Alpha activities can be used for categorization, transportation, and disposal of radioactive waste generated from the operation of nuclear facilities including nuclear power plants. In order to transport and dispose of such low- and intermediate-level radioactive waste (LILW) to the Wolsong LILW Disposal Center (WLDC) at Gyeongju, the gross alpha concentration of an individual drum should be determined according to the acceptance criteria. In addition, when the gross alpha concentration exceeds 10 Bq/g, the inventory of the comprising alpha emitters in the waste is to be identified. Gross alpha measurements using a proportional counter are usually straightforward, inexpensive, and high-throughput, so they are broadly used to assay the total alpha activity for environmental, health physics, and emergency-response assessments. However, several factors are thoughtfully considered to obtain a reliable approximate for the entire alpha emitters in a sample, which include the alpha particle energy of a particular radionuclide, the radionuclide that is used as a calibration standard, the uniformity of film in a planchet, time between sample collection and sample preparation, and time between sample preparation and counting. Korea Atomic Energy Research Institute (KAERI) have evaluated the inventory of radionuclides in low-level radioactive waste drums to send every year hundreds of them to the WLDC. In this presentation, we revisit the gross alpha measurement results of the drums transported to WLDC in the past few years and compare them with the concentrations of alpha emitters measured from alpha spectrometry and gamma spectrometry. This study offers an insight into the gross alpha measurement for radioactive waste regarding calibration source, self-absorption effect, composition of alpha emitters, etc.

Korea Atomic Energy Research Institute (KAERI) is planning to disposal of the radioactive contaminated cement waste form to the final disposal facility. The final disposal facility require evaluation of immersion, compressive strength, and radionuclide inventory of radioactive wastes to meet the acceptance criteria for safe disposal. According to the LILW acceptance criteria of the Nuclear Safety and Security Commission ok Korea (NSSC), the disposal limit radioactivity of 129I (3.70×101 Bq/g) is lower than other radionuclides. 129I emits low energy as its disposal limit is low, so it is difficult to analyze in the presence of 137Cs and 60Co which emit high energy. Therefore, it is essential to an accurately separate and analyze iodine in radioactive waste. In this study, we focused on the determination of 129I in cement waste form containing 137Cs, 60Co. We added 1 g of 129I(11.084 Bg), 137Cs(1,300 Bq) and 60Co(402 Bq) to cement waste form, respectively. The separation of 129I in cement waste form was carried out using an acid leaching method. And, we confirmed the specific activity of 137Cs and 60Co at each separation step. It was observed that an acid leaching method showed the remove efficiency 137Cs(99.97%) and 60Co(99.94%), respectively. In addition, 129I was also analyzed at approximately 96.44% in simulated contaminated cement waste form. In conclusion, through this experiment, it was confirmed that 129I could be successfully separated and analyzed by using the acid leaching method in cement waste form containing excessive 137Cs and 60Co.

The decommissioning of nuclear facilities produces various types of radiologically contaminated waste. In addition, dismantlement activities, including cutting, packing, and clean-up at the facility site, result in secondary radioactive waste such as filters, resin, plastic, and clothing. Determining of the radionuclide content of this waste is an important step for the determination of a suitable management strategy including classification and disposal. In this work, we radiochemically characterized the radionuclide activities of filters used during the decommissioning of Korea Research Reactors (KRRs) 1 and 2. The results indicate that the filter samples contained mainly 3H (500–3,600 Bq·g−1), 14C (7.5–29 Bq·g−1), 55Fe (1.1– 7.1 Bq·g−1), 59Ni (0.60–1.0 Bq·g−1), 60Co (0.74–70 Bq·g−1), 63Ni (0.60–94 Bq·g−1), 90Sr (0.25–5.0 Bq·g−1), 137Cs (0.64–8.7 Bq·g−1), and 152Eu (0.19–2.9) Bq·g−1. In addition, the gross alpha radioactivity of the samples was measured to be between 0.32–1.1 Bq·g−1. The radionuclide concentrations were below the concentration limit stated in the low- and intermediatelevel waste acceptance criteria of the Nuclear Safety and Security Commission, and used for the disposal of the KRRs waste drums to a repository site.

We established pretreatment method of solidified cement ion-exchange resin samples generated before 2003 in nuclear power plants for measurement of non-volatile radionuclide activity. A microwave digestion system (MDS) with mixed acid (HCl-HNO3-HF-H2O2) was used to dissolve cement and to desorb non-volatile elements such as Ce, Co, Cs, Fe, Nb, Ni, Re, Sr and U from mixed ion-exchange resin. The content of Ce, Co, Fe, Nb, Ni, Re, Sr, U and Cs after pretreatment of cement plus mixed ion-exchange resin was measured by ICP-AES and ICP-MS, respectively. As iron and strontium are also present in cement, their content after dissolving a certain amount of cement was measured by ICP-AES. All elements except Nb were quantitatively recovered. Especially since the Nb recovery was low at 72.0±2.5%, the MDS following addition of the mixed acid to the resin was operated once more for desorbing Nb from it. Finally the recovery of Nb was over 95%. This sample pretreatment method will be applied to solidified cement ion-exchange resin samples generated in nuclear power plants for assessment of radionuclide inventory.

The massive amount of radioactive waste will generated during decommissioning of nuclear. Among the radioactive waste from these disposal process, 50-55 million tons of concrete waste are included. For safe disposal, it is very important to accurately analyze the concentration of radionuclides, especially 129I and 131I, contaminated concrete. 129I, a long-lived radioisotope of iodine (t1/2=1.57 × 107 y), and 131I (t1/2=8.04 d) are generated from the fission of uranium in nuclear reactors. In Korea, according to the Nuclear Safety and Security Commission (NSSC) radioactive clearance level guide, the limit for radioactive clearance level of 129I is less than 0.01 (Bq/g). Iodine can be absorbed, accumulate in organisms, and exhibit low energy emission compared with cesium, and cobalt. Therefore, it is essential to an accurately separate and analyze iodine radioactive waste. In this study, we focused on the determination of iodine in simulated cement waste form containing KI for the recovery of iodine. We performed cement waste form sieved through a different particle size (0.5 mm < ɸ < 6.35 mm). For the separation of iodine from solid samples with low iodine content, such as soil, sediment, and cement, for sample decomposition associated with solvent extraction using CHCl3 for separation of iodine from the matrix. The separation of iodine in cement waste particles was therefore carried out using an acid leaching method using KI containing cement particles. We observed that cement particle size decreased at 6.35 mm to 0.5 mm with iodine yield decrease at 0.840±0.011 to 0.582±0.010. Thus, in this study, the acid leaching method enables to determination Iodine in cement.

The aim of this study was to investigate effect of heat stress on expression levels of plasminogen activators (PAs) related mRNAs and proteins, and changes of PAs activity in porcine endometrial explants. The endometrial explants (200 ± 50 mg) were isolated from middle part of uterine horn at follicular phase (Day 19-21) and were pre-incubated in serum-free culture medium at 38.5oC in 5% CO2 for 18 h. Then, the tissues were transferred into fresh medium and were cultured at different temperature (38.5, 39.5, 40.5 or 41.5oC) for 24 h. The expression level of urokinase-type PA (uPA), type-1 PA inhibitor (PAI-1), type-2 PAI (PAI-2), and heat shock protein-90 (HSP-90) mRNA were analysis by reverse-transcription PCR and proteins were measured by western blotting. The supernatant were used for measurement of PAs activity. In results, mRNA and protein levels of HSP-90 was higher in 41.5oC treatment groups than other treatment groups (p < 0.05). The expression of uPA, PAI-1, and PAI-2 mRNA were slightly increased by heat stress, however, there were no significant difference. Heat stress condition suppressed expression of active uPA and PAI-2 proteins (p < 0.05), whereas PAI-1 protein was increased (p < 0.01). Although PAI-1 protein was increased and active uPA was decreased, PAs activity was greatly enhanced by exposure of heat stress (p < 0.05). These results suggest that heat stress condition could change intrauterine microenvironment through regulation of PAs activity and other factors regarding with activation of PAs might be regulate by heat stress. Therefore, more studies regarding with regulatory mechanism of PAs activation are needed.

In our previous study, exogenous plasminasminogen activators (PAs) influenced to fertility of boar spermatozoa via reduction of zona pellucida (ZP) resistance against protease and number of sperm binding ZP. plasminasmin (plasmin), is converted by PAs, is an important enzyme to degrade extracellular matrix and it is closely associated with fertilization process. Therefore, the aim of present study was to confirm changes of sperm penatration and ZP solubility by plasmin during in vitro fertilization (IVF). The cumulus-oocyte complasminexes (COCs) were aspirated from the antral follicles 3-6 mm in diameter and matured for 44 hours. Then, the cumulus cells were removed and denuded oocytes were co-incubated with spermatozoa for 18-20 hours in IVF medium containing 100 ng/ml plasmin. The number of sperm binding ZP and ZP solubility were measured using hoechst 33342 and 0.5% (w/v) pronase, respectively. Aceto-orcein stain was used to assess fertilization parameters. In results, sperm penetration did not affect by plasmin treatment during fertilization. Hoewever, treatment of plasmin decreased monospermic fertilization and IVF efficiency compared with control group (p<0.05). Furthermore, the number of penetrated sperm and pronucleus formation per zygote in plasmin group was significantly increased compared with control group (p<0.05). Despite of reduced monospermic fertilization by plasmin treatment, the number of sperm binding ZP was significantly higher in non-treated zygote than plasmin-treated zygote (p<0.05). Similar with previous study, ZP digestion time was reduced by plasmin treatment (p<0.05). These findings shown that plasminasmin during fertilization enhance the penetration of spermatozoa into ZP via increasing of ZP solubility and it was correspond with our previous results that fertility of spermatozoa during IVF was increased by exogenous urokinase-type PA treatment via sperm-ZP binding and increase of ZP solubility. Therefore, during the fertilization process, plasmin that is converted by PAs from oviduct epithelial cells might be closely associated with degradation of ZP proteins for penetration of sperm. This work was supported by the National Research Foundation of Korea (NRF) grant funded by the Korea government (Ministry of Education) (2016R1D1A1B03931746).

This paper investigates a theoretical and experimental evidence for a niche strategy for small and medium online shopping malls to survive against large famous shopping malls dominating the E-commerce market. The present study explored both theoretically and empirically how consumers’ preferences for alternatives in online shopping context are affected by their construal level and concentrated its efforts on the verification of the phenomenon under various frames and regarding various categories(Liberman and Trope 1998; Liberman, Trope, and Stephan 2007, Liberman Trope, and Wakslak 2007). For this, this study demonstrates how chronic construal levels of consumers may affect their alternative choice for online shopping via various contexts (Experiment 1-3) and categories (Experiment 3-5). This series of experiments suggests that consumers with high construal level can be defined as a group that is relatively less susceptible to reputation of the shopping malls. Thus, strategically targeting this group of consumers will help small online malls lacking store reputation to mitigate their competitive disadvantage. Based on both existing literature and the experimental results as above, this research discusses possible methods for small online shopping malls to target high-construal segmentation.

A stable supply of seafarers is an important issue for Korean maritime industries and related business activities. After four years of their role on a ship, Korean maritime officers are increasingly being separated from their fellow sailors. The present paper reviews the trend and characteristics in the separation rate of maritime officers, and examines the main factors affecting the separation rate through panel data models. The paper collects the panel data of maritime officers from 2007 to 2014. The main results of panel data models show us that the separation rate is affected mainly by the duration (period) after graduation. The unemployment rate in all industries and the relative wage level of seafarers affect negatively the separation rate. The dummy variable for the completion year of military services shows positive coefficients. We can conclude that the labour market of seafarers is affected by the employment situation in all industries.

그래핀 기반 소재는 높은 가공성과 초박성으로 인하여 분리막 소재로서 각광받고 있다. 본 연구에서는, 스핀 코팅 법을 이용하여 제조된 산화그래핀 분리막의 기체 투과 거동을 평가하였다. 산화그래핀 분리막의 구조는 산화그래핀의 크기와 산화그래핀 용액의 pH 조절을 통하여 조절될 수 있다. 산화그래핀의 크기가 작을수록 굴곡률이 작아짐에 따라 분리막의 기 체 투과도 및 선택도가 증가하는 경향을 보인다. 또한 산화그래핀에서의 기체 투과 거동은 적층된 산화그래핀 사이의 채널 크기에 따라 영향을 받는다. 특히 산화그래핀 분리막의 좁은 기공과 이산화탄소 선택적인 산화그래핀 자체의 특성으로 인하 여 산화그래핀 분리막은 이산화탄소에 대한 높은 투과도 및 선택성을 가지며, 이는 이산화탄소 포집에 적합한 특성을 가진다. 이러한 산화그래핀 분리막의 특이한 기체 투과 거동은 흡착-촉진 확산 거동(표면 확산 기작)으로 설명될 수 있다. 본 연구를 통하여 이산화탄소 선택성 분리막 소재 설계와 슬릿 형태의 기공과 적층 구조를 가진 분리막을 통한 기체 투과 거동 연구가 활발히 이루어질 것으로 기대한다.