Skeletonema pseudocostatum의 세포는 규산질 성분의 돌기에 의한 사슬 형태로, 길이는 6~17.3 μm였고, 엽록체는 세포 당 1~2개를 포함하고 있었다. 주사전자현미경 관찰결과 Skeletonema 종을 구분할 수 있는 가장자리 받침돌기끝 (terminal fultoportula process)은 끝이 갈라지거나, 갈고리 모양이었고, 길이가 1.67±0.5 μm이고, 개각의 가장자리에 위치해 있으며, 개수는 8.10±1.1개로 개각의 크기에 따라 다양하게 나타났다. 말단세포 입술돌기 (terminal rimoportula process)는 두꺼운 원통형의 나팔관 모양으로, 개각의 중앙 근처에 위치하였고, 길이는 1.1±0.6 μm 였으며, 개수는 1개였다. 연결세포 받침돌기 (intercalary fultoportula process)는 대부분 1 : 1 결합으로 서로 맞물려있는 형태였고, 1 : 2 결합도 종종 발견되었다. 계통분석 결과는 형태적 특징이 유사한 종 간의 유전학적 거리가 가깝다는 것을 나타냈고, 지리적 기원이 다른 동일 종의 경우, 유전적 차이를 보이지 않았다. 이는 S. pseudocostatum은 지리적 위치와 상관없이 유전적 차이가 나타나지 않는 단일계통 (monophyly)이라는 것을 의미한다.

In this paper, we report graphene composite membranes prepared by transfer of a layer of chemical vapor deposition graphene onto porous anodic alumina (AA) substrates with nominal pore size 20 and 30 nm, referred as 20AA and 30AA. The coated and uncoated substrates were characterized using optical and electron microscopy techniques. The bare substrates exhibited a smooth surfaces with a well-organized array of hexagonal pores, displaying an average pore size of 17 ± 3 (20AA) and 23 ± 3 nm (30AA). The scanning electron microscopy and atomic force microscopy analyses confirmed the successful transfer of graphene layer onto the target substrates. The molecular transport study was performed by introducing 0.5 M potassium chloride (KCl) and deionized water in a Side-bi-Side Franz diffusion cell. The graphene/20AA specimen blocked 66% ions transport, and graphene/30AA membrane about 64%. The ions blockage exceeded 90%, near the characteristics of defectfree graphene when the defects of the transferred graphene were sealed with Nylon 6,6. The results of this study suggest the potential use of graphene on AA substrates for water desalination and gas purification applications.

Brucellosis is the most common zoonosis worldwide, which is caused by Brucella spp. In humans, it can be mainly occurred by direct contact with infected animals or consumption of contaminated dairy products. This study focused on human brucellosis caused by B. melitensis discovered from Chinese worker in Korea in 2015. We investigated molecular epidemiological evidence to find the infection source. We first performed several PCR methods including 16S rRNA PCR, multiplex PCR and real-time PCR to identify Brucella species. We also conducted MLVA typing for epidemiological trace-back analysis. The isolate from the patient was confirmed to B. melitensis through Brucella-specific PCR. In clustering analysis with B. melitensis from foreign countries, this human isolate was correlated with B. melitensis isolates from humans and sheep in China by 99.9% similarity. Thus, we assumed the brucellosis patient has been already infected in China followed by migration to Korea according to molecular epidemiological analysis with history evidence. Moreover, we suggest it needs to take measures to reduce the risk for intercountry transmission of brucellosis due to the influx of infected people from abroad.

A zinc-air battery is one of most promising advanced batteries due to its high specific energy density, low cost, and environmental friendliness. However, zinc anodes in zinc-air batteries lead to several issues including self-discharge, corrosion reaction, and hydrogen evolution reaction (HER). In this paper, viscosity of electrolyte has been controlled to suppress the corrosion reaction, HER, and self-discharge behavior. Various viscosity average molecular weights of poly(acrylic acid) (PAA) are adopted to prepare the electrolyte. The evaporation of electrolytes is proportional to the increase in molecular weight. In addition, enhanced self-discharge behavior is obtained when the gelling agent with high molecular weight is used. In addition, the zinc-air cell assembled with lower viscosity average molecular weight of PAA (Mv ~ 450,000) delivers 510.85 mAh/g and 489.30 mAh/g of discharge capacity without storage and with 6 hr storage, respectively. Also, highest capacity retention (95.78 %) is obtained among studied materials.

We found ten species of larvae belonging to the family Pleuronectidae as a result of analysis on ichthyoplankton collected monthly from the East Sea, Yellow Sea, Korea Strait and East China Sea between February 2016 and May 2018 using bongo net. The ten species of pleuronectid larvae were divided into three groups in morphology. Group A had three or four bars on the lateral side of the tail: Glyptocephalus stelleri, G. kitaharae, Pseudopleuronectes yokohamae, and Hippoglossoides dubius. Group B had a row of melanophores along the dorsal and ventral side of tail: Cleisthenes pinetorum, Eopsetta grigorjewi, Dexistes rikuzenius, and Platichthys bicoloratus. Group C had dense melanophores which are covering trunk and tail entirely except caudal peduncle: Platichthys cornutus and Platichthys japonicus. The three groups did not associate with previous molecular phylogenetic studies except for the G. stelleri and G. kitaharae of the group A.

In this study, we investigate the effect of Al/N source ratios and growth rates on the growth and structural properties of AlN films on c-plane sapphires by plasma-assisted molecular beam epitaxy. Both growth rates and Al/N ratios affect crystal qualities of AlN films. The full width at half maximum (FWHM) values of (1015) X-ray rocking curves (XRCs) change from 0.22 to 0.31° with changing of the Al/N ratios, but the curves of (0002) XRCs change from 0.04 to 0.45° with changing of the Al/N ratios. This means that structural deformation due to dislocations is slightly affected by the Al/N ratio in the (1015) XRCs but affected strongly for the (0002) XRCs. From the viewpoint of growth rate, the AlN films with high growth rate (HGR) show better crystal quality than the low growth rate (LGR) films overall, as shown by the FWHM values of the (0002) and (1015) XRCs. Based on cross-sectional transmission electron microscope observation, the HGR sample with an Al/N ratio of 3.1 shows more edge dislocations than there are screw and mixed dislocations in the LGR sample with Al/N ratio of 3.5.