With the recent concern regarding cellulose enhancing radionuclide mobility upon its degradation to ISA, disposal of cellulosic wastes is being held off until the disposal safety is vindicated. Thus, a rational assessment should be conducted, applying an appropriate cellulose degradation model considering the disposal environment and cellulose degradation mechanisms. In this paper cellulose degradation mechanisms and the disposal environment are studied to propose the best-suitable cellulose degradation model for the domestic 1st phase repository. For the cellulose to readily degrade, the pH should be greater than 12.5. As in the case of SKB, 1BLA is excluded from the safety assessment because the pH of 1BLA remains below 12.5. Furthermore, despite cellulose degradation occurring, it does not always produce ISA. At low Ca2+ concentration, the ISA yield rate is around 25%, but at high Ca2+ concentration, the ISA yield rate increases up to 90%. Thus, for the cellulose to be a major concern, both pH and Ca2+ concentration conditions must be satisfied. To satisfy both conditions, the cement hydration must be in 2nd phase, when the porewater pH remains around 12.5 and a significant amount of Ca2+ ion is leaching out from the cement. However, according to the safety evaluation and domestic research, 2nd phase of cement hydration for silo concrete would achieve a pH of around 12.4, dissatisfying cellulose degradation condition like in 1BLA. Thus, cellulose degradation would be unlikely to occur in the domestic 1st phase repository. To derive waste acceptance criteria, a quantitative evaluation should be conducted, conservatively assuming cellulose is degraded. To conduct a safety evaluation, an appropriate degradation model should be applied to determine the degradation rate of cellulose. According to overseas research, despite the mid-chain scission being yet to be seen in the experiments, the degradation model considering mid-chain scission is applied, resulting in an almost 100% degradation rate. The model is selected because the repositories are backfilled with cement, achieving a pH greater than 13, so extensive degradation is reasonably conservative. However, under the domestic disposal condition, where cellulose degradation is unlikely to occur, applying such model would be excessively conservative. Thus, the peeling and stopping model derived by Van Loon and Haas, which suggests 10~25% degradation rate, is reasonably conservative. Based on this model, cellulose would not be a major concern in the domestic 1st phase repository. In the future, this study could be used as fundamental data for planning waste acceptance criteria.

Concerns with colloids, dispersed 1~1,000 nm particles, in the LILW repository are being raised due to their potential to enhance radionuclide release. Due to their large surface areas, radionuclides may sorb onto mobile colloids, and drift along with the colloidal transport, instead of being sorbed onto immobile surfaces. To prevent adverse implications on the safety of the repository, the colloidal impact must be evaluated. In this paper, colloid analysis done by SKB is studied, and factors to be considered for the safety assessment of colloids are analyzed. First, the colloid generation mechanism should be analyzed. In a cementitious repository, due to a highly alkaline environment, colloid formation from wastes may be promoted by the decomposition of organic materials, dissolution of inorganic materials, and corrosion of metals. Radiolysis is excluded when radionuclide inventory is moderate, as in the case of SKB. Second, colloid stability should be evaluated to determine whether colloids remain in dispersion. Stable colloids acquire electric charges, allowing particles to continuously repel one another to prevent coagulation. Thus, stability depends on the pH and ionic condition of the surroundings, and colloid composition. For instance, under a highly alkaline cementitious environment, colloids tend to be negatively charged, repelling each other, but Ca2+ ion from cement, acting as a coagulant, makes colloid unstable, promoting sedimentation. As in the case of SKB, the colloidal impact is assumed negligible in the silo, BMA, and BTF due to their extensive cement contents, but for BLA, with relatively less cement source, the colloidal impact is a potential concern. Third, colloid mobility should be assessed to appraise radionuclide release via colloid transport. The mobility depends on the density and size of colloids, and flow velocity to commence motion. As a part of the assessment, the filtration effect should also be included, which depends on pore size and structure. As in the case of SKB, due to static hydraulic conditions and engineering barriers, acting as efficient filters, colloidal transport is expected to be unlikely. In the domestic underground repository, the highly alkaline environment would lead to colloid formation, but due to high Ca2+ concentration and low flow velocity, colloids would achieve low stability and mobility, thus colloidal impact would be a minor concern. In the future, with further detailed analysis of each factor, waste composition, and disposal condition, reliable data for safety evaluation could be generated to be used as fundamental data for planning waste acceptance criteria.

Once systems, structures and components (SSCs) of dry storage systems are classified with respect to safety function or safety significance (i.e., safety classification), appropriate engineering rules can be applied to ensure that they are designed, manufactured, maintained, managed (e.g. aging management) etc. In Unites States, the systems, structures and components (SSCs) consisting DSSs are classified into two or several grades (i.e., class A, B and C or not important to safety, and important to safety (ITS) or not important to safety (NITS)) with respect to intended safety function and safety significance. This classification methods were based on Regulatory Guide 7.10 (i.e., guidance for use in developing quality assurance programs for packaging). Also, in Korea, SSCs of DSSs should be classified into ITS and NITS in much the same as method based on Regulatory Guide 7.10. In that guidance, for providing graded approach to manage the SSCs of packaging, they were trying to classifying SSCs in accordance with radiological consequences. But there was limitations that the provided classification criteria was still qualitative, so that it was not enough for managing the SSCs according to graded approach. On the other hand, in some other nuclear facilities (i.e., nuclear power plant, radioactive waste management facility and disposal facility etc.), quantitative criteria relevant to radiological consequence (i.e., radiation doses to workers or to the public) or inventory of radioactivity are existed so that it can be applied for classifying safety classes. In summary, the study on the application safety classification that applied quantitative criteria to perform safety classification of SSCs in DSS is inadequate or insufficient. The purpose of this study is proposing the preliminary framework for estimating safety significance of SSCs in DSS which can be utilized in our further advanced studies. In this study, a framework was established to estimate the safety significance of SSCs related to radiation shielding and confinement using MCNP® 6.2 and Microsoft Excel. Referring to the methodology of IAEA Specific Safety Guide 30, we assumed severity for failures of components that could lead to degradation of the SSC’s performance. The safety class of SSC was decided based on the impact of SSC’s failure on consequences.

This study examined the subacute oral toxicity of Dendropanax morbiferus H.Lév leaves hot-water extracts (DMWE) using male and female Spargue-Dawley rats. Rats were orally administered the DMWE at dose levels of 0, 250, 500, 1,000, and 2,000 mg/kg body weight (BW) for four weeks. For experimental period, clinical signs and the number of deaths were examined, and feed intake and BW of all experimental animals were measured once a week for four weeks. At the end of the experiment, blood samples were collected from all rats, and all animals were euthanized and autopsies were performed to collect major organs. No dead animals were found during the experimental period. In addition, no differences were found between control and DMWE-treated groups in feed intakes, BW changes, organ weights, clinical signs, hematological parameters, and serum biochemical parameters. The results of this study provided evidence that oral administration of DMWE at the dose of 2,000 mg/kg BW is safe in rats and may not exert severe toxic effects.

In this study, the acute toxicity of Dendropanax morbiferus H.Lév leaf hot-water extracts (DMWE) was examined in male and female ICR mice. Mice were orally administered the DMWE at dose levels of 0, 250, 500, 1,000 and 2,000 mg/kg body weight (BW) for single-dose toxicity test. There were no significant differences in change of BW between control and all DMWE treated-groups. In hematological and blood biochemical analysis, none of the parameters were affected by the DMWE. Similarly, there were no significant effects on markers for liver and kidney functions in all DMWE treated-groups. Since there were no adverse effects of the DMWE in single oral toxicity tests, even at the highest doses, it was concluded that the lethal dose 50 (LD50) of DMWE is estimated at > 2,000 mg/kg BW.

국립원예특작과학원에서 2016년 거베라 신품종 ‘샤이핑크 (Shy Pink)’를 육성하였다. ‘Shy Pink’는 2008년 10월부터 2008년 11월까지 녹색 화심의 분홍색 반겹꽃 ‘프리존’과 갈 색 화심의 살구색 반겹꽃 ‘아틸리아’를 교배하여 획득한 실생 72개체 중에서 2009년부터 2016년까지 생육 및 개화특성검 정을 거쳐 선발한 절화용 대륜 거베라 품종이다. ‘샤이핑크 (Shy Pink)’는 화형이 안정적인 갈색 화심의 연분홍색(RHS R49A) 반겹꽃 대륜계 품종이다. 꽃은 평균 직경이 12.4cm이 고, 내부설상화와 화반의 직경은 각각 7.2cm와 2.3cm이다. 외부설상화의 길이와 폭은 각각 6.0cm와 1.2cm로 꽃잎이 좁은 도란형이다. 꽃대 직경은 상부 6.1mm, 중부 7.0mm 정 도로 강건하며, 꽃대의 길이는 48.9cm이다. 절화수명은 12.1 일로 대조구인 ‘하모니(Harmony)’ 12.0일로 유사하였지만 절 화수명이 길며, 연간 채화량은 52.8본/주로 다수성 품종이다.

Emotional labor, characterized by a dysfunctional type of emotional regulation called surface acting, has detrimental psychological consequences on employees, including depression and social anxiety. Because such disorders exhibit psychological characteristics manifested through brain activation, previous studies have succeeded in distinguishing individuals with depression and social anxiety from healthy controls using their functional connectivity characteristics. However, it has not been established whether the functional connectivity characteristics associated with emotional labor are distinguishable. Thus, we obtained resting-state fMRI data from participants in the emotion labor (EL) group and control (CTRL) group, and we subjected their whole-brain functional connectivity matrices to a linear support vector machine classifier. Our analysis revealed that the EL and CTRL groups could be successfully distinguished on the basis of individuals' connectivity patterns, and confidence in the classification was correlated with the scores on the depression and social anxiety scales. These results are expected to provide insight on the neurobiological characteristics of emotional labor and enable the sorting of employees undergoing adverse emotional labor utilizing neurobiological observations.

본 연구의 목적은 어머니의 주중 미디어 놀이 횟수가 유아의 놀이상호작용에 미치는 영향에서 자기통제와 주의집중문제의 매개역할을 살펴보는 것이다. 이를 위해 육아정책연구소의 한국아동패널 7차년도 데이터를 사용했고, 자료는 R 4.1.3과 PROCESS macro v4.1 for R로 분석했다. 본 연구의 결과는 다음과 같다. 첫째, 어 머니의 주중 미디어 놀이 횟수는 유아의 자기통제에 부적 영향, 주의집중문제에 정적 영향을 미쳤다. 또래 놀이상호작용에 대해 자기통제는 정적 영향, 주의집중문제는 부적 영향을 미쳤다. 자기통제는 주의집중문제 에 부적 영향을 미쳤다. 둘째, 어머니의 주중 미디어 놀이 횟수가 유아의 또래놀이상호작용에 미치는 영향 에서 자기통제와 주의집중문제는 각각 부적 매개효과가 나타났다. 마지막으로 어머니의 주중 미디어 놀이 횟수가 유아의 또래놀이상호작용에 미치는 영향에서 자기통제와 주의집중문제는 부적 직렬다중매개효과가 있었다. 본 연구의 결과는 유아의 자기통제와 주의집중문제가 어머니의 주중 미디어 놀이 횟수와 또래놀이 상호작용을 매개하는 주요한 요인임을 시사한다.