Non-destructive estimation of leaf area is a more efficient and convenient method than leaf excision. Thus, several models predicting leaf area have been developed for various horticultural crops. However, there are limited studies on estimating the leaf area of strawberry plants. In this study, we predicted the leaf areas via nonlinear regression analysis using the leaf lengths and widths of three-compound leaves in five domestic strawberry cultivars (‘Arihyang’, ‘Jukhyang’, ‘Keumsil’, ‘Maehyang’, and ‘Seollhyang’). The coefficient of determination (R2) between the actual and estimated leaf areas varied from 0.923 to 0.973. The R2 value varied for each cultivar; thus, leaf area estimation models must be developed for each cultivar. The leaf areas of the three cultivars ‘Jukhyang’, ‘Seolhyang’, and ‘Maehyang’ could be non-destructively predicted using the model developed in this study, as they had R2 values over 0.96. The cultivars ‘Arihyang’ and ‘Geumsil’ had slightly low R2 values, 0.938 and 0.923, respectively. The leaf area estimation model for each cultivar was coded in Python and is provided in this manuscript. The estimation models developed in this study could be used extensively in other strawberry-related studies.

In this study, graphene was rapidly grown by chemical vapor deposition using a liquid cell for supplying methanol as a carbon source of graphene. To realize the rapid growth, methanol which is carbon-contained organic solvent was used instead of methane gas, a widely used carbon source for graphene growth. The graphene grown with the growth time as a variable was transferred to a SiO2/ Si substrate with an oxide thickness of 300 nm to confirm whether it was grown with full coverage with an optical microscope. The results confirmed a full coverage in 0.5 min of growth. The Raman spectra also confirmed the G-peak position at 1585.0 cm−1 and an intensity ratio of 2D/G at 2.3 or higher. Concerning electrical transport characteristics, at an induced carrier density of 1 × 1012 cm−2, the hole (μh) and electron (μe) mobilities were 1524 cm2 V−1 s−1 and 1528 cm2 V−1 s−1, respectively. Thus, our study confirmed that high-quality, large-area graphene can be grown within 0.5 min.

한-아프리카 농식품 기술협력 협의체 (KAFACI)는 아프리카 농업 공통현안을 연구과제를 통하여 해결하고자 2010년에 출범하여 현재 한국 포함 20개국으로 구성되었다. 본 논문은 지난 10년간 회원국에서 수행한 결과를 바탕으로 KAFACI 회원 국과 비회원국 간의 양자 무역 흐름에 대한 국제 기술 협력의 영향을 분석하였다. 분석은 UN 상품 무역 통계 데이터베이스에서 2000년에서 2018년 동안 45 개 아프리카 국가 간의 양 자 무역 패널 데이터를 이용하였으며 국제 무역 중력 모델을 적용하였다. 또한, 내생성, 표본 선택 편의, 패널내의 상관관계 를 통제하는 표본 선택 기법을 적용한 핵크만 랜덤 효과 회귀 모형을 사용하였다. 분석결과 경험적 결과는 국제 기술 협력이 KAFACI 회원국과 비회원 국 간의 양자 무역 흐름에 긍정적인 영향을 미친다는 것을 보여준다. 이러한 연구 결과 이 외에도 KAFACI는 회원국과 아프리카 이외의 주요 무역 파트 너 간의 양자 무역 흐름을 크게 늘렸을 가능성이 있지만 여기서는 다루지 않았다. 또한 KAFACI 회원국의 기술 채택 수준과 비율은 무역을 잠금 해제하기 위해 경제의 공급 측면에 영향을 미치는데 중요하지만 여기에서는 다루지 않았다.

The yellow-legged hornet, Vespa velutina nigrithorax (Hymenoptera: Vespidae), invaded into South Korea in 2003. Currently, V. velutina is distributed throughout South Korean regions,. A genetic trait of invasive species provides important data for environmental risk assessment. In this study, we analysed the genetic variation of the V. velutina among the populations of South Korea and other foreign countries using partial sequences of mitochondrial COI, CytB and 16S rRNA. We further developed intergenic spacers (IGS2 and IGS3) to detect genetic variation among Korean populations. Each single haplotype was recovered from the domestic V. velutina from each coding gene sequence. Korean individuals shared the haplotype with that of Japan and China. Phylogenetic analysis (excluding 16S rRNA) using available sequences and ours showed the presence of two groups: the Indonesia and Malaysia group and another group (Korea, Japan, China, France, Vietnam and Thailand). The newly developed IGS2 and IGS3 markers resulted in each seven and four haplotypes, providing better resolution than coding gene sequences. Analysis of Molecular Variance using the combined sequences of IGS2 and IGS3 showed that the majority of variance was allocated to each population and only minority of variance is allocated to among-populations. This result may indicate that the V. v. nigrithorax invaded in Korea shows a single panmictic population and this possibly suggest that Korean population may have originated from small founder individuals.

Roller Compacted Concrete Pavement (RCCP) is placed by roller compaction of a mixture of less cement and unit water content and more aggregates and provides excellent early strength development with the help of interlocking of aggregates and hydration. The unit cement content of RCC pavements accounts for 85% of conventional pavements, with low drying shrinkage. As low drying shrinkage leads to smaller crack widths than ordinary concrete, RCC pavements can help elevate reflecting crack resistance if applied to a base layer of a composite pavement system. In a composite pavement with an asphalt surface laid over a concrete base, pavement temperature change is important in predicting pavement performance. As movement of the lower concrete layer is determined by temperature depending on pavement depth, temperature data of the pavement structure serves as an important parameter to prevent and control reflecting crack. Among the causes of reflecting crack, horizontal behavior of the lower concrete layer and curling-caused vertical behavior of joints/cracks are considered closely related to temperature change characteristics of the lower concrete course (Baek, 2010). Previous studies at home and abroad about reflecting crack have focused on pavement behavior depending on daily and yearly in-service temperature changes of a composite pavement (Manuel, 2005). Until now, however, studies have not been conducted on initial temperature characteristics of concrete in composite pavements where asphalt surface is placed over an RCC base. Annual temperature changes of in-service concrete pavements go up to 60 ℃, and those of asphalt overlays become around the twice at 110 ℃. This study evaluated initial crack behavior of composite pavement by investigating pavement temperature by depth of an RCC base and analyzing joint movement depending on change to temperatures of continuously jointed pavements. Findings from the study suggest that in composite pavements and asphalt overlays, time of laying asphalt has an important impact on crack behavior and reflecting crack.

The Semi-Rigid Pavement (SRP) mixture is composed of Gap Graded Asphalt (GGA) mixture (air void = 20~28%) and cement paste. By inserting cement paste into voids in GGA mixture, SRP can provide not only flexibility but also rigidity characteristics on pavement performance. SRP can mitigate pavement surface temperature increase during summer session, provide better smoothness and mitigate rutting distress due to heavy weight vehicles, successfully. In Japan, SRP is widely applied in cross section area, heavy vehicle parking lot and highway ticketing booth in highway network system. In South Korea, SRP was introduced and applied since 2005. However, still more researches and studies are needed to understand material characteristics and improve performance of SRP. Moreover, the current SRP system in South Korea merely follows and adapts the aggregate gradation information from Japan which needs to be amended and customized into original material (i.e. aggregate, binder and cement) situation of South Korea. In this paper, SRP system based on Stone Mastic Asphalt (SMA) mixture design originated from Korea Expressway Corporation (KEC) and enhanced cement paste with addition of fly-ash and slags was developed. In addition, an optimized proportion between asphalt mixture air voids and cement paste amount with consideration of economic benefit was introduced. Based on field evaluation process it can be said that the newly developed SRP system can successfully adapted not only in static site on highway: parking lots or ticketing booth, but also in dynamic site on highway: driving and wheel path.

In case of performing asphalt pavement overlay on existing concrete pavement layer, applying asphalt emulsion tack-coating or spreading prime-coating is considered to improve adhesion between asphalt and concrete layer. After coating work is done a curing process is considered not only for promoting evaporation process in coated (and/or spread) asphalt emulsion, but also for generating a membrane which can act as a bonding agent. Finally, asphalt overlay construction is performed when this curing process is completely done. However, during asphalt overlay construction process remarkable amount of spread tack-coating layer is lost due to asphalt material transfer vehicles (e.g. trucks, approximately 40~50% of total spread tack coating material is lost). In this paper, a new pavement equipment contains simultaneous asphalt emulsion spreading ability and corresponding construction techniques are introduced. Through applying this equipment, non-stop two step sequent working process: spreading asphalt emulsion on to existing concrete pavement layer then paving asphalt material for overlay construction, is available. During pavement working process temperature of asphalt material was kept with ranged between 130ºC and 170ºC. After performing field performance evaluation, it was found that crucial improvement in pavement layer adhesion, crack and rutting resistant ability were observed compared to the conventional paving method.

동남아시아에 발생하던 등검은말벌은 최근 국내 뿐만 아니라 프랑스와 일본, 유럽 전역으로 확산되어 전 세계 양봉 산업에 극심한 피해를 주고 있다. 등검은말벌을 방제하기 위해 다양한 방제 방법들이 연구되고 있으며, 그 중 말벌 유인제에 대해 국제적으로 많은 연구가 진행되어 왔으나 이 역시 지속적인 개발이 필요한 실정이다. 따라서 본 연구에서는 시판 유인제와 최근 (주)다목에코텍에서 새롭게 개발한 신규 개발 유인제에 대한 효능 검정을 수행하였 고 양봉장에 출현하는 국내 발생 말벌속의 발생양상을 조사하였다. 담양 1개소와 곡성 2개소에 기존 유인제과 신규 유인제를 장착한 포획기를 각 3쌍씩 설치하여 2016년 9월부터 11월말까지 주 1~2회 관찰하였다. 그 결과 국내 발생 말벌속 중 등검은말벌(7,787 개체)이 가장 많이 포획되었고, 다음으로 장수말벌, 말벌, 좀말벌, 꼬마장수말벌, 털보말벌 순으로 포획되었다. 두 유인제의 포획력 검정 결과, 신규 개발 유인제가 통계적으로 유의하게(P < 0.01) 등검은말벌 포획력이 높음을 보였다.

Previous phylogenetic results often showed fluctuating positions of Geometroidea in Macroheterocera, particularly from mitochondrial genome (mitogenome)-based analyses. In this study, we sequenced mitogenomes of four geometrid moths to increase taxon diversity for the inference of phylogenetic positions of Geometroidea in Macroheterocera. The general genomic features found in Macroheterocera also were found in the four geometrid moths. Phylogenetic analyses using 71 representative mitogeneome sequences in Macroheterocera yielded the consensus superfamilial relationships (((((Bombycoidea + Lasiocampoidea) + Geometroidea) + Noctuoidea) + Drepanoidea) + Mimallonoidea), confirming the sister relationship of Geometroidea to (Bombycoidea + Lasiocampoidea) in both Bayesian Inference and Maximum-likelihood method.

This study was aimed to evaluate the dose-response the effects of nano-encapsulated conjugated linoleic acids(CLAs) on in vitro ruminal fermentation profiles. A fistulated Holstein cow was used as a donor of rumen fluid. Nano-encapsulated CLAs(LF, 5% of nano-encapsulated CLA-FFA; HF, 10% of nano-encapsulated CLA-FFA; LT, 5% of nano-encapsulated CLA-TG; HT, 10% of nano-encapsulated CLA-TG) were added to the in vitro ruminal fermentation experiment. In the in vitro ruminal incubation test, the total gas production on incubation with nano-encapsulated CLAs was increased significantly according to the incubation time, compared with the control(p<0.05). The tVFA concentrations on addition of LF and HT were significantly higher than that of the control(p<0.05). Thus, nano-encapsulated CLAs might improve the ruminal fermentation characteristics without adverse effects on the incubation process. In addition, the population of Butyrivibrio fibrisolvens which is closely related to ruminal biohydrogenation was increased by adding HT, while decreased by adding LF at 12 h incubation. These results showed that nano-encapsulated CLA-FFA could be applied to enhance CLA levels in ruminants by maintaining the stability of CLA without causing adverse effects on ruminal fermentation profiles considering the optimal dosage.

Dendrolimus superans (Lepidoptera: Lasiocampidae) has long been acknowledged to present in South Korea under the circumstance of a substantial change in species names of Dendrolimus. In the present study, we found that specimens of D. superans collected from South Korea were D. sibiricus, rather than D. superans. Comparison of Korean specimens to the D. superans from Japan and the D. sibiricus from Russia in terms of wing morphology, female and male genitalia, a partial COI gene sequence, and a partial internal spacer sequence 2 (ITS2) consistently supported the presence of D. sibiricus in South Korea. Phylogenetic analyses using concatenated sequences of COI and ITS2 from available individuals of D. sibiricus and D. superans both by Bayesian inference and maximum likelihood methods the Korea samples to be D. sibiricus.