PURPOSES : This study was conducted to evaluate the physical properties of the RAP 50 asphalt mixture containing polymer modified rejuvenator and warm-mix additive to improve the recycling rate of RAP and reduce CO2 emission. METHODS : Mix design of Polymer Modified Warm-mix Asphalt Mixture(RAP 50), and Hot Mix Asphalt Mixture(RAP 30) were produced and the properties of asphalt mixture such as Marshall Stability, ITS, Deformation Strength, TSR, and Dynamic Stability were compared between the two asphalt mixtures. RESULTS : The RAP 50 asphalt mixture showed superior or similar performances compared to the RAP 30 asphalt mixture in all the tests conducted. The results of the Marshall stability and dynamic stability in particular were 13,045N and 3,826 pass/mm, which were 11.37% and 76.7% greater than the RAP 30 asphalt mixture, which indicated that high plastic deformation resistance may be expected. CONCLUSIONS : The results obtained from laboratory tests on the two types of mixtures indicated that the use of polymer modified rejuvenator and warm-mix additive not only allows to increase the proportion of RAP but also improves its properties under lower temperature condition than RAP 30 asphalt mixture. Additionally, it was confirmed that plastic deformation resistance was high and moisture resistance and crack resistance were improved for a RAP 50 asphalt mixture.

This study presents a sustainable design method to optimize the embodied energy and CO2 emission complying with the design code for reinforced concrete column. The sustainable design method effectively achieves the minimization of the environmental load and energy consumption whereas the conventional design method has been mostly focused on the cost saving. Failure of reinforced concrete column exhibits compressive or tensile failure mode against an external force such as flexure and compression; thus, optimization analyses are conducted for both failure modes. For the given sections and reinforcement ratios, the optimized sections are determined by optimizing cost, embodied energy, and CO2 emission and various aspects of the sections are thoroughly investigated. The optimization analysis results show that 25% embodied energy and 55% CO2 emission can be approximately reduced by 10% increase in cost. In particular, the embodied energy and CO2 emission were more effectively reduced in the tensile failure mode rather than in the compressive failure mode. Consequently, it was proved that the sustainable design method effectively implements the concept of sustainable development in the design of reinforced concrete structure by optimizing embodied energy consumption and CO2 emission.

대부분의 온실가스는 에너지의 생성 및 이용으로부터 발생되고, 교통부문에서 배출되는 온실가스 중 약 95 % 이상이 수송용 연료에서 기인한다. 또한, IPCC 가이드라인에서 제시하는 배출계수를 사용하였을 경우 국가 고유의 연료특성이 반영되지 않는 단점이 있고, 기후변화협약 교토의정서에 따른 의무 감축국도 UN에 제출하는 국가 온실가스 배출량 보고서 작성 시 대부분 Tier 2나 Tier 3 수준의 배출계수를 적용하고 있 다. 본 연구에서는 국내 교통부문에 사용되는 휘발유, 경유 등의 수송용 연료에 대한 연차별 시계열 특성을 파 악하고, CO2 배출계수의 연도별 변화추이를 분석하여 실제 연료를 활용한 CO2배출계수 실측방법의 적용 타 당성을 평가하였다.

PURPOSES : The aim of this article is to compare and identify eco-friendly competitiveness between (regional) motorway and high-speed rail(HSR) from the perspective of CO2 emission in the Republic of Korea. METHODS : In order for an analysis of low-carbon competitiveness between the two modes, CO2e emission, CO2eppk (equivalent CO2 gram per passenger kilometer), is employed as a comparison index. As for HSR, the index is calculated based on the passenger transport data and the gross of CO2e produced by Kyungbu high-speed line in 2013. Additionally, the gross of CO2e is computed by the greenhouse gas emission factors of domestic electricity generation mix. Regarding the index of motorway, it is directly calculated using both the official CO2e emission factor and the passenger-car occupancy of motorway. RESULTS: The results revealed, in the case of inter-regional transport, that the CO2e emission of displacement-based cars is 54.9% less than that of HSR, as the domestic electric power systems heavily relies on the thermal power plants over 66%. Note that internal combustion engines commonly used for vehicles are more energy-efficient than steam-driven turbines usually utilized for thermal power generation. CONCLUSIONS: It can be seen, at the very least in our study, that HSR has no superiority over motorway in the case of CO2e emission under the situations of domestic electricity generation mix. In addition, advanced eco-friendly vehicles have strong advantages over HSR. Therefore, all-out efforts should be made to develop and harvest renewable energy sources in order to achieve low-carbon HSR, sparing fossil fuels.

PURPOSES: The present study aims to evaluate the added CO2 emissions incurred from accelerating operation when to increase the speed up to the allowed level. METHODS : The methodology used are basically the relationship between emission rates and vehicle speeds or acceleration rate. These rates together are used to calculate the added CO2 emissions incurred from accelerating operation. RESULTS: It was resulted that the all the emission rates are increasing proportionally to vehicle speeds or acceleration rates. Additionally, it was also resulted that allowable speeds increasing, the added emission rates are increasing rapidly. CONCLUSIONS: It may be concluded that if the allowable speed ranges are managed, CO2 emissions during vehicle operation are much reduced. From this reason, it was found that the allowable speed during highway design and operation would be much necessary

This study was conducted to find out the soil CO2 emission characteristic due to rain fall pattern and intensity changes. Using Automatic Opening and Closing Chambers (AOCCs), we have measured annual soil respiration changes in Pinus koraiensis plantation at Seoul National University experimental forest in Mt. Taehwa. In addition, we have monitored heterotrophic respiration at trenching sites (4×6 m). Based on the one year data of soil respiration and heterotrophic respiration, we observed that 24% of soil respiration was derived from root respiration. During the rainy season (end of July to September), soil respiration at trenching site and trenching with rainfall interception site were measure during portable soil respiration analyzer (GMP343, Vaisala, Helsinki, Finland). Surprisingly, even after days of continuous heavy rain, soil water content did not exceed 20%. Based on this observation, we suggest that the maximum water holding capacity is about 20%, and relatively lower soil water contents during the dry season affect the vital degree of trees and soil microbe. As for soil respiration under different rain intensity, it was increased about 14.4% under 10 mm precipitation. But the high-intensity rain condition, such as more than 10 mm precipitation, caused the decrease of soil respiration up to 25.5%. Taken together, this study suggests that the pattern of soil respiration can be regulated by not only soil temperature but also due to the rain fall intensity.

저탄소 공정을 이용한 추출 기술인 초음파, 마이크로파 및 초고압 추출 공정기술의 이산화탄소 배출량(TCO2)과 얻어진 저분자 진세노사이드 총량의 상관관계를 비교하였다. 기존의 공정인 열수 추출 공정의 TCO2 배출량은 약 0.4 TCO2로 나타났다. 마이크로파 추출 공정의 경우 0.1437 Ton 당 CO2를 배출하는 것으로 확인 되었다. 또한, 초음파 추출 공정의 경우 0.0862 Ton 당 CO2를 배출하는 것을 확인 하였으며, 초고압 추출 공정의 경우 0.1014 Ton당 CO2를 배출하는 것을 확인 하였다. 저탄소 공정별 저분자 진세노사이드의 전환된 양을 측정한 결과 마이크로파 추출 공정의 경우 약 246.65% 정도 증진된 것을 확인 할 수 있었다. 또한, 초음파 공정의 약 275.71% 증진된 결과를 보였다. 초고압 추출 공정의 경우에는 약 295.21% 증진된 결과를 얻었다. 전체적으로 열수 추출 공정의 경우 얻어진 저분자 진세노사이드가 적은 반면 CO2 배출량이 매우 높은 것을 확인하였다. 반대로, 저탄소 추출 공정인 마이크로파, 초음파 및 초고압 공정의 경우 얻어진 저분자 진세노사이드의 양이 높으며, 방출되는 CO2의 양이 기존의 재래 방법보다 적은 것을 확인 하였다. 따라서, 저탄소 추출 공정인 마이크로파, 초음파, 초고압 추출 공정을 통해 인삼을 효과적으로 추출을 할 수 있으며, 친환경 저탄소 공법을 통해 CO2 발생량을 억제하여 경제적으로 천연물을 추출할 수 있을 것으로 사료된다.

PURPOSES: The sensitivity of CO2 emissions per vehicle by a various speeds is compared according to the type of roads. METHODS: The methodology of the study are as follows: First, the sensitivity of CO2 emissions per vehicle are analyzed by averaged daily travel speeds. Second, the sensitivity of CO2 emissions per vehicle are analyzed by averaged hourly travel speed. Third, the sensitivity of CO2 emissions per vehicle are analyzed by sectional travel speeds. RESULTS: The sensitivity that on Saturday in a week, at peak times in a day and in close location from Seoul was higher than in other situations. CONCLUSIONS: From this study, we may conclude that CO2 emissions per vehicle at low speeds are generally more sensitive.

This study investigates the dynamic effects of economic development, international cooperation, electricity consumption, and political risk on the escalation of CO2 emission in Vietnam. We adopted autoregressive distributed lag model and Granger causality method to examine the interaction between CO2 and various economic and political factors, including foreign direct investment, trade openness, economic growth, manufacture, electricity consumption, and political risk in Vietnam since the economic revolution in 1986. The findings reflect opposite influence between these factors and the level of CO2 in the intermediate and long-term durations. Accordingly, foreign direct investment and CO2 emission have a bidirectional relationship, in which foreign direct investment accelerates short-term CO2 emission, but reduces it in the long run through an interactive mechanism. Moreover, economic development increases the volume of CO2 emission in both short and long run. There was also evidence that political risk has a negative effect on the environment. Overall, the findings confirm lasting negative environmental effects of economic growth, trade liberalization, and increased electricity consumption. These factors, with Granger causality, mutually affect the escalation of CO2 in Vietnam. In order to control the level of CO2, more efforts are required to improve administrative transparency, attract high-quality foreign investment, and decouple the environment from economic development.

본 연구는 우리나라의 1990-2014년 시계열 자료를 활용하여 물 효율성, 경제성장, 전력생산 및 이산화탄소 배출 간의 장·단기 인과관계를 실증적 으로 분석하였다. 기존 연구들이 경제성장, 이산화탄소 배출 및 전력 및 에너지에 국한되어 분석을 한 반면 본 연구는 기존 변수들과 더불어 물 효율성과의 관계를 설명하였다는 기여를 가지고 있다. 실증분석결과를 살펴보면, 네 변수들은 단기조정관계를 통해 장기적으로 균형상태에 도달한다는 것과 변수들 간의 인과관계에서 이산화탄소 배출과 경제성장은 물 효율성의 원인이 되고 이산화탄소 배출과 경제성장 및 물 효율성은 전력생산의 원인이 된다는 사실을 발견하였다. 또한 물 효율성에 대한 장기 영향계수 추정결과를 통해 전력생산의 증가와 경제성장 및 이산화탄소 배출의 감소는 물 효율성을 증가시키며, 일정 수준 이상의 경제성장은 물 효율성의 증가속도를 감소시킨다는 경제성장과 물 효율성의 역U자형 관계를 확인하였다.

Environmental awareness and its relation to the development of economy has garnered increased attention in recent years. Researchers, over the years, have argued that sustainable development warrants for minimizing environmental degradation since one depends on the other. This study analyzes the relationship between environmental degradation (carbon emission taken as proxy for degradation), economic growth, total energy consumption and industrial production index growth in Bangladesh from year 1998 to 2013. This study uses Vector Autoregression (VAR) Model and variance decomposition of VAR to analyze the effect of these variables on carbon emission and vice-versa. The findings of VAR model suggest that industrial production and GDP per capita has significant relationship with carbon emission. Further analysis through variance decomposition shows carbon emission has consistent impact on industrial production over time, whereas, industrial production has high impact on emission in the short run which fades in the long run which is consistent with Environmental Kuznets Curve (EKC) hypothesis. Carbon emission rising along with GDP per capita and at the same time having low impact in the long run on industrial index indicates there may be other sources of pollution introduced with the rise in income of the economy over time.

This reasearch was performed to evaluate CO2 emission of Modular bridge quantitatively. Preferentially, Modular bridge was separated steel girder bridges, concrete girder, concrete slab bridge and analyzed process in doing configuration W.B.S system. According to the Ministry of land guidelines, each process was divided into material, transportation, construction and calculated by division in detail the materials and fuel so it planned that quantitative assessment can be achieved.