In this study, the removal performance of high-concentration H2S and complex odors was evaluated for bio-filters installed in sewage treatment plants and manure treatment plants. The amount of odor generation according to temperature was found to be higher in summer than in spring. It was found that the longer the empty bed retention time of the bio-filter, the higher the odor removal efficiency. Therefore, in order to effectively remove odors, it is necessary to maintain a sufficiently long residence time when designing a bio-filter. In addition, a case in which a bio-filter and a wet pre-treatment system were combined to remove high-concentration odors was studied. The result showed that the wet pre-treatment was effective in removing high-concentration odors. In particular, most of the hydrogen sulfide could be adequately removed by wet pre-treatment.

The effect of the change in air inflow velocity has been investigated at the opening of the malodor emission source to determine its influence on the Complex odor concentration. Both the Complex odor collection efficiency and concentrations were measured according to the change in airflow velocity. When the air inflow velocity was 0.1 m/s, it was observed that some of the generated gas streams were diffused to the outside due to low collection efficiency. In contrast, only the increased gas collection volume up to 0.5 m/s showed no substantial reduction of the Complex odor concentration, which indicates an increase in the size of the local exhaust system as well as the operation cost for the Complex odor control device. When the air inflow velocity reached 0.3 m/s, the Complex odor concentrations not only were the lowest, but the odorous gas could also be collected efficiently. The air inflow velocity at the opening of the malodor emission source was considered the key factor in determining the gas collection volume. Therefore, based on the results of this study, an optimal air inflow velocity might be suggestive to be 0.3 m/s.

Most of the odorous substances generated in public environment facilities are treated using a local exhaust ventilation system. This study assessed the leakage of odorous substances by measuring design criteria, collected air volume, and complex odor in the unit process of sewage treatment facilities. The closer the guideline/design operation airflow ratio of each odor source is to 1.0, the more identical the guideline:design:operation airflow. The average air volume ratio of the facilities under the study was 0.95~0.99 for the MBR process and 0.29~0.68 for the BNR process. As a result of comparing the types of wastewater treatment processes, the leakage of odorous substances was about 9.7 times higher in the BNR process (192,732 m3/min) than in the MBR process (19,838 m3/ min). In this study, it was found that the following two means are important for the proper collection and prevention of odorous substances. The first is the estimation of collection air volume with consideration to the characteristics of the odor source (temperature, odor generation condition, etc.). The second is the design and operation of the local exhaust ventilation system.

Since the implementation of the Odor Prevention Act in 2005, the number of odor complaints has continuously increased due to the increased interest in the living environment. The current odor control means is a concentrationbased method for the source of odor. That is why there is a difference between the odor sensitivity and the result of the odor measurement in the odor damage area. The government is considering the introduction of the grid method, which is the odor management method of Germany, as the method of odor investigation in the odor damage area in the second comprehensive Odor Prevention Policy (2019-2028). The grid method is receptor-based odor measurement method that investigators use to judge odors in the field, task that expensive and requires substantial manpower and time. To study an odor measurement method that is suitable for domestic conditions, this study compared the correlation between results based on the odor frequency concept grid method around the livestock facilities and the result of ammonia concentration measured by passive air sampler. The correlation coefficient (R) that is between the frequency of odor per spot for the entire odor and the ammonia concentration that was measured by passive air sampler was 0.65 which is relatively good. Among the entire odor detected by the grid method, the correlation coefficient (R) between the odor frequency selected only for livestock odor and the ammonia concentration was significantly increased to 0.80. In addition, the correlation between odor exposure (ECPexist) and the ammonia concentration for the overall odor was 0.81 (linear) and 0.86 (index). If only the livestock odors were selected, the correlation between odor exposure and the ammonia concentration was very high at 0.96 (linear) and 0.95 (index).

Odorous compounds emitted from the melting process for material recycling of plastic have an effect on the sensory annoyance to the nearby residents. The objective of this study was to investigate emission characteristics of malodor in the domestic plastic recycling plants. The olfactometric results showed that the odor concentration among the surveyed plants were significantly different, depending on the melting temperature and material sources. The higher melting temperature led to the higher odor concentration. In particular, as for a plant where melting temperature was 320℃, the odor concentration exceeded 100,000 dilution ratio. However, as the temperature was reduced, the odor emission decreased gradually. This result indicates that reduction of the melting temperature is effective measure to decrease the emission of odor compounds. Quantitative and qualitative analysis of odorous compounds showed that regulatory odor substances such as sulfur compounds, aldehydes and VOCs were found with high concentration in the exhausted gases. Liquid tar in the exhausted gases makes it difficult to remove odorous compounds with traditional odor control devices. In order to eliminate both odorous compounds and liquid tar effectively, a combustion method is strongly recommended in these plants.