선체구조의 품질검사 중 가장 일반적인 방법의 하나는 비파괴검사이다. 하지만 복합소재 선체는 강화재와 수지로 구성된 여러가지 재료가 섞여 있고 또 생산환경과 작업자에 따라 FRP(Fiber-Reinforced Plastics) 제작품질에 차이가 발생할 가능성이 크기 때문에 정확한 검사평가는 쉽지 않은 일이다. 특히 FRP 선박의 경우에는 다른 구조물보다 두께가 매우 두껍고 주로 수척층 공법을 이용하기 때문에 더욱 그렇다. 초음파 탐상의 조건 중 검사체의 밀도가 매우 중요하기 때문에 본 연구에서는 FRP 선박 제작에 널리 사용되고 있는 소재와 유리섬유강화재 중량 비율로 제작된 선박의 외판을 검사체로 선정하고, Pulse-Echo 초음파 탐상기를 활용하여 GFRP(Glass Fiber-Reinforced Plastics) 선체 외판의 초음파 탐상을 위한 적정 조건을 조사하였다. 1.00 MHz, 2.25 MHz, 5.00 MHz 세 종류 탐촉자로 A-Scan 을 실시하였으며 선체 외판의 두께 검사결과와 비교분석함으로써 적정 초음파 탐상 조건을 찾고자 하였다. 연구결과 탐촉자의 초음파 주파수가 높아질수록 수신자의 반사파 음향 속력을 감소시켜야 더 정도 높은 두께 측정 결과를 얻을 수 있었으며, 상대적으로 낮은 초음파 주파수 탐촉자에서 더 적은 오차가 발생함을 확인할 수 있었다.

The GPS positioning method is widely used in the performance of forest tasks due to its convenient observation. But the result of GPS positioning without precise GPS measurements or DGPS method generally includes relatively large positioning errors. In case of mountainous regions, these positioning errors more increase because tree canopies or topographies interfere GPS satellite signals. Thus, observers have to consider how large positioning errors are included under the various observation condition in mountainous regions. In this study, we conducted a real-time GPS positioning experiment in the mountainous region with widely used three hand-held GPS measurements and a precise GPS measurement in Korea Forest Service. We observed the positioning data at various regions of topography and physiognomy. Finally, we analyzed the RMSE of each GPS positioning results under various mountain environments.

We have developed superconducting mixer receivers for 129 GHz VLBI observation in Korean VLBI Network (KVN). The developed mixer has a radial waveguide probe with simple transmission line L-C transformer as a tuning circuit to its 5 series-connected junctions, which can have 125 - 165 GHz as the operation radio frequency (RF). For intermediate frequency (IF) signal path a high impedance quarter-wavelength line connects the probe to one end of symmetric RF chokes. The double side band (DSB) receiver noise of the mixer was about 40 K over 4 - 6 GHz IF band, whereas we achieved the uncorrected single side band (SSB) noise temperature of about 70 K and better than 10 dB image rejection ratio in 2SB configuration with 8 - 10 GHz IF band. Insert-type receiver cartridges employing the mixers have been under commission for KVN stations.

We designed the Intermediate Frequency(IF) distributor for multi beam backend system and manufactured Voltage to Frequency Converter(VFC) to measure the multi-beam receiver performance. Multi beam receiver has 15 channel receivers and can get 15 spectrums at once. The multi beam receiver has more observation efficiency than single beam receiver. We manufactured the 15 IF distributors to distribute IF signal for Autocorrelation spectrometer that is radio signal processor. Also, we manufactured the VF Converter to test the performance measurement of receiver for Korea VLBI Network(KVN) system which is under-construct in Seoul, Ulsan and Jeju. As a result of performance measurement, we could obtain linearity of 99.4% on the input power vs output frequency and measured the operating range of input frequency.

In order to get more accurate GPS position with the changes of the inner configuration setting of GPS receiver, the authors carried out measurements of the position at known it with one antenna and two GPS receivers manufactured by same company. We have investigated the accuracies of positions according to the change of the maskangle and receiving mode of output data in inner configuration of GPS receivers, and analyzed the relationships between numbers of satellites visibility and maskangles, and values of HDOP and maskangles. When the maskangles in inner configuration were set below 20 degree, the accuracies of positions were high. But if they were became bigger than 25 degree, standard deviations ot position errors and HDOPS of positions were became bigger. Numbers of satellites visibility(y) and maskangles(x) have relations with a formula, y = -0.1662x+9.9225, and values of HDOP(y) and maskangles(x) have relations with a formula, y = 0.6035 e0.0517x. The results of position accuracies observed by two GPS receivers to the known position at same time were that average errors of position fixs by GPS receiver configured with NMEA0183 mode were 6.7m and standard deviations were 1.5m, and them by GPS receiver configured with binary mode were 5.0m and standard deviations were 1.1m respectively.