Electrolessly deposited Co (Re,P) was investigated as a possible capping layer for Cu wires. 50 nm Co (Re,P) films were deposited on Cu/Ti-coated silicon wafers which acted as a catalytic seed and an adhesion layer, respectively. To obtain the optimized bath composition, electroless deposition was studied through an electrochemical approach via a linear sweep voltammetry analysis. The results of using this method showed that the best deposition conditions were a CoSO4 concentration of 0.082 mol/l, a solution pH of 9, a KReO4 concentration of 0.0003 mol/l and sodium hypophosphite concentration of 0.1 mol/L at 80˚C. The thermal stability of the Co (Re,P) layer as a barrier preventing Cu was evaluated using Auger electron spectroscopy and a Scanning calorimeter. The measurement results showed that Re impurities stabilized the h.c.p. phase up to 550˚C and that the Co (Re,P) film efficiently blocked Cu diffusion under an annealing temperature of 400˚C for 1hr. The good barrier properties that were observed can be explained by the nano-sized grains along with the blocking effect of the impurities at the fast diffusion path of the grain boundaries. The transformation temperature from the amorphous to crystal structure is increased by doping the Re.

Through the electrostatic interaction between the poly-diallydimethylammonium chloride (PDDA) modified Multi-walled carbon nanotube (MWNT) and SnO2 suspension in 1mM NaNo3 solution, MWNT-SnO2 nanocomposites (MSC) for anode electrodes of a Li-ion battery were successfully fabricated by colloidal heterocoagulation method. TEM observation showed that most of the SnO2 nanoparticles were uniformly deposited on the outside surface of the MWNT. Galvanostatic charge/discharge cycling tests showed that MSC anodes exhibited higher specific capacities than bare MWNT and better cyclability than unsupported nano-SnO2 anodes. Also, after 20 cycles, the MSC anode fabricated by heterocoagulation method showed more stable cycle properties than the simply mixed MSC anode. These improved electrochemical properties are attributed to the MWNT, which adsorbs the mechanical stress induced from volume change and increasing electrical conductivity of the MSC anode, and suppresses the aggregation between the SnO2 nanoparticles.

Multi-walled carbon nanotube (MWNT)/SnO2 nano-composite (MSC) for the anode electrode of a Li-ion battery was prepared using a homogeneous precipitation method with SnCl2 precursors in the presence of MWNT. XRD results indicate that when annealed in Ar at 400˚C, Sn6O4(OH)4 was fully converted to SnO2 phases. TEM observations showed that most of the SnO2 nanoparticles were deposited directly on the outside surface of the MWNT. The electrochemical performance of the MSC electrode showed higher specific capacities than a MWNT and better cycleability than a nano-SnO2 electrode. The electrochemical performance of the MSC electrode improved because the MWNT in the MSC electrode absorbed the mechanical stress induced from a volume change during alloying and de-alloying reactions with lithium, leading to an increase in the electrical conductivity of the composite material.

켄터키 블루그래스의 종자배양에서 캘러스 형성 및 식물체 재분화 체계를 확립하기 위하여 배지조성 및 배양조건 등에 따른 배양효율의 차이를 'Kenblue'를 공시품종으로 사용하여 수행한 실험의 결과를 요약하면 다음과 같다. 성숙종자로부터 캘러스 유도를 위한 생장조절제로는 2 mg/L 2,4-D와 0.2 mg/L BAP 조합이 가장 효과적이었으며, 유도된 캘러스로부터 식물체 재분화를 위해서는 1 mg/L NAA와 5mg/L kinetin 조합이 가장 효과적

들잔디(Zoysia japonica Steud.)의 최적 조직 배양 조건을 확립하기 위하여 성숙종자로부터 최적 캘러스 유도 및 효율적인 식물체 재분화에 미치는 몇 가지 요인의 영향을 조사하였다. 성숙종자로부터 배발생 캘러스 유도율은 3mg/L 2,4-D가 첨가된 MS 배지에서 85%로 가장 높았으며 NAA 또는 IAA를 첨가한 처리구보다 높게 나타났다. 배발생 캘러스로부터 식물체 재분화는 0.1 mg/L 2,4-D와 5 mg/L BA가 첨가된 N6 배지

오차드그라스(Dactylis glomerata L.)의 치사온도를 결정하기 위하여, 국내 육성품종인 "장벌 102호"(Jangbeol 102) 품종을 시험재료로 하여 종자를 petri dish에서 발아시켜 작은 화분에 10 개체씩 이식, 생장실에서 4주간 재배하였다. , 및 에서 처리한 경우에는 60분간 처리했을 때에도 거의 식물체 손상이 없었다. 에서 30분간 이상 처리했을 때에는 잎 끝이 마르고 약간 시들었으나 식물체의 손상은 약한 편이었으며, 에서

알팔파 종자를 의 2,4-D를 첨가한 SH 배지에서 배양하여 캘러스를 유도하였으며, 캘러스를 SH 배지에 의 NAA와 의 kinetin을 첨가한 배지에서 28~30일간 배양하고, 의 2,4-D와 의 kinetin을 첨가한 배지에서 3~5일간 배양 후, 의 (와 의 proline을 첨가한 배지에서 21~25일간 배양하여 완전히 재분화된 식물체와 많은 수의 shoot를 얻었다. 알팔파의 재분화 과정에서 뿌리가 유도되는 효율을 높이기 위해, SH salt의