Today freeway is experiencing a severe congestion with incoming or outgoing traffic through freeway ramps during the peak periods. Thus, the purpose of this study is to identify the traffic characteristics, analyze the relationships between the traffic characteristics and finally construct the delay predictive models on the rap junctions of freeway with 70mph speed limit. From the traffic analyses, and model construction and verification for delay prediction on the ramp junctions of freeway, the following results were obtained : ⅰ) Traffic flow showed a big difference depending on the time periods. Especially, more traffic flows were concentrated on the freeway junctions in the morning peak period. ⅱ) The occupancy also showed a big difference depending on the time periods, and the downstream occupancy(Od) was especially shown to have a higher explanatory power for the delay predictive model construction on the ramp junctions of freeway. ⅲ) The delay-occupancy curve showed a remarkable shift based on the occupancies observed : Od/〈9% and Od/≥9%. Especially, volume and occupancy were shown to be highly explanatory for delay prediction on the ramp junctions of freeway under Od/≥9%, but lowly for delay prediction on the ramp junctions of freeway under Od/〈9%. Rather, the driver characteristics or transportation conditions around the freeway were thought to be a little higher explanatory for the delay prediction under Od/〈9%. ⅳ) Integrated delay predictive models showed a higher explanatory power in the morning peak period, but a lower explanatory power in the non-peak periods.

As a shipboard dependency for the safety and reliability becomes very important, the need for solid systems providing non-stop workload has been increased. This system is heartbeat that transmits shipboard state, audit and control information to the land. So, this paper describes a ship's LAN configuration method for the safety and reliability. In order to achieve these requirements, network, server and disk fault tolerance techniques are surveyed, and dual network configuration model, cluster server configuration method are presented and tested based on the survey.

Today freeway is thought to be a very important transportation facility carrying tremendous traffic flow as the main corridor within the area of between the areas. However freeway is experiencing severe congestion and accidents by increased entrance ramp flow especially at peak time period. Ramp meters on the freeway entrance ramps that supply traffic to the freeway in a measured or appropriately regulated amount are needed for alleviating freeway congestion. Because ramp meters can be operated to discharge traffic at a measured or regulated rate thus maintaining more uniform speed on the mainline section maximizing the throughput to the freeway within the capacity of a downstream bottleneck and reducing the congestion related accidents. Thus the objectives in this study were to analyze the traffic characteristics on the freeway I-94 with ramp metering system before/after ITS technology in Detroit (Michigan) area compare shifts of the traffic characteristics on the freeway I-94 before/after ITS technology and finally suggest a better ramp metering strategy for the freeway system The following results were obtained: i)Flow occupancies and speeds on the mainline merge section of freeway were shown to be a big difference depending on the peak periods areas and directions based on the distribution of traffic flow characteristics on the freeway. ii)Reduced speed was shown to be more than 5 mph and ramp flow was also shown to be more than 240 vph at peak periods if there was the ramp metering system constructed on the freeway. iii)Ramp metering system was shown to be optimally operated on the freeway if ramp flow could be maximized within the range of over 900 vph and reduced occupancy could be also maximized by no more than 2 percent at peak periods. iv)The average flows on the freeway after the ITS technology were shown to be a decrease of over 20% depending on the peak periods areas and directions when compared with those flow on the freeway before the ITS technology. over 20% depending on the peak periods areas and directions when compared with those speeds on the freeway before the ITS technology. vi)The average metering rates on the freeway after the ITS technology were shown to be an increase of over 10% depending on the peak periods areas and directions when compared with those metering rates on the freeway before the ITS technology.

This paper is concerned with developing a standard costing model based on the case study of PECT and GCT in order to improve operation efficiency and design business strategy. In doing so the model can be a useful tool to analyze current calculation system of lease charge at the two terminals and to judge whether the level of lease charge currently applied to them is justifiable for thier profitability.

The purpose of this paper is to develop a knowledge-based real-time decision support system to support decision makers for efficient berth operation of Inchon Port. In these days the berth operation problems have been many studied. The berth operation rules differ from port to port and the problem is highly dependent on natural geographical and operational environment of port. In Inchon Port the ship’s entrance into port and departure from port is extremely affected status of dock. In this paper we analyzed some effects of dock a specific character of Inchon Port with a real data of ship’s in Inchon Port. And reconstruct a previous expert’s knowledge of berth allocating problem in Inchon Port. Also the mechanism for the efficient berth operation has been studied by repeatedly dispatching in order to obtain a best effect of berth allocation, with real-time updated information for delay at service time of a specific berth and changing of a working-berth. The system is developed with graphic user interface(GUI) concept using user interactive approach. And this system will be provide decision support maker with an efficient and fast way to berth allocating and reduce wastes of time space and manpower in Inchon Port operation.

Congestion and traffic accidents occur on the merge and diverge sections in the interchange of the freeway. Studies have been conducted to reduce the traffic delay and accidents on the merge section in the freeway since 1960s. but a study was not conducted to estimate the speed variation on the merge section construct models estimated for the speed variation and suggest the appropriate measures. The purpose of this study was to identify the traffic flow characteristics on the merge section in the freeway construct the models estimated for the speed variation on the merge section in the freeway and finally establish the appropriate measure for reduction of traffic delay and accidents on the merge section in the freeway. The following results were obtained: I) Speed variations in the urban freeway appeared to be about 3.2mph, 6.5mph and 7.4mph based on the morning peak period, afternoon peak period and 24-hours period but those in the suburban freeway appeared to be about 8.0mph, 11.1mph and 10.1mph based on the same periods respectively. So different speed reduction signs need be installed to reduce delay and accidents on the merge section in the freeway based on the areas and periods as the freeway traffic management system(FTMS). ii) These models estimated for speed variation need to be studied with the changeable message sign(CMS) technique based on the real-time data so that the traffic flow could be maximized and the traffic delay and accidents be on the merge section in the freeway as more efficient freeway traffic management system(FTMS) in the near future.

Traffic accidents increase with the increase of the vehicles in operation on the street. Especially big traffic accidents composed of over 3 killed or 20 injured accidents with the property damage become one of the serious problems to be solved in most of the cities. The purpose of this study is to build the discrimination model on big traffic accidents using the Quantification II theory for establishing the countermeasures to reduce the big traffic accidents. The results are summarized as follows. 1)The existing traffic accident related model could not explain the phenomena of the current traffic accident appropriately. 2) Based on the big traffic accident types vehicle-vehicle, vehicle-alone, vehicle-pedestrian and vehicle-train accident rates 73%, 20.5% 5.6% and two cases respectively. Based on the law violation types safety driving non-fulfillment center line invasion excess speed and signal disobedience were 48.8%, 38.1% 2.8% and 2.8% respectively. 3) Based on the law violation types major factors in big traffic accidents were road and environment, human, and vehicle in order. Those factors were vehicle, road and environment, and human in order based on types of injured driver’s death. 4) Based on the law violation types total hitting and correlation rates of the model were 53.57% and 0.97853. Based on the types of injured driver’s death total hitting and correlation rates of the model were also 71.4% and 0.59583.

This study, a sub-one of comprehensive research works titled under "Rural Resources Evaluation System", tried to verify utility/applicability of the developed model system through the case study works on 3 sample villages, Backya, Uyan and Suyu, representing the lowland, upland and seashore villages respectively. From the various surveying and collecting works including the official/statistical data collection, map analysis, in-situ investigation, field survey and written material review, the original data set were obtained and manipulated into final input data for resources grading. After then, by the automatized calculation procedure of "Rural Resources Evaluation System", score results for resources evaluation were finally produced with the total maximum score being 1,000. Through comparing works among score results of 3 case villages and between score results and areal characteristics of each case village, the applicability of the system developed in this study was well confirmed.

The export/import processing systems of the foreign advanced port use the integrated database to increase the productivity of the users involved in the port and logistics activities. However all the port and logistics related organizations in Korea such as container terminal, customs, ministry of maritime affairs and fisheries, etc. are using their own databases, so it is very inconvenient to the users to process their export/import affairs. It is necessary to develop the integrated database for the port and logistics affairs to provide the one stop service to the port and logistics related users. So we have investigated and analyzed the databases of port and logistics related organizations, and recognized the users' various needs of information. And then we have suggested the conceptual architecture of integrated database for port and logistics, and proposed the strategies for successful development of the integrated database in this paper.

This paper aims to suggest the strategies for Korea port, especially Busan to develope into a viable transhipment center and/or Hub port as the articulation points between mainline and feeder nets. To tackle this goal, the authors clarify the requirements for Korea port which will be critical in determining its position as Hub trough the careful analysis on competitiveness, environmental impact, port policy and capacity, transhipment traffic and inherent ability to generate traffic. The results are summerized as follows. (1) Coping with increasing container volumes, new investment is sustainedly necessary to increase the capacity and inherent ability of container port and create economies of scale. Moreover, increasing port capacity will increase the potential for the Korea port's inclusion into mainline rather than feeder networks. (2) Considering an increasing awareness of need for customer-oriented operations and service quality rather than simply a reliance on infrastructure-led efficiency, privatization of one sort or another and corporation of port have been key strategies in achieving greater efficiency in Korea containerport.

This study, a sub-one of comprehensive research works titled under "Rural Resources Evaluation System", tried to propose a rational methodology for development of rating tabulation on evaluation items. Firstly, the database system for handling of original/processed data of each evaluation items was constructed, being mainly focussed on the possibilities of data acquisition and statistical treatment. The rating tabulation system developed in the study has the formalized evaluation classes as 2 or 5 for convenience/simplification of analysis works. For each evaluation item in lower step of the goal system, 5 types of rating technique were arranged, which were based on statistical analysis using mean and standard deviation values(Type I), its existence or not(Type II), relative significance of its holding volume(Type III), synthesized weighting scale of its quality and quantity(Type IV), and the others(Type V). And, standardized 4-steps procedure for rating tabulation was proposed. Finally, the rating tabulation system developed in the study was applied to each evaluation item of goal system, from which the numerically-valued ranking criteria was obtained.

This paper aims to suggest the strategies for Korea port, especially Busan to develope into a viable transshipment center and/or Hub port as the articulation points between mainline and feeder nets. To tackle this goal, the authors clarify the requirements for Korea port which will be critical in determining its position as Hub through the careful analysis on competitiveness, environmental impact, port policy and capacity, transshipment traffic and inherent ability to generate traffic. The results are summerized as follows. (1) Coping with increasing container volumes, new investment is sustainedly necessary to increase the capacity and inherent ability of container port and create economies of scale. Moreover, increasing port capacity will increase the potential for the Korea port's inclusion into mainline rather than feeder networks. (2) Considering an increasing awareness of need for customer-oriented operations and service quality rather than simply a reliance on infrastructure-led efficiency, privatization of one sort or another and corporation of port have been key strategies in achieving greater efficiency in Korea containerport.

Kim Eunil & Park Soonhyuck. 1997. The Construction of Database of English Sentences Based on Syntactic and Semantic Types. Studies in Modern Grammatical Theories 11: 1-16. Our database is to help researchers easily find the type of English sentences they want to discuss by clicking syntactic and semantic types or typing in words. The database written by MS Visual Basic 4.0 and MS Jet Database Engine 3.0 has 3 modules--i.e. search, input, and DB manager. The search module helps users find English sentences discussed in linguistic journals by using 62 syntactic/semantic types, words, sources, or grammaticality. The input module helps users make his/her own database while the DB manager merges two DB files.