갈색거저리 유충의 사료인 밀기울은 대부분 수입에 의존하고 있는데 일부 국가의 식량 수출 중단 조치 등에 따른 국제 곡물가격 상승으로 밀기울 가격은 인상되고, 식용곤충 판매가격이 하락하면서 생산비 절감을 위한 사료 개발이 요구되고 있다. 농업부산물 3종을 50% 이상 급이하게 되면 유충 생육이 저하되었기 때문에 본 연구는 적정한 배합비율을 선정하기 위해 첨가사료 20, 30% 함량으로 밀기울과 혼합하여 사료를 급이하였을 때 갈색거 저리 유충의 생육 특성과 영양성분 변화에 대해 밀기울만 제공한 대조구와 비교하였다. 부산물 A와 B, C를 각각 30% 함유한 처리구에서 갈색거저리 유충 무게는 대조구와 차이가 없음을 확인하였다. 먹이소화율은 부산물B를 20% 함유한 처리구가 80.5%로 대조구에 비해 높았고, 부산물C 30% 처리구에서 72.6%로 가장 낮았다. 갈색거저 리 유충의 생육일수 100일 기준으로 부산물B 30% 처리구에서 용화율이 76.1%로 대조구보다 1.6배 높았으며, 부산물A 20% 처리구는 29.2%로 용화율이 가장 낮았다. 갈색거저리 유충의 조단백질 함량은 부산물 C 30% 처리 구에서 대조구보다 10.3% 증가하여 아미노산 분석을 진행한 결과 sarcosine과 ornithine이 2.5배 이상 증가하였다. 이를 통해 부산물 B나 C를 30% 함유한 사료를 급이하였을 때 사육 원가를 절감하여 유충을 생산할 수 있을 것으로 사료된다.

본 논문은 일반적인 상황이 아닌 전시라는 특수한 환경에서의 영상기반 AI 모션캡쳐 적용방법의 다양한 시도 를 살펴보았다. 이전의 방식을 살펴보면서 다양한 전시 환경과 조건에 따라 활용 가능한 방법을 연구하고, 장 단점을 서술하여 인터렉션 전시공간에 적용 가능한 영상기반 AI 모션캡쳐 모션캡쳐 기술의 필요성과 적용 가 능성을 설명한다. 또한 MIVA 프로젝트를 진행하면서 전시공간이라는 비규격화 된 공간에서의 불편한 점을 파 악하고 이에 대한 대응할 수 있는 기술적인 환경 구성에 대하여 정리하였다. 또한 실제 공간에서 캡쳐 프로그 램을 설치하고 전시에 적용하면서 생기는 문제점을 파악하고 해결하면서 적절하게 적용 가능한 모션캡쳐 기 술 환경 파이프라인을 제안한다.

The present study examined changes in surface shape and pore size observed in carbon black particles isothermally oxidized in an air atmosphere according to their burn-off ratio. Carbon black materials were fed into a horizontal tubular furnace in an air atmosphere when the inside temperature reached 600 °C. Subsequently, while changing the isothermal oxidation time, carbon black samples with different burn-off ratios were obtained, i.e., 10.5, 20.0, 30.4, 41.0, 49.9, 59.8, 71.1, and 81.0%. The scanning electron microscope analysis revealed that the observed carbon black particles were in the form of aggregated primary particles, and that there was no change in the particle size of these primary particles as the burn-off process proceeded. The latter observation supported the observation that pores were formed in the carbon black samples during the burn-off process. Notably, the Brunauer–Emmett–Teller analysis exhibited hysteresis curves, indicating that the corresponding adsorption isotherms were of IV-type. It was also found that the area of the hysteresis curves increased as the burn-off process proceeded. The specific surface area of the raw carbon black sample was 58.00 m2/g, while that of the 81.0% sample was about 4.1 times the figure at 240.27 m2/g. The total pore volume VT was 0.17 cm3/g for the raw sample, and it was much higher for the 81.0% sample at 0.58 cm3/g. The transmission electron microscope analysis showed that the raw carbon black particles had a spherical shape with a smooth surface, but inner pores were not observed. In the 49.9% sample, pores with a size of about 5 nm were observed inside carbon black particles. Notably, the size of the pores observed in the 81.0% sample was about 20 nm and the large pores were created by the collapsing and merging of the smaller pores by oxidation.

Potential utility of 14 candidate housekeeping genes as normalization reference for RT-qPCR analysis with developmental samples (fertilized eggs to late veliger larvae) in Pacific abalone Haliotis discus hannai was evaluated using four different statistical algorithms (geNorm, NormFinder, BestKeeper and comparative ΔCT method). Different algorithms identified different genes as the best candidates, and geometric mean-based final ranking from the most to the least stable expression was as follow: RPL5, RPL4, RPS18, RPL8, RPL7, UBE2, RPL7A, GAPDH, RPL36, PPIB, EF1A, ACTB and B-TU. The findings were further validated via relative quantification of metallothionein (MT) transcripts using the stable and unstable reference genes, and expression levels of MT were greatly influenced according to the choice of reference genes. In overall, our data suggest that RPL5 and RPS18, either singly or in combination, are appropriate for normalizing gene expression in developmental samples of this abalone species, whereas ACTB, B-TU and EF1A are less stable and not recommended. In addition, our findings propose that standard deviations in geometric ranking as well as geometric mean itself should also be taken into account for the final selection of reference gene(s). This study could be a useful basis to facilitate the generation of accurate and reliable RT-qPCR data with developmental samples in this abalone species.

This study aimed to examine the effect of a mild elevation in serum cholesterol level in a porcine coronary overstretch restenosis model using a balloon angioplasty catheter or drug-eluting coronary stent. Pigs were divided into two groups and were fed a commercial normal diet (CND, n = 4) or a high-fat diet (HFD, n = 4) for 5 weeks. Coronary overstretch injury by balloon angioplasty or stent implantation was induced in the left anterior descending and left circumflex artery after 1 week of feeding. Histopathological analysis was performed at 4 weeks after coronary injury. During the experiment, the total cholesterol level in the HFD group increased by approximately 44.9% (from 65.9 ± 3.21 mg/dL at baseline to 95.5 ± 9.94 mg/dL at 5 weeks). The lumen area in the CND group was reduced in comparison with that in the HFD group after balloon angioplasty. After stent implantation, the injury score showed no significant difference. There were significant differences in the neointimal area (2.7 ± 0.33 mm2 in the CND group vs. 3.3 ± 0.34 mm2 in the HFD group, p<0.05), lumen area (2.6 ± 0.54 mm2 in the CND group vs. 2.0 ± 0.33 mm2 in the HFD group, p<0.05), and percent area stenosis (52.0 ± 7.96% in the CND group vs. 62.4 ± 5.15% in the HFD group, p<0.05). Body weight change was not different between the two groups. Increased serum cholesterol level activated vascular smooth muscle cell proliferation in the porcine coronary overstretch model.

Clithon retropictus has been protected by the Ministry of Environment as an endangered species since 1998 and has been listed on the state red list of endangered species category II. It is viewed as a representative for all endangered species in the northeastern coastal waters of Korea. Most of the habitats of C. retropictus have been found to be in an unstable state because of development projects such as road construction, small stream development, irrigation for securing agricultural water, and flood prevention. These habitats are damaged by small stream maintenance projects and development, and the risk of damage is increasing and active efforts are needed in order to protect them. Although the Ministry of Environment is striving to preserve this endangered species, the habitat of C. retropictus is still facing external threats because it spreads to only a small area at high densities. Therefore, in order to protect the habitat of C. retropictus, a level II endangered species, it is urgent to make an effort to minimize habitat damage and to take measures for its protection.

식용곤충에서 최근에 식품공전에 등록된 갈색거저리 유충, 쌍별귀뚜라미 유충에 대해 일선 농가들이 식용곤충의 안정적 공급 및 유통을 위해 수확 후 건조 포장시 보관 유통기한을 설정할 필요가 있다. 건조된 갈색거저리, 쌍별귀뚜라 미 성상(분말, 건조물)을 용량 100g씩 PE, PET, 내습 포장지 등 포장재질에 진공, 밀봉포장을 한 후 저장온도를 45℃ 설정하여 2월 12일부터 3월 11일까지 1개월동안 가속실험을 실시하였다. 1개월후 시료 검체하여 품질 지표를 분석 조사한 결과, 밀봉포장에서 갈색거저리 건조물은 수분, 일반세균, 관능검사 등에서 PET+제습제, PE+제습제가 분말은 PE, PE+제습제 순으로 조사되었고 쌍별귀뚜라미 건조물은 PET+제습제, 내습포장제가 분말은 내습포장제만 기준치 이내로 조사되었다. 진공 포장에서 갈색거저리 건조물은 PE+제습제, 내습포장제가 분말은 PE, 내습포장제로 나타났으며 쌍별귀뚜라미 건조물은 PE+제습제, PET+제습제가 분말은 PET+제습제, 내습포장제 순으로 조사되었다. 특히, 쌍별귀뚜라미 분말은 밀봉, 진공포장 모두에서 일반세균 기준치(1,000cfu/g)가 이상을 보여 본 실험 포장재질로 는 유통이 어려운 것으로 나타났다.

Composite resins are developed as restorative materials to improve esthetics and mechanical properties. To improve the physical properties of resin material, resin filler have to be added. However, no imaging method is adopted for resin filler distribution. Optical coherence tomography (OCT) is a optical imaging technique to delineate microscopic structures within biological tissue. The OCT application to dental composites resin and its filler is not described yet. So, this new and advanced optical method is needed for clinical application for evaluation of dental composite resin. To analyze the spatial distribution of dental composite resin and to evaluate the resin restoration in cavity, frequency domain optical coherence tomography (FD-OCT) was used for their analysis. Resin restored tooth was prepared. For morphological observation, serially sectioned teeth, conventional X-ray taking and micro computed-tomography (CT) images were compared with OCT images. The experiment has done to evaluate the success of the resin restoration using 3 dimensional structure OCT image. In this research, OCT is evaluated as a new technique to image resin restoration. The evaluation of resin restored tooth was performed by OCT. Inappropriate restoration such as marginal adaptation, large porosities, internal integrity and poor contour could be detected. Resin filler also could be checked by OCT. The distribution, number, regularity and size of resin filler can be differentiated from several commercial products. Considering the characteristics of the OCT, it can be used to evaluate the defects of resin restoration, resin filler distribution, and internal integrity between resin material and tooth structure. The OCT can be considered to be a new and advanced method for the evaluation of resin restorations.