본 연구는 도로시설물의 염화칼슘 제거를 위한 미세기포 세척장비의 최적 운용조건에 대하여 성능평가를 수행하였다. 실험에 사용된 미세기포의 직경은 196.6±100.6nm 에 1.36×108개/ml의 농도를 나타낸다. 세척장비의 분사장치에 대한 실험 성능결과, 100bar의 분사압력에서 100cm, 150cm 분사거리에 약 93%, 91%의 세척효율이 나타나는 것으로 확인되었다. 미세기포 생성(순환)횟수를 2-6회로 증가시킴에 따라 최소 1%에서 7%까지 염화물 제거율이 높아짐을 확인하였다. 미세기포 생성 공기유량을 4 ml/min에서 0.5 ml/min으로 낮춤에 따라 세척효율이 최대 30%까지 증가하는 것이 확인되었다. 일반 상수도와 미세기포의 세척효율은 미세기포가 일반상수도 보다 세척효율이 25% 높게 나타났다.

본 연구는 3개의 운전변수(압력, 공기량, 운전시간)를 실험 설계하고 마이크로 버블의 종말부상 속도(Terminal rise velocity)를 반응 값으로 하여 예측식 모델과 최적 조건을 수립하였다. 다항식 회귀분석을 통해 펌프의 압력(X1) 4.5bar, 공기량(X2) 3.3L/min 그리고 운전시간(X3)이 2.2min에서 종말상승속도(Terminal rise velocity)에 대한 최적값인 5.14 cm/min (85.7㎛/sec)을 얻었다. 또한, 레이저 입자계수 측정장치를 이용하여 2~5㎛ 및 25~50㎛ 영역에서의 가장 높은 마이크로버블 직경크기 분포를 확인하였다.

하수방류수 재이용을 위한 RO 전처리로 부유물질 및 콜로이드 물질의 제거를 위해 가압식 MF를 사용하였다. 남양주 J 하수처리장의 생물학적 처리와 모래여과를 거쳐 방류되는 방류수를 원수로 사용하였으며 100 톤/일 규모의 pilot plant를 1년 이상 운전하여 성능을 검토하였다. 가압식 MF에 의해 원수 수질 및 온도의 변화에 상관없이 flux 40 LMH 운전이 가능하였으며 전처리로 응집제를 넣어 용존 유기물을 응집할 경우 60 LMH 운전이 가능하였다. RO 공정에서 장기간 정지 이후 운전을 재개하였을 때 1단 pressure drop이 급격히 증가하는 현상이 나타났고 이러한 결과는 배관 내 형성된 유기물과 이온물질의 복합오염물질이 1단 RO막에 침적된 결과로 사료된다.

In an effort to find the optimum porous of Taewoo through the mathematical model 2 - dimensional tank water experiment among the approached to a problem related to ocean engineering, this study analyzed the porosity by dividing it into 9 cases. As the wave penetrates through the longitudinal porous of the Taewoo model, it was found that there is a wave energy loss because of the phenomenon of the separation of the porous due to the eddy. Looking into the general tendency based on the wave-height meter (probe) data, it was found that the shorter wavelength and higher frequency area, the more reflection coefficients increased, but in contrast, the longer wavelength and lower frequency area, the transmission coefficients showed the increasing trend and energy dissipation was in a similar way with reflection coefficients. In addition, it was found that the bigger the porosity was, the narrower distribution range of reflection coefficients was, and the more its average value decreased. On the other hand the transmission coefficients in direct opposition to reflection was found to show the wider range and the more gradual increase in the average value as porosity was the bigger around the average value. In contrast, energy dissipation rate was found to increase linearly as porosity increased the more around the porosity of 0.2518 but it decreased gradually around the peak point. Through the above results, it is judged that the porous of optimum in the longitudinal direction of the Taewoo model perforated plate was about 2.6cm because it was found that the porosity which produced the lowest reflection and transmission coefficient and the highest energy dissipation. As a result of comparing this to the case where there was no porosity at all, it showed the function of wave absorbing about 31.60%.

MBR 기술은 지난 20여 년 동안 처리성능과 효율성 그리고 비용절감 측면에서 빠른 속도로 발전하고 있다. 또한 안정적인 하수처리와 하수재이용관점에서 핵심기술로 널리 인식되고 있다. 본고에서는 MBR 기술의 개발과 상업적 응용에 관한 발전과정을 재조명하고 세계 시장의 전망을 제시하고자 한다. 주요 적용기술에 대해 다음 5가지 측면에서 검토하여 제시하였는데 1) MBR 기술의 진화, 2) MRBs의 상업용 기술, 3) 대용량 MBR 플랜트 설치 사례, 4) MBR 시장의 성장, 5) 기술의 발전방향 순으로 제시하였다. 마지막으로 MBRs에 대한 경제적, 환경적, 그리고 기술적 측면에서 향후 발전방향을 1) 초기투자비, 2) 처리 수질, 3) 분리막 소재/모듈, 4) MBR 장비와 공정, 5) 운영비용, 향후 6) 혐기성 MBRs 공정과 같은 차세대 기술 분야로 나누어 제시하였다.

This paper established the analytical model of sea surface oscilation of simple type fishing port with vertical wave absorbor. This model is composed by MAEM(Matched Asymptotic Expansion Method) for wave amplification in fishing port and EEM(Eigen - function Expansion Method) for wave absorbing characteristics against vertical perforated plates. Dimensionless porosity by adopting Darcy's law was introduced to evaluate wave absorbing characteristics of the perforated structure. Using the model, the efficiency of the vertical perforated plates was studied for fishing port tranqulity with number of plates, array method and plate intervals. Optimal design and arrangement of perforated plates can be applied to develop multipurpose fishing ports and villages.

Heavy metal concentrations in the soil were investigated for the abandoned Samkwang metal mine, Cheongyang-Gun, Chungnam Province, Korea. The concentrations of heavy metal(As, Cd, Cu, Ni, Pb, Zn) were determined in mine soils collected at the abandoned mine sites to obtain a general classification and specification of the pollution in this highly polluted region. The results estimated with the normal test and basis statistic on the central tendency and variation showed that the distribution of heavy metal concentration had significantly different at the range of all locations. The range of spatial distribution on the relationship of heavy metal concentration and pH was 4.8∼8.8 and heavy metal concentration on the type of land use was highest in forest land, and also Ni and Zn in farm and rice field showed the high concentration. The distribution of heavy metal concentration on the depth of a soil showed that the metal concentrations in subsoil were higher than of those in surface soil, while the concentration of Cu and Ni had no significant difference on the depth of soil. Results from the correlation analysis using the data except the extreme and unusual data revel that Zn-Cd(r=0.867), Zn-As(r=0.797), Zn-Pb (r=0.764), Cu-Cd(r=0.673), Cu-As(r=0.614) and Zn-Ni(r=0.605) were the most important parameters in assessing variations of heavy metal in soil. To discriminate pattern differences and similarities among samples, principal factor analysis(PFA) and cluster analysis(CF) were performed using a correlation matrix. This study suggests that PFA and CF techniques are useful tools for identification of important heavy metal and parameters. This study presents the necessity and usefulness of multivariate statistical assessment of complex databases in order to get better information about the quality of soil and gives the basis information to clean up the abandoned mine sites.

This paper represents the statistical characteristics of sources and receptors for road traffic noise in apartment complex. Also we suggested that the site-specific characteristics of vertical and horizontal distributions in the complex apartment have been derived using a different analysis for evaluating levels of Leq1h by the apartment floor at a given distance from a road in terms of the flow rate, the mean speed of the traffic, and the percentage of the type vehicles in the day and night periods. As a result, the contribution orders of traffic quantity by the type of vehicles showed as followed: light vehicle>medium vehicle>heavy vehicle>motorcycle. Especially, the mixing ratio of entering the road on the heavy vehicle in the daytime was two times higher than that of in the night. The speed in all types of vehicle is in the range of 41 and 81 km/hr and noise level was not significantly different in day and night-time. The sources of road traffic noise had different variations and uncertainties using a random variable and probability distribution. The sound distribution to receptors by the apartment floor showed S curve between 1st floor and 15th floor With the normality test, the normal distributions using Anderson-Darling Test followed 1st, 3th, 13th and 15th floor in the daytime and all floors except 7th floor in the night (p>0.05). And also, the value of the pearson correlation coefficient (r) obtained in this study have significantly different at the range of floor. In conclusion, the results suggested that the distribution characteristics of levels of Leq1h on the sources and receptors of road traffic noise in apartment complex must be improved and developed on the guideline of regulation of road traffic noise.

Currently, the application of TiO2 photocatalyst has been focused on purification and treatment of wastewater. However, the use of conventional TiO2 slurry photocatalyst results in disadvantage of stirring during the reaction and of separation after the reaction. And the usage of artificial UV lamp has made the cost of photocatalyst treatment system high. Consequently, we studied that solar light/TiO2 film system was designed and developed in order to examine disinfection characteristics of sewage wastewater treatment. The optimum conditions for disinfection such as solar light intensity, characteristic of sewage wastewater, amounts of TiO2 and comparison of solar ligth/TiO2 systems with UV light/TiO2 system was examined. The results are as follows: (1) photocatalytic disinfection process with solar light in the presence of TiO2 film more effectively killed total coliform (TC) than solar light or TiO2 film absorption only. (2) The survival ratio of TC and residual ratio of organic material (BOD, CODcr) decreased with remain resistant material. (3) The survival ratio of TC and residual ratio of organic material (BOD, CODcr) decreased with the increase of amounts of TiO2. (4) TC survival ratio decreased linearly with increasing UV light intensity. (5) The disinfection effect of solar light/TiO2 slurry system decreased more than UV light/TiO2 film systems. (6) The disinfection reaction followed first-order kinetics. We suggest that solar light instead of using artificial UV light was conducted to investigate the applicability of alternative energy source in the disinfection of TC and the degradation of organic material.

This study make a comparison between the phosphorus removal performance of FNR(Ferrous Nutrient Removal) process and A/O process by the laboratory experiments. For simultaneous removal of phosphorus, iron electrolysis was combined with oxic tank. Iron precipitation reactor on the electrochemical behaviors of phosphorus in the iron bed. The phosphorus removal in FNR process was more than A/O process. Iron salts produced by iron electrolysis might help to remove COD and nitrogen. And the demanded longer SRT is the more removes the removes COD, nitrogen, and phosphorus. Also, FNR process of sludge quantity more reduce than A/O process to input cohesive agents.

Soil biofiltration is an environmentally-sound technology for elimination of VOCs, odorous and NOx compounds from a low concentration, high volume waste gas streams because of its simplicity and cost-effectiveness. This study was performed to evaluate effect of removal of gaseous NOx using a soil and a yellow soil. Over 60% and 48% of NOx from a soil and a yellow soil was removed at the inlet NO concentrations of 423~ 451ppb, respectively. The bio-filter using a soil media was capable of purifying NOx with a different natural processes. Although some of the processes are quite complex, they can broadly be summarized as adsorption into soil pore water, and biochemical transformations by soil bacteria. When the filteration bio-reactor was applied to a soil and a yellow soil, effective NOx removal was obtained for several times and months. These results show that a soil biofilter can be of use as an alternative advanced NOx treatment system.

In this paper we examine the mass transport within the boundary layer near the sea bottom. The fluid domain is seperated into inner and outer region of boundary layers. In outer region, the wave field is assumed to be inviscid and irrotational. When the incident waves enter the arrays of circular cylinders, the scattering of water waves by an array of N bottom mounted vertical circular cylinders is solved using the method proposed by Linton & Evans under the potential theory. In inner region, the Navier-Stokes equation must be satisfied with boundary conditions at the boundary later and bottom is to be represented by the sum of the Eulerian mean drift and the Stokes' drift.

Herein we investigate the mass transport velocity caused by the viscosity near the ocean structure such as circular pile and inclined breakwaters. The mass transport velocity which is represented by the sum of the Eulerian velocity and the stokes drift were derived by Carter, Liu and Mei(1973). The tangential components of the inviscid velocity field at the bottom needed in the calculation of the mass transport velocity is obtained by solving the scattering problem due to breakwaters. The matched asymptotic expansion technique is employed to obtain the inviscid flow fields scattered by inclined breakwaters. The numerical results show that heary sediments tends to be deposited near the center of breakwaters and that the narrowing of the entrance width results in reduction of the magnitude of mass transport.