This study was conducted to solve the problem of the existing odor management method taking a long time to analyze samples. Using real-time air quality measurement equipment, 17 designated odor substances were measured three times at a business site causing odor complaints. As a result, three substances, hydrogen sulfide, trimethylamine, and methyl mercaptan, were measured at higher levels than the site boundary emission standards inside the business site. In the case of trimethylamine, it was measured about 500 times higher than Odor Threshold Values, and was estimated to be the substance causing the odor. Through an inspection of the business site, improvements were instructed to be made to the wastewater treatment process, which is the emission facility where trimethylamine is generated. Subsequent measurement results showed that designated odor substances were measured within the emission standards at all locations, and it was determined that efficient management of odorgenerating businesses would be possible if Selected Ion Flow tube-Mass Spectrometry was utilized.

This study was conducted to verify the reliability of volatile organic compounds (VOCs) data derived from Selected Ion Flow Tube-Mass Spectrometers (SIFT-MS) measurements. In the previous study, the measurement reliability was validated using simultaneous measurements by SIFT-MS and gas chromatography-mass spectrometry (GS-MS), but in order to ensure more accuracy, and additional analysis was conducted by diluting standard gases (2 ppm) consisting of 10 types of VOCs mainly measured in industrial complexes (concentrations ranged from 0 to 500 ppb). As a result of 2 experiments, the SIFT-MS showed linearity and produced a coefficient of determination of over 0.99 for all cases. SIFT-MS has secured high measurement reliability, and it is considered to be able to efficiently manage VOCs emitted in industrial complexes.

The concentrations of odor and volatile organic compound (VOC)-inducing substances were measured using selected ion flow tube mass spectrometers (SIFT-MS). SIFT-MS can continuously measure the concentration of odor-causing substances and VOCs in real time without pre-treatment steps. Measurements were conducted during the day and at night at 10 spots in the chemical block of the Sihwa industrial complex. Similar measurement results were observed in the daytime and nighttime for materials except methyl ethyl ketone with high concentrations. A high concentration of hydrogen sulfide was also measured at night. It is expected that an amount of emissions of VOCs and odor-causing substances under the absence of inspection can be traced if measured at other industrial complexes in vulnerable times.

The concentrations of volatile organic compounds (VOCs) and odor-inducing substances were measured using selected ion flow tube mass spectrometers (SIFT-MS) and a drone equipped with an air quality monitoring system. SIFT-MS can continuously measure the concentration of VOCs and odor-inducing substances in realtime without any pre-treating steps for the sample. The vehicle with SIFT-MS was used for real-time measurement of VOC concentration at the site boundaries of pollution sources. It is possible to directly analyze VOCs concentration generated at the outlets by capturing air from the pollution sources with a drone. VOCs concentrations of nine spots from Banwol National Industrial Complex were measured by a vehicle equipped with SIFT-MS and were compared with the background concentration measured inside the Metropolitan Air Quality Management Office. In three out of the nine spots, the concentration of toluene, xylene, hydrogen sulfide, and methyl ethyl ketone was shown to be much higher than the background concentration. The VOCs concentrations obtained using drones for high-concentration suspected areas showed similar tendencies as those measured using the vehicle with SIFTMS at the site boundary. We showed that if both the drone and real-time air quality monitoring equipment are used to measure VOCs concentration, it is possible to identify the pollutant sources at the industrial complex quickly and efficiently check sites with high concentrations of VOCs.

중공사 MD 모듈은 DCMD(Direct Contact Membrane Distillation) 방식으로 운전하는 경우 효율저하가 발생하는 이유로 주로 VMD(Vacuum Membrane Distillation) 방식으로 운전되었다. DCMD의 경우 고장을 줄일 수 있으며, 진공 펌프와 TVC 등을 필요로 하지 않아 경제적으로 열효율을 높일 수 있다면 선호되는 방식이다. 열효율을 향상시키기 위한 기초적인 방법으로 멀티모듈의 다양한 배열을 고려하기 위한 모듈 분석을 선행하였다. 이전연구를 통해 개발한 중공사막을 이용하여 모듈을 CFD 분석을 하여 운전방식(내외압, 병류 및 향류)에 따라 온도 및 유량조건별로 분석하였다. 이후 최적 운전방식을 기반으로 열교환효율에 적합한 모듈 배치를 모의하였다. 본 연구는 국토교통부 플랜트연구개발사업의 연구비지원(과제번호 18IFIPC146666-01)에 의해 수행되었습니다.

It is not cost effective to raise the density of catch basins in preparation for heavy rainfall in terms of construction and maintenance. Our researchers have developed the new catch basin for increasing interception capacity of runoff with internal filtration structure. To compare interception capacity of an existing catch basin with the invented catch basin, a hydraulic experiment device with 4% of road gradients and 0.2% of road gradients was constructed. For runoff conditions of 4.4 l/s, 6.7 l/s and 10.4 l/s, capability of runoff and separation capability of debris (sand and leaves) were evaluated. As the main experimental results, the effectiveness of the developed catch basin has been verified with an increase in interception rate of approximately 22% for the runoff of 6.7 l/s as heavy rainfall. However, the results of invented catch basin showed only 4.5% of settlement rate of debris regarding sand. Therefore, the authors proposed an improved tilted screen structure additionally. After reviewing the performance of improved catch basin, application of the invented catch basin is expected to drain runoff effectively when it is applied to the faulty road drainage section.

The objective of this study is to investigate and evaluate that a roadside tree root intrudes sewer network systems. Two approaches were performed to assess the characteristics of tree root intrusion. First, the characteristics of tree roots that had invaded sewers were directly observed by means of closed-circuit television inspection robot. Second, the intrusion proportions of tree root into rain gutters in the sampling area were investigated. As tree species of low intrusion proportions, the results indicated that Ginkgo biloba Linn. and Acer buergerianum Miq. were 1.7% and 4.3%. On the other hand, tree species of high intrusion proportions were Metasequoia glyptostroboides Hu et Cheng, Ulmus davidiana var. japonica Nakai and Zelkova serrata Makino as 22.2%, 20.4%, and 17.6% respectively. In particular, sewers and gutters around Zelkova species should be the focus of maintenance work because of the high proportion of these trees on roadsides.

고분자물질의 사용으로 인한 건축 재료의 다변화에 따라 화재 시 발생되는 연소가스 또한 다양해지고 있다. 그중 HBr은 NES 713과 BS 6853, FTP Code Part 2에서 연소 가스의 독성 평가 시 측정되는 독성가스이다. 특히 산업안전물질보건자료(MSDS)에서는 HBr가스를 흡입할 경우 화상을 일으키며 호흡부전, 두통 등을 유발시킬 수 있고 50ppm의 HBr가스에 노출된 사람은 생명과 건강에 즉시 영향을 받을 수 있는 매우 유독한 연소가스이다. 본 논문에서는 HBr 표준가스에 노출된 동물의 운동성 측정실험인 가스유해성 시험 및 HBr가스에 노출된 마우스의 생물학적 검사 결과를 비교 분석하여 HBr의 연소 독성에 관한 연구를 수행하였다.

In an environment of global competition, the success of a manufacturing corporation is directly related to bow it plans and executes production in particular as well as to the optimization level of its process in general. This paper proposes a production

  Due to recent growing interest in autonomous software agents and their potential application in areas such as electronic commerce, the autonomous negotiation become more important. Evidence from both theoretical analysis and observations of human intera

최근 도심지와 산간지역에 설치되는 도로터널의 경우 터널개소의 증가와 장대화로 화재 사고가 점차 증가되고 있어 터널의 방재시설 강화가 요구되고 있다. 하지만 터널화재 발생시 대규모 인명피해가 발생될 수 있는 연기질식사 방지를 위한 연구는 부족한 실정이다. 본 연구에서는 화재발생시 연기확산을 차단하여 질식사 최소화 및 대피시간을 확보 할 수 있는 에어커튼 시스템을 개발하였다. 에어커튼 시스템은 방재설계 사례를 기준으로 시뮬레이션(CFD)을 통한 최적화 방안(분사각도, 분사량 등)을 도출하였으며, 실내 Lab Test 및 실제 도로터널서 화재실험을 실시한 결과 차연성능을 발휘하였다. 이론적/실험적 검증을 통한 에어커튼 시스템 도입을 통하여 도로터널의 인명피해를 최소화 할 수 있는 새로운 방재시설로 발전되길 기대한다.