This study aims to optimize the cochlea-inspired artificial filter bank (CAFB) using El-Centro seismic waveforms and test its performance through a shaking table test on a two-span bridge model. In the process of optimizing the CAFB, El-Centro seismic waveforms were used for the purpose of evaluating how they would affect the optimizing process. Next, the optimized CAFB was embedded in the developed wireless-based intelligent data acquisition (IDAQ) system to enable response measurement in real-time. For its performance evaluation to obtain a seismic response in real-time using the optimized CAFB, a two-span bridge (model structures) was installed in a large shaking table, and a seismic response experiment was carried out on it with El-Centro seismic waveforms. The CAFB optimized in this experiment was able to obtain the seismic response in real-time by compressing it using the embedded wireless-based IDAQ system while the obtained compressed signals were compared with the original signal (un-compressed signal). The results of the experiment showed that the compressed signals were superior to the raw signal in response performance, as well as in data compression effect. They also proved that the CAFB was able to compress response signals effectively in real-time even under seismic conditions. Therefore, this paper established that the CAFB optimized by being embedded in the wireless-based IDAQ system was an economical and efficient data compression sensing technology for measuring and monitoring the seismic response in real-time from structures based on the wireless sensor networks (WSNs).

The purpose of this study is to present theoretical and experimental evidence for a niche strategy for small and medium online shopping malls to run business against large famous shopping malls prevailing the E-commerce market. For this, the present study demonstrates how chronic construal levels of consumers may affect their alternative choice for online shopping via various contexts (Experiment 1-3) and categories (Experiment 3-5). This series of experiments suggests that consumers with high construal level can be defined as a group that is relatively less susceptible to reputation of the shopping malls. Thus, strategically targeting this group of consumers will help small and medium-sized online malls lacking store reputation to mitigate their competitive disadvantage. Based on both existing literature and the experimental results as above, this research discusses possible methods for small and medium-sized online shopping malls to target high-construal segmentation.

This study investigated the densification behavior of rhenium alloys including W-25 wt.%Re and Re-2W-1Ta (pure Re) during sintering. The dilatometry experiments were carried out to obtain the in-situ shrinkage in H2 atmo-sphere. The measured data was analyzed through shrinkage, strain rate and relative density, and then symmetricallytreated to construct the linearized form of master sintering curve (MSC) and MSC as a well-known and straightforwardapproach to describe the densification behavior during sintering. The densification behaviors for each material were ana-lyzed in many respects including apparent activation energy, densification parameter, and densification ratio. MSC witha minimal set of preliminary experiments can make the densification behavior to be characterized and predicted as wellas provide guideline to sinter cycle design. Considering the results of linearized form and MSC, it was confirmed thatthe W-25 wt.%Re compared to Pure Re is more easily densified at the relatively low temperature.

우유 또는 주스 종이용기를 재활용하여 화장지를 생산하고 있는 제지회사에서 배출되는 제지폐수를 대상으로 주기적 질소 역세척이 가능한 세라믹 정밀여과 시스템을 운전하였다. 제지폐수 재활용을 위해 본 연구에서 7개의 채널이 있는 2 종류의 알루미나 분리막이 사용되었다. 질소 역세척 시간을 40초, 막간압력차 1.0kgf/cm2, 역세척 압력 5.0kgf/cm2로 고정하였을 때 0.4mum의 평균기공 크기를 갖고 있는 HC04 알루미나 분리막의 최적 여과시간 간격은 4분으로 1.0mum의 평균기공인 HV10 분리막의 16분보다 짧았다. 여과시간 간격과 역세척 시간을 고정한 상태에서 막간압력차(TMP)의 영향을 살펴본 결과, 높은 TMP 조건에서는 쉽게 막표면에 케이크가 형성되고 막 내부 구조에도 막오염이 발생하기 때문에 낮은 TMP 조건이 막오염 제어에 유리한 것을 알 수 있었다. 그러나 TMP는 폐수처리 여과 시스템에서 구동력이기 때문에, 가장 높은 TMP 조건에서 가장 많은 총여과부피를 얻을 수 있었다. 한편, 다채널 세라믹 분리막을 사용한 정밀여과시스템에서 얻은 투과수는 탁도가 낮기 때문에 제지공정에서 재활용 될 수 있다.

본 연구에서는 4종류의 관형 세라믹 정밀 및 한외여과막(탄소 재질)으로 제지공장의 방류수를 물로 주기적 역세척하면서 여과하였을 때, 최적 역세척 시간을 규명하였다. 각 분리막에 대상으로 물 역세척 시간의 영향을 살펴 본 결과, 분리막의 기공이 클수록 길게 역세척 하는 것이 가장 많은 총여과부피, 즉 처리수의 회수 효율이 높기 때문에 가장 효과적이라 할 수 있다. 한편, 180분 동안 여과하면서 초기투과선속에 대한 투과선속의 변화를 살펴본 결과, 정상운전시간이 길수록 막오염이 많이 진행된 상태이므로 역세척 시간을 길게 해주여야만 막오염을 억제하여 높은 투과선속을 유지할 수 있다는 것을 알 수 있었다. 또한, 막오염의 저항 변화 추이를 관찰하여 최적 물역세척 시간을 규명해 보아도, 투과선속의 변화로부터 얻은 최적 역세척 시간과 거의 동일한 결과를 얻을 수 있었다.