바이오디젤은 중립연료로써 친환경 연료로 알려져 있으며, 육상에서는 일정 비율을 의무 혼합하는 정책을 시행하고 있다. 본 연구에서는 바이오디젤의 선박 연료로써의 사용 가능성을 검증하기 위해 선박용 경유와 바이오디젤의 혼합비율 0 %, 5 %, 10 %, 20 %에 대해 성분 분석, 금속 부식성 실험, 저장 안정성 실험을 수행하였다. 성분 분석은 ISO 8217:2017 기준에 따라 밀도, 동점도, 인화점 등 총 8가지를 평가하였으며, 180일 동안 상온과 가혹 조건(60 ℃)에서 금속 부식성 실험과 저장 안정성 실험을 통해 바이오디젤 신뢰성을 검증 하였다. 연구 결과, 성분 분석은 바이오디젤 모든 혼합비율에서 ISO 8217:2017 기준을 만족하였으며, 바이오디젤 비율에 따라 동점도, 밀 도, 산값은 혼합비율이 높아질수록 높게 나타났으며, 황분은 혼합비율이 높아질수록 낮게 나타났다. 금속 부식성은 탄소강, 철, 알루미늄, 니켈의 경우 부식이 거의 발생하지 않았으나, 구리의 경우 60 ℃ 환경 바이오디젤 20 % 혼합에서 산소가 풍부한 바이오디젤의 영향으로 부식이 발생하였다. 저장 안정성은 모든 바이오디젤 혼합비율을 180일 동안 상온과 가혹 조건에서 저장한 결과, 변색, 슬러지 발생, 연료 분리가 육안으로 확인되지 않았다.

Diesel engine has the advantages of strong power, low fuel consumption and good durability, so it has been widely used in transportation, automobile, ship and other fields. However, the nitrogen oxides(NOx) and particulate matter(PM) emitted by diesel engines have become one of the main causes of air pollution. Especially during idling, the engine temperature is low, and there are more residual exhaust gases in the combustion chamber, resulting in the formation of more harmful emissions. In this study, performance of a single cylinder, four-stroke, direct injection (DI) diesel engine fueled with diesel–biodiesel mixtures has been experimentally investigated. The findings show that a remarkable improvement in PM–NOx trade-off can be achieved by burning diesel-bioethanol blend fuels.

Diesel engine has the advantages of strong power, low fuel consumption and good durability, so it has been widely used in transportation, automobile, ship and other fields. However, the nitrogen oxides(NOx) and particulate matter(PM) emitted by diesel engines have become one of the main causes of air pollution. Especially during idling, the engine temperature is low, and there are more residual exhaust gases in the combustion chamber, resulting in the formation of more harmful emissions. In this study, performance of a single cylinder, four-stroke, direct injection (DI) diesel engine fueled with diesel–biodiesel mixtures has been experimentally investigated.

In this study, the effects of fuel injection pressure changed from 45 to 65 MPa on combustion and emission characteristics were investigated in a common rail direct injection (CRDI) diesel engine fueled with diesel and palm oil biodiesel blends. The engine speed and engine load were controlled at constant 1700rpm and 100Nm, respectively. The tested fuel were PBD20 (20 vol.% palm oil biodiesel blended with 80 vol.% diesel fuel). The main and pilot injection timing was fixed at 3.5°CA BTDC and 27°CA BTDC (before top dead center), respectively. The experimental results show that the combustion pressure and heat release rate increased. In addition, the indicated mean effective pressure (IMEP) and maximum combustion pressure increased with an increase of the fuel injection pressure. Hydrocarbon (HC), smoke opacity and carbon monoxide (CO) decreased, but oxides of nitrogen (NOx) emissions increased as fuel injection pressure increased.

These days, our environmental pollution has been greatly threatened by various exhaust emissions from diesel engines for transportation, and there is a tendency that regulations on this are very strengthened. In this study, when biodiesel and water-cooled EGR are simultaneously applied to common rail diesel engines, which occupy most of passenger diesel engines, the characteristics of exhaust smoke and NOx were investigated. As a result of this experiment, as a result of applying less than 10% EGR to 5% biodiesel mixed fuel, it was found that smoke and NOx emissions can be simultaneously reduced.

In recent years, our reality is facing a serious risk of air pollution from transport vehicles. In particular, various exhaust emissions from diesel engines are pointed out as a serious cause of environmental pollution. This study attempted to study the potential of biodiesel as an alternative energy for CRDI diesel engines. When biodiesel 30% was applied, the smoke emission was reduced by 40% at 4000rpm compared to diesel. On the other hand, there was no significant difference in output, torque, and energy consumption. However, NOx emissions tended to increase compared to diesel. The applicability of biodiesel to CRDI diesel engines has been demonstrated for the characteristics of output and smoke emissions.

In this study, the spray characteristics of blending fuel with diesel fuel and high viscosity biodiesel fuel was investigated. The research was performed for the effect on biodiesel fuel blending ratio and injection pressure for the spray behavior. The experimental process of spray injection was analyzed with LDPAlaser diffraction particle analyzer). In addition, spray atomization characteristics were researched with SMD(Sauter mean diameter) and droplet distribution on various injection pressure conditions. Fuel containing high viscosity biodiesel fuel has some different spray behaviors on account of the viscosity and surface tension. Though this experimental result, we found that the increase of injection pressure enables SMD to get smaller, but the increase of blending ratio makes SMD larger.

The potential for biodiesel to replace diesel has been explored as an alternative fuel for naturally aspirated indirect injection diesel engines. Overall biodiesel smoke emissions were significantly reduced compared to diesel fuel, which was approximately 36% lower at 2000 rpm, peak load conditions. And torque, power and brake energy consumption did not show much difference. However, compared to diesel fuel, NOx emissions from biodiesel have increased. To combat this problem, an EGR(exhaust gas recirculation) method has been applied to reduce NOx emissions. It was confirmed that simultaneous reduction of NOx and smoke was confirmed by cooling EGR method(10~15%) and biodiesel(20 vol%).

In this study, we investigated the effects of diesel-palm oil biodiesel-ethanol blends on combustion and emission characteristics in a 4-cylinder common rail direct injection (CRDI) diesel engine at low idling operations. The engine speed and engine load was 750 rpm and 40 Nm, while the main and pilot injection timing was respectively fixed at 2 °CA before top dead center (BTDC) and 20 °CA BTDC. The experimental results showed that the cylinder pressure increased with the increasing of palm oil biodiesel ratio from 20% to 100%. In addition, the peak value of cylinder pressure increased by 4.35% compared with pure diesel fuel when 5 vol.% ethanol oil added to diesel oil. Because the palm oil biodiesel and ethanol are the oxygenated fuel, the oxygen content played an important role in improving combustion. Based on the high oxygen content of biodiesel and ethanol, their mixing with diesel fuel effectively reduced PM emissions but increased NOx slightly, while CO and HC had no significant changes.

바이오디젤은 신재생연료이면서 환경 친화적인 수송용 액상 바이오연료이다. 곤충은 새로운 바이오디젤 원료로 여겨지고 있다. 특히, 동애등에는 높은 지질을 함유하고 있어 재생가능한 바이오디젤 원료이다. 동애등에 유래 바이오디젤은 포화지방산 함량이 높고 다불포화지방산 함량이 낮아 품질이 좋은 바 이오디젤을 만들 수 있다. 동애등에 유래 바이오디젤은 EN 14214의 대부분 품질기준을 만족한다. 동애등에는 기존의 식물성 원료, 미세조류에 비해 지질 수율이 높아 바이오디젤 생산성이 높다. 본 논문에서는 곤충 유래 바이오디젤의 전반적인 생산 방법과 품질 특성에 대해 서술하였다.

한국과 인도네시아를 포함한 대부분의 국가는 온실가스 감축을 위해 바이오디젤 같은 바이오연료 보급에 대한 강력한 정책을 추진하고 있다. 하지만, 바이오디젤 보급 확대를 위해서는 원료 부족 문제를 먼저 해결해야 한다. 본 연구에서는 원료 공급 안정성을 개선하고 바이오디젤 생산 가격을 낮추기 위해 비식용이면서 동시에 단위면적당 생산성이 높은 인도네시아 열대작물(R. Trisperma) 오일의 바이오디젤 생산 가능성을 조사하였다. 수확기간이 다른 두 종류의 오일은 많은 불순물과 높은 유리지방산 함량을 가지고 있어 효율적인 바이오디젤 생산을 위해, 에스테르화 반응과 전이에스테르화 반응을 실시하였다. 오일은 반응을 진행하기 앞서 여과와 수분제거 과정을 통해 반응의 효율을 높이고자 하였다. 에스테르화 반응은 불균질계 산 촉매인 Amberlyst-15를 사용하였으며, 반응 전 오일들의 산가는 각각 41, 17 mg KOH / g 이었으나, 에스테르화 반응 후 3.7, 1.8 mg KOH/g으로 약 90% 이상의 전환율을 보이며 유리지방산 함량 을 2%이하로 감소시켰다. 이후 전이에스테르화 반응은 KOH를 염기 촉매로 사용하여 바이오디젤 합성 실험을 진행하였다. 생성된 바이오디젤은 약 93%의 FAME 함량을 나타냈으며, 총 글리세롤의 함량은 0.43%으로 제품 규격(FAME 96.5%, 총 글리세롤 0.24%)에는 미달되었다. 이는 지방산 조성 분석 결과 일반적으로 관찰되지 않는 특이 지방산인 α-Eleostearic acid가 10.7~33.4% 포함되어 나타나는 특성으로 판단되며, 추가 반응 최적화 및 분리정제 연구 진행으로 연료품질 규격 달성이 필요한 것으로 나타났다. 기존에 활용되지 못하던 비식용 원료로부터 바이오디젤 생산 기술을 확보할 경우 바이오디젤 보급 확대를 위한 안정적 원료 공급에 기여할 것으로 판단된다.

Biodiesel is a remarkable alternative fuel for the diesel engine among various countries. Various studies are carried out on the environmental and economic effects as well as the nature of diesel engine fuel biodiesel in the combustion process and emission characteristics. In this study, CRDI diesel engines used diesel fuel and 20 % biodiesel blend fuel (BD 20 %) as fuel, with City-mode exceeding 300 hours. Engine performance and emissions were sampled at one-hour intervals for analysis. The engine was inspected after testing to check the engine parts (valves and injectors). It was concluded that 300 hours of operation using BD 20 % does not cause abnormal deterioration of the engine or abnormal changes in engine power and exhaust gas.