In 1963, a severe pine damage by unknown causes were reported at Goheung region and it turned out that the damage was caused by the black pine bast scale, M. thunbergianae 20 years later. The black pine bast scale have been causing serious damage to Japanese black pine forests in the east and southwestern coastal area of South Korea and its distribution has been expanded. The areas of Japanese black pine forests damaged by M. thunbergianae was 4,043ha in 41 cities or districts in 2017. In males, two nymphal instars are followed by wingless preadult, the pupa, and the adult, whereas the female adult directly emerges from the second nymphal instar. According to recent sex pheromone survey for male adult, M. thunbergianae occur mainly single generation in South Korea with possibility its phenology was advanced probably due to climate change. Until now, the most effective measure to control the black pine bast scale is to trunk injection with insecticides after thinning of a damaged pine forest.

OLED Display fabrication system is one of the most complicated discrete processing systems in the world. As the glass size grows from 550×650mm to 1,500×1,850mm in recent years, the efficiency of Automated Material Handling System (AMHS) has become very important and OLED glass manufacturers are trying to improve the overall efficiency of AMHS. Aiming to meet the demand for high efficiency of transportation, various kind of approaches have been applied for improving dispatching rules and facility layout, while simultaneously considering the system parameters such as glass cassettes due date, waiting time, and stocker buffer status. However, these works did not suggest the operational policy and conditions of distribution systems, especially for handling unnecessary material flows such as detour. Based on this motivation, in this paper, we proposed an efficient algorithm for improving detour transportation in OLED FAB. Specifically, we considered an OLED FAB simplifying OLED production environment in a Korean company, where four stockers are constructed for the delivery of Lot in a bay and linked to processing equipments. We developed a simulation model using Automod and performed a numerical experiment using real operational data to test the performance of three operation policies under considerations. We showed that a competitive policy for assigning alternative stocker in case of detour was superior to the current dedicated policy using a specified stocker and other considered policies.

The ability of plants to endure environmental stress factors, which are going to be more severe due to global warming, is important especially for forest plants. Because obtain trait of resistance to temperature using conventional breeding for woody plants is a time consuming way. In this study, chloroplast-localized OsHSP26 gene was overexpressed in Populus alba L. to breed tolerant transgenic poplar to temperature stress. The plantlets of OsHSP26-overexpressed transgenic poplar showed more heathy phenotypic response than wild-type plants under both prolonged low- and high-temperature stress. While the SPAD value, which refers chlorophyll content, in wild-type plants decreased depending on the exposure time to the temperature stress, higher SPAD value were shown in the transgenic plants. The contents of total phenolic compounds in the transgenic plants were lower than those of the wild-type plants, and not significantly changed except in the treatment of prolonged low-temperature. However, the total flavonoids contents of the transgenic plants were dramatically increased under prolonged temperature stress. The DPPH scavenging activities of the transgenic plants were higher than those of the wild-type plants under temperature stress. Consequently, it was revealed that overexpressing OsHSP26 allow for P. alba to be tolerant to temperature stress.

There are a lot of types of wild vegetables such as Colocasia esculenta (L.) Schott stem in Korea. However, the consumption of these wild vegetables is restricted because their storage decreased dramatically after harvest. To maintain original quality of vegetables, pre-treatments such as blanching and drying are important. But conditions for these treatments were still not optimized for many vegetables including Colocasia esculenta (L.) Schott stem. Thus, the objective of this study was to set up an optimal pre-treatment method for freezing storage. Colocasia esculenta (L.) Schott stems were peeled and cut equally (10 cm) for sample preparation. Dried samples (D) were dried at 90℃ for 3 h. Blanched samples (B) were blanched in hot water at 100℃ for 2 min. Blanched and dried samples (BD) were blanched and dried as same protocol. Physicochemical properties were analyzed to evaluate the quality including texture, moisture content, total color difference and viable cell count. Raw sample had 6.85 kg/cm 3 of hardness and 78.75 of chewiness whereas B was 6.83 kg/cm 3 of hardness and 7.8 of chewiness. B had the similar value compared to raw samples. Moisture content of raw sample was 94.4% and that of B was 94.1%, though there were not any significant differences between them. ΔE value of B showed lower value than those of the others. Viable cell counts and total coliforms were not detected after treatment, while raw sample had 5.39 log CFU/g of viable cell count without total coliform. Therefore, pre-treatments are essential for microbial safety of samples. All results considered, it is supposed that blanching is the optimal pre-treatment to sustain its original quality of Colocasia esculenta (L.) Schott stems before freezing.

The objective of the study was to measure the beneficial effects of lactic acid bacteria (LAB) inoculation on the nutritive value of oat silage collected from thirteen regions in the Republic of Korea. The contents of crude protein, acid detergent fiber (ADF), neutral detergent fiber (NDF) and crude ash (CA) were slightly lower in LAB inoculated silage when compared with the control silage, whereas inoculation of LAB resulted in increased total digestible nutrient (TDN). Higher number of LAB, but lower count of yeast and fungi indicated the effectiveness of the LAB inoculation on oat silage fermentation. LAB inoculation resulted in low pH silage, which may prevent undesirable microbial growth. The LAB inoculation promoted lactic acid dominant fermentation with marginal levels of acetic acid and butyric acid in oat silage. These data suggest that the LAB inoculation may preserve oat silage at better quality for ruminant animal production.

An experiment was carried out to determine the homofermentative activity of Lactobacillus plantarum KCC-10 and KCC-19 on the ensiling of whole crop barley (WCB). The crude protein in the silages was slightly higher in the KCC-10 and KCC-19 treatments compared to the control, but there was no significant difference between the two inoculant-treated silages. Nutrient parameters such as acid detergent fiber, neutral detergent fiber and in vitro dry matter digestibility in L. plantarum KCC-10 and KCC-19 treated silages did not differ from those in the control silage. The lactic acid content increased in KCC-10 and KCC-19 treated silage when compared with the control silage but the contents of acetic acid and butyric acid produced in KCC-10 and KCC-19 treated silages were similar with the control silage. Further, the number of lactic acid bacteria (LAB) in KCC-10 treated silage demonstrated a significant increase when compared to the control. Especially, KCC-19 treated silage showed greater lactic acid bacterial growth potential. Other microbes such as yeast and fungi were not detected in KCC-10 and KCC-19 treated WCB silages. Hence, this study suggests that the addition of L. Plantarum KCC-10 and KCC-19 to the WCB silage can improve fermentation quality for the production of high-quality silage.

An investigation was carried out to evaluate the potential role of Lactobacillus Plantarum KCC-10 and KCC-19 on the quality and fermentation characterization of Italian ryegrass (IRG) silages. The physiochemical properties of IRG silage such as crude protein content, neutral detergent fiber, acid detergent fiber, total digestible nutrient and in vitro dry matter digestibility were not affected by KCC-10 and KCC-19. The pH of IRG silage in KCC-10 and KCC-19 treatments decreased compared to the control (p<0.05), while the lactic acid content in KCC-10 and KCC-19 treatments increased compared to the control (p<0.05). In addition, the number of lactic acid bacteria (LAB) in the KCC-10 treatment increased compared to the control (p<0.05). The number of lactic acid bacteria in KCC-19 increased, but there was no significant difference in all treatments. Therefore, we recommend L. plantarum KCC-10 and KCC-19 as potential additive candidates in IRG silage with lots of advantages.

Trunk injection of nematicides was applied to prevent pine wilt disease (PWD). Although the trunk injection of nematicides was effective to PWD prevention, it was not effective to a vector, Monochamus alternatus. Thus, This study was investigated for the insecticidal activity and the effect of oviposition deterrence by injecting to pine trees with systemic insecticides such as Acetamiprid SC 10%, Imidacloprid DC (20%), and Thiamethoxam DC (15%). As a results, mortality of M. alternatus adults was 100% at 56 days after trunk injection. Percentage of M. alternatus adults moved to a young black pine tree by trunk injection of Imidacloprid DC (20%) and Thiamethoxam DC (15%) in screen cage (4.0×2.0×2.5m) was 76.7% and 70.0%, respectively. But the mortality of M. alternatus adults showed 100%. Percentage of M. alternatus adults moved to the treated and untreated young black pine trees by trunk injection of Acetamiprid SC (10%) in screen cage (4.0×2.0×2.5m) were 25.9% and 49.5% at 1st day and 3rd day after treatment, respectively. Percentage of M. alternatus adults oviposited to treated pine logs at 3month after trunk injection of liquid mixture of Acetamiprid SC (10%) and Emamectin benzoate EC (2.15%) in screen cage (72×72×100㎝) was 25%. But, untreated pine logs was 100%

This study was carried out to determine a fertilization rate for productivity and nutritive value improvement of silage corn, using two kinds of composts, and to examine the potential possibility of utilization as an organic fertilizer. The experiment was