The physiochemical properties of dried yam (Dioscorea batatas) by freeze dryer, cold-air dryer or hot-air dryer were examined for chromaticity, water absorption index (WAI), water soluble index (WSI), rehydration, viscosity properties and pasting properties. Freeze dried yam was maintained higher degree of lightness and higher WAI and WSI than those of cold-air or hot air dried one. In the case of rehydration, freeze dried yam was restored within one hour. The viscosity properties of freeze dried yam were the highest viscosity in all shear rates. Freeze dried yam was milled by roll mill (RM), pin mill (PM) or jet mill (JM) to evaluate for particle size, starch damage, pasting property and microstructure. Particle size was JM < PM < RM as 13.85~112.50 μm. In the result of starch damage, it was the highest value as 8.83 in JM, was the lowest value as 7.47 in RM. In pasting property, JM had relatively low viscosity at all shear rates. In the Microstructure by measuring scanning electron microscope, JM particle surfaces were rough with high starch damage, and particle size was confirmed fine particles in JM.

To increase the collagen recovery rate, bromelain (PB) and a microbial enzyme (PM) were used to treat to pork skin with single agent or combinations. The quality of collagen from the pork skin was evaluated by enzymatic treatments. The highest results for the solid contents and pork skin recovery rate obtained with the microbial-enzyme-bromelain mixtue (PMB) were 13.60% and 18.05% respectively. The result also showed that the color was affected by different types of enzyme treatments. Although PM treatment showed the highest result in the protein content of 251.30 mg/100 g, PMB treatment was the highest in the test of collagen content of 37.73 g/100 g among the treatments. However bands of the pork skin were detected widely at 130 kDa and 170 kDa ranges in SDS-PAGE. The band of PB treatment showed at the range of below 17 kDa, changed into a smaller molecular weight. The collagen content test of the pork skin by the treatments, collagen contents with combination treatment of pork skin with PMB (0.5%) resulted the highest in 43.76 g/100 g. Also the fat content at the above treatment was reduced to 11.12% compared to the other treatments. With these results of this experiment, we conclude that the enzymatic treatments were effective for the processing property of pork skin like enhancing the yield of collagen

The processing properties of spent hen and broiler chicken were investigated before and after treatment to improve texture characteristics. Each treatment consisted steaming (S) with 85℃ for 20 min, Pulsed Electric Field (PEF) with 1.5 KV/cm for 4 sec, and Super Heated Steam (SH) with an oven temp. of 300℃, a steam temp. of 350℃ for 8 min. The yield of spent hen and broiler were 66.85% and 63.80% respectively in the control, but decreased in every treatment was lowest at 61.05% in the PEF treatment (p<0.05). In the color test, L value decreased, but the a and b values increased regardless of the species of spent hen or broiler. In the test of heating loss, the S treatment of spent hen had the highest result of 45.25% but lowest of 30.66% in the SH treatment of the broiler. When it was compared with various treatments, SH after PEF treatment showed the better result in terms of heating loss than the PEF or SH treatment respectively. In the test of texture, the broiler showed the lowest hardness of 5.57 kg in the SH (p<0.05). Otherwise, the spent hen resulted in 14.08 kg of hardness in steaming after PEF, but it improved significantly to 10.73 kg in SH after PEF. In the test of 9 scored sensory evaluation of overall palatability, 7.8 point was the best score with SH treatment in the broiler. The best score in spent hen was 6.3 point which was SH after PEF treatment. With this experiment, SH after PEF was the condition in the treatments to have the better texture of spent hen.

In order to determine the material characteristics of pork rinds according to the breeds, the chemical composition, color, pH, collagen contents, shear force, fatty acid and amino acid contents of pork rinds were investigated. White pork rinds (WPR) and black pork rinds (BPR) were evaluated before and after heating to compare the differences between breeds and the effects of heating treatment. In the chemical composition test, the respective moisture contents for WPR and BPR before heating were 49.90% and 53.75% but increased to 60.75% and 61.09% after heating. The test for crude protein and crude fat contents showed lower values after heating but WPR was higher than BPR. In the color test, the L value decreased rapidly with heating, dropping from 68.75 to 45.11 in WPR and from 67.22 to 49.64 in BPR. WPR had a higher L value and a lower a value than BPR before heating but had a higher L value and a lower a value than WPR after heating. pH was significantly higher in WPR than BPR regardless of heating (p<0.05). The collagen content for WPR and BPR was 10.38 g/100 g and 11.54 g/100 g but increased to 12.00 g/100 g in WPR and decreased to 11.40 g/100 g in BPR after heating. The shear force of 26.14 kgf in WPR was significantly higher than 12.89 kgf in BPR before heating (p<0.05), but the values decreased significantly after heating in both WPR and BPR. Linoleic acid in WPR was 17.29%, which was higher than 15.13% in BPR. The USFA for BPR was also higher than WPR. In amino acid composition, the EAA contents in WPR was 7,190 mg%, which was higher than 5,520 mg% in BPR.

This study was performed to investigate the phyico-chemical characteristics of breast meat from spent hens (SP) in comparison with the same part from the broilers (BR). The moisture and crude protein contents for SP were 72.56% and 24.26%, which were lower than 75.87% and 24.64% for BR. Crude fat and crude ash contents in SP were 0.45% and 1.00%, which were higher than the BR contents of 0.41% and 0.51%. The respective L, a and b value for SP were 48.61, 2.40 and 2.42, which were lower than the BR values of 49.41, 1.45 and 3.06 respectively. The pH for SP was 5.89, which was higher than pH 5.79 for BR. The WHC for SP was 50.29%, which was lower than that of BR at 62.31%. SP scored 28.04% in the heating loss test, which was significantly higher than 19.09% for BR. The shear forces for SP and BR were 4.86 kg and 1.36 kg respectively, which meant that the texture of SP was much tougher than that of BR. Hardness for SP was 8.89 kg while that of BR was 3.92 kg indicating that the SP texture is firmer than that of BR. Oleic acid was most abundant fatty acid in both samples and was at 44.15% in SP and 27.68% in BR.

In order to fractionate sardine oil by different solvents for an effective use of fish oil being subjected to the limit of use, an attempt was to investigate the proper solvents, ratios and fractionation time. The results of the study were as follows: 1. The proper solvent of fractionation using ethanol, isopropyl alcohol, acetone, and hexane was ethanol, and its optimum ratio was 2:1 (ethanol: oil, v/w). The proper time of ethanol fractionation by the ratio (2:1) was 4hr at 10℃, 6hr at 5℃, 8hr at 0℃and 8hr at -5℃, respectively. 2. In the fractionation by stages using the ratio (2:1) at each temperature, the yield of stearine was 8％ at 10℃ (Fraction I), 32％ at 5℃ (Fraction II), 7％ at 0℃ (Fraction III) and 10％ at 0℃ (Fraction IV), respectively. When ethanol fractionation was undertaken at 5℃ by stages, the yield of stearine (Fraction II) was high. 3. Iodine value of Fraction II was 96.8. This result indicated that the hydrogenation process would be simplified by fractionation. 4. The percentage of the decrease of polyenoic acids from original sardine oil to Fraction II oil was from 30.5％ to 13.5％. The major fatty acids of Fraction II were palmitic and oleic acids and these fatty acids were about 52％ of total fatty acids. Therefore, Fraction II, which remained liquid oil at room temperature because solid fat content was 6.9％ at 20℃, would be used as frying oil.

The purpose of this study was to investigate the ability of natural antioxidants as stabilizers for meat by-products to prevent lipid oxidation. The white internal organs were evaluated using different treatments: no antioxidant (control), ascorbic acid (T1), Artemisiacapillaris Thunb. (T2), Opuntia (T3), Schisandra chinensis (T4), and Saururuschinensis (Lour.) Baill (T5). Antioxidant activities were analyzed by measuring DPPH contents, superoxide anion radical levels, nitrate scavenging activities, and total polyphenol contents. T1 and T2 showed higher antioxidant activities and total polyphenol contents (p<0.05). Additionally, changes in physicochemical properties (pH, color, volatile basic nitrogen [VBN], and thiobarbituric acid reactive substances [TBARS]) and microbiological aspects in white internal organs processed with antioxidants were investigated. As storage time increased, the CIE a* and b* values of the white internal organs processed with natural antioxidants were decreased (p<0.05), and CIE L* values were low, particularly for the T3 sample relative to that in the control. Moreover, the pH, VBN, and TBARS values of samples T2–T5 were increased after 7 days of storage, but showed low values compared with those of the control (p<0.05). Moreover, compared with the control group, the treatments showed antimicrobial effects. Our results indicated that these natural antioxidants could be used as lipid oxidation stabilizers of meat by-products during storage and that Artemisiacapillaris Thunb. and Opuntia may have applications as natural antioxidants in the meat by-product industry.