The present study was conducted to analyze agronomic characteristics of 8 ecotypes of Arundinella hirta (A. hirta) and the correlation among them. Changes in phenotypic characteristics of 8 ecotypes were measured at equal intervals of time from May to September. Among ecotypes, Jangsoo-1 has the highest plant height (172.33 cm), number of leaves (9.00) and leaf length (55 cm) while the ecotype Youngduk has the highest leaf width (1.57 cm), fresh mass (26.63 g), dry mass (7.06 g), number of spikelets per spike (53.33), amount of seeds per spike (0.74 g) and amount of seeds per 10 spikes (7.23 g). The ecotype Jinju-1 has the shortest plant height (119 cm) and leaf number (6.33), while Okgye-2 has shortest leaf length (30.67 cm), leaf width (0.93 cm), fresh mass (12.60 g), dry mass (3.30 g), spike length (30.33 cm), spikelet per spike (39.67), amount of seeds per spike (0.61 g) and amount of seeds per 10 spikes (6.00 g). Correlation coefficients were estimated among the studied agronomic characteristics which showed positive and significant association with each other. In the present study, the agronomic data collected would be useful to understand the potential of A. hirta as a forage resource and helpful in selecting the high-yielding genetic resource for future forage improvement.
Corn silage is extensively utilized in ruminant feeding on a global scale, with substantial research efforts directed towards enhancing its nutritional worth and managing moisture content. The purpose of this study was to assess the impact of normal cutting height and elevated cutting height on whole-crop corn silage. Corn was harvested at heights of 15 cm and 45 cm above the ground, respectively, 45 days after heading. The harvested corn was cut into 2-3 cm lengths and packed into 20-liter plastic silos in triplicate. The results showed that dry matter (DM), crude protein (CP), water soluble carbohydrates (WSC), and in vitro dry matter digestibility (IVDMD) of C45 were significantly higher than those of the control, while the neutral detergent fiber (NDF) was significantly lower in C45 (p<0.05). The C15 had higher yields than C45 (p<0.05). There was no significant difference in the total digestible nutrients (TDN) yield of whole-crop corn silage. The increase in cutting height resulted in a larger change in moisture content and NDF per centimeter. After 60 days-ensiling, C45 showed significantly lower NH3-N concentrations. Moreover, C45 had significantly higher lactic acid concentration, lactic acid/acetic acid ratio, and lactic acid bacteria count compared to the control. Mold was not detected and the yeast count was less than 2 log10 cfu/g fresh matter in both control and C45. In summary, C45 improved the feeding value and fermentation quality of whole-crop corn silage at the expense of forage productivity.
Buckwheat (Fagopyrum esculentum), which is a traditional Korean crop, has been known as a health food due to its rich nutrition. This study was conducted to evaluate the change in flavonoid content of flowers and seeds during post-flowering growth of Korean tartary buckwheat variety ‘Hwanggeummiso’, with the aim of providing basic data for the development of functional food and feed additive. Tartary buckwheat took 69 and 99 days from the sowing date to reach the flowering and maturity stages, respectively. As a result of examining the flavonoid components of each part of tartary buckwheat, chlorogenic acid, rutin, and isoquercitrin of flowers increased from the flowering period on 22 May (0 days after flowering) to 42 days after flowering, while quercetin increased until 21 days after flowering and then decreased thereafter. In seeds, chlorogenic acid, rutin, and isoquercitrin were most abundant at the time of seed-bearing on 14 days after flowering, and showed a decreasing tendency thereafter. On the other hand, quercetin showed a tendency to increase until 21 days after flowering and then decrease. Overall, the flavonoid content was higher in flowers than in seeds, with rutin being particularly prominent. Based on this, the possibility as food materials and feed additives was confirmed using buckwheat produced in Korea.
This study was aimed to isolate bacterial inoculants producing chitinase and evaluate their application effects on corn silage. Four corn silages were collected from four beef cattle farms to serve as the sources of bacterial inoculants. All isolates were tested against Fusarium graminearum head blight fungus MHGNU F132 to confirm their antifungal effects. The enzyme activities (carboxylesterase and chitinase) were also measured to isolate the bacterial inoculant. Based on the activities of anti-head blight fungus, carboxylesterase, and chitinase, L. buchneri L11-1 and L. paracasei L9-3 were subjected to silage production. Corn forage (cv. Gwangpyeongok) was ensiled into a 10 L mini silo (5 kg) in quadruplication for 90 days. A 2 × 2 factorial design consists of F. graminearum contamination at 1.0104 cfu/g (UCT (no contamination) vs. CT (contamination)) and inoculant application at 2.1 × 105 cfu/g (CON (no inoculant) vs. INO (inoculant)) used in this study. After 90 days of ensiling, the contents of CP, NDF, and ADF increased (p<0.05) by F. graminearum contamination, while IVDMD, acetate, and aerobic stability decreased (p<0.05). Meanwhile, aerobic stability decreased (p<0.05) by inoculant application. There were interaction effects (p<0.05) on IVNDFD, NH3-N, LAB, and yeast, which were highest in UCT-INO, UCT-CON, CT-INO, and CT-CON & INO, respectively. In conclusion, this study found that mold contamination could negatively impact silage quality, but isolated inoculants had limited effects on IVNDFD and yeast.
This study was conducted to determine the appropriate seeding dates by verifying the difference in winter survival and productivity of alfalfa according to fall sowing dates in the central area of South Korea. The experiment was conducted for 2 years (2020 and 2021) at the field in the Department of Animal Resources Development, NIAS located in Cheonan. Sowing dates started from September 18 to November 8 with 10 days of intervals during 2020 and 2021; SO1 (September 18), SO2 (September 28), SO3 (October 8), SO4 (October 18), SO5 (October 28), and SO6 (November 8). After sowing, the winter survival rate was measured in the spring of the following year, and the dry matter yield was measured by harvesting at 10% flowering and harvesting five times a year. SO6 failed to winter survival, and SO5 also had a lower winter survival rate than SO1~4 (p<0.05). The average annual dry matter yield of alfalfa linearly decreased with delaying sowing dates (p<0.05). The feed value did not differ in the same year by delaying the sowing date in the same year. These results suggest that sowing date should be started before October 18 to increase winter survival and productivity of alfalfa in the central area of South Korea.
The experiment aim to breed an early-maturing variety of Italian ryegrass (Lolium multiflorum Lam.). It was conducted at the Grassland and Forage Crops Division, National Institute of Animal Science, RDA, Cheonan, Korea, from 2022 to 2023. The new variety named “Oasis” is a diploid with green leaves and has a semi-erect growth habit in late fall, and an erect growth habit in early spring. With a heading date of May 10, Oasis is categorized as an early-maturing variety. Compared with the “Florida80” as a control variety, Oasis’s flag leaf was 1 mm wider and 2 cm shorter, while the plant length was 7.8 cm longer. Additionally, the ear of Oasis was 1.2 cm longer than that of Florida80, and it showed lodging resistance. The dry matter yield of Oasis (8,805 kg/ha) was higher than that of Florida80. The total digestible nutrient and crude protein contents of Oasis were 64.5%, and 9.3%, respectively, which were 1.1% and 0.6% higher than those of Florida80, respectively. The neutral and acid detergent fiber contents in Oasis were 54.2% and 30.8%, respectively, which was 1.9% and 1.4% lower than those of Florida80, respectively. These results indicate that Oasis has good dry matter yield in the most of region and especially, middle and northern region of South Korea.
Silicon (Si) has the potential to improve plant growth and stress tolerance. The study aimed to explore Si-involving plant responses and molecular characterization of different Si-responsive genes in alfalfa. In this study, the exogenous supplementation of Si enhanced plant growth, and biomass yield. Si-acquisition in alfalfa root and shoot was higher in Si-supplemented compared to silicon deficient (-Si) plants, implying Si-acquisition has beneficial on alfalfa plants. As a consequence, the quantum efficiency of photosystem II (Fv/Fm) was significantly increased in silicon-sufficient (+Si) plants. The quantitative gene expression analysis exhibited a significant upregulation of the Lsi1, Lsi2, Lsi3, NIP5;1, and NIP6;1 genes in alfalfa roots, while BOR1, BOR4, NIP2, and NIP3 showed no significant variation in their expression. The MEME results further noticed the association of four motifs related to the major intrinsic protein (MIP). The interaction analysis revealed that NIP5;1 and Lsi1 showed a shared gene network with NIP2, BOR1, and BOR4, and Lsi2, Lsi3 and NIP3-1, respectively. These results suggest that members of the major intrinsic proteins (MIPs) family especially Lsi1, Lsi2, Lsi3, NIP5;1, and NIP6;1 genes helped to pass water and other neutral solutes through the cell membrane and those played significant roles in Si uptake and transport in plants. Together, these insights might be useful for alfalfa breeding and genome editing approaches for alfalfa improvement.
Iron (Fe) is a vital element for plants and other organisms, involving in several physiological processes including respiration, chlorophyll biosynthesis, and photosynthesis. Unfortunately, how Fe accumulation regulates in response to light quality has not been well established in plants. Therefore, the aim of the study was to explore the mechanism of Fe homeostasis by light quality. In this study, we found morpho-physiological attributes were significantly improved in response to blue (λmax: 450) compared to white (λ max: 500) and red (λmax: 660) light. The root-shoot length, plant biomass, photosynthesis efficiency (Fv/Fm) and leafgreen (SPAD) significantly declined in response to white and red light. However, these parameters were improved and iron deficiency was substantially alleviated by blue light exposure in alfalfa seedlings. This study might be useful to the forage breeders and farmers for improving alfalfa yield and nutritional benefits.
It is widely known that forage corn is one of the most important crops in the production of silage and green chops during the summer months. In this study, the characteristics and the productivity of Kwangpyeongok, AGR 41, and Nero IT corn cultivars were evaluated in the regions of Jeju and Cheonan, Korea between 2021 and 2022. In each year, different corn cultivars were sown in different parts of the country on April 7 in Jeju and May 3 in Cheonan. The yield of three cultivars, Kwangpyeongok, AGR 41, and Nero IT were measured at the yellow-ripening stage, including the leaves and stems (Stover) and corn grain. Kwangpyeongok stover and total dry matter (DM) yields were slightly higher in Cheonan than in Jeju over the past two years. The quantity of corn cultivated in all cultivated areas was similar. The average yield of AGR 41, corn quantity and total DM were slightly higher in Jeju than in Cheonan. In terms of stover yield, and total dry matter content of the Nero IT cultivar cultivated in Jeju had a slightly higher yield than the cultivar cultivated in Cheonan. Based on this study, all cultivars can show some variations but not too much in terms of growth productivity and distinct characteristics depending on their location. Overall, AGR 41, and Nero IT cultivars in Jeju exhibit slightly higher levels of productivity than the same cultivars in Cheonan.
This study was conducted to calculate the damage of Italian ryegrass (IRG) by abnormal climate using machine learning and present the damage through the map. The IRG data collected 1,384. The climate data was collected from the Korea Meteorological Administration Meteorological data open portal.The machine learning model called xDeepFM was used to detect IRG damage. The damage was calculated using climate data from the Automated Synoptic Observing System (95 sites) by machine learning. The calculation of damage was the difference between the Dry matter yield (DMY)normal and DMYabnormal. The normal climate was set as the 40-year of climate data according to the year of IRG data (1986~2020). The level of abnormal climate was set as a multiple of the standard deviation applying the World Meteorological Organization (WMO) standard. The DMYnormal was ranged from 5,678 to 15,188 kg/ha. The damage of IRG differed according to region and level of abnormal climate with abnormal temperature, precipitation, and wind speed from -1,380 to 1,176, -3 to 2,465, and -830 to 962 kg/ha, respectively. The maximum damage was 1,176 kg/ha when the abnormal temperature was -2 level (+1.04℃), 2,465 kg/ha when the abnormal precipitation was all level and 962 kg/ha when the abnormal wind speed was -2 level (+1.60 ㎧). The damage calculated through the WMO method was presented as an map using QGIS. There was some blank area because there was no climate data. In order to calculate the damage of blank area, it would be possible to use the automatic weather system (AWS), which provides data from more sites than the automated synoptic observing system (ASOS).