The performance characteristics of a lead acid battery are investigated with the content of Sodium Perborate Tetrahydrate (SPT, NaBO3·4H2O) in a positive plate active material. SPT, which reacts with water to form hydrogen peroxide, is applied as an additive in the positive plate active material to increase adhesion between the substrate (positive plate) and the active material; this phenomenon is caused by a chemical reaction on the surface of substrate. A positive plate with the increasing content of SPT is prepared to compare its properties. It is confirmed that the oxide layer increases at the interface between the substrate and the active material with increasing content of SPT; this is proven to be an oxide layer through EDS analysis. Battery performance is confirmed: when SPT content is 2.0 wt%, the charging acceptance and high rate discharge properties are improved. In addition, the lifetime performance according to the Standard of Battery Association of Japan (SBA) S0101 test is improved with increasing content of SPT.

In this study, air scouring cleaning was selected and applied among 5 small blocks (S1~S5) in domestic S cities to analyze the cleaning effect of particles causing discoloration. In order to identify the cleaning effect, 10 locations were selected as water quality investigation point, such as the stagnant or water mains ends. Removal of solids, variation of particle components, weight and concentration were analyzed. And the level of the cleanness of the surface inside water mains using endoscope was investigated. As a result of analysis, the solids discharged after cleaning were mainly sand and gravel, pieces related to pipe materials, and corrosion products. As a result of analyzing the concentrated particles of the filter before and after cleaning, it was found that the change in discoloration on the filter was large. In addition, as a result of comparing the weight and the concentration of the particles, it was found that the particles causing discoloration were significantly removed after cleaning. From the results of the endoscopy, it was confirmed that most of the precipitated and accumulated dark yellow discoloration matters inside water mains were removed through cleaning. Therefore, it seems that the particles causing discoloration in water decreased after cleaning. Therefore, it is expected that, if properly cleaning was applied, matters that cause discoloration can be removed from the water mains, and customer's complaints can also be reduced through water quality improvement.

Various electronic control parts and devices installed in electric vehicles have greatly improved the convenience of occupants, but electromagnetic waves emitted from electronic devices have greatly increased concerns about malfunctions, deterioration of performance, safety accidents, etc. There are two models of analysis. Case A is symmetrical about one axis of rotation. Case B has two axes of rotation. In this study, a flow analysis was conducted to find excellent flow conditions in the mixing process to develop a paint with excellent electromagnetic shielding and thermal insulation performance. The results of the flow analysis are reflected in manufacturing specifications and are intended to be used to develop high-quality systems.

This study was conducted to evaluate the applicability of a carrier media with natural minerals as packing material in a biofilter to remove odor-causing compounds. The carriers were prepared by mixing powdered zeolite, barley stone, and clay. They have a pellet type with a length of 5m m to 10 mm, 3.2 m2/g of a specific surface area, and 0.04 cm3/g of a pore volume. The adsorption capacity and the biodegradation by biomass formation on the media were experimented with toluene and ammonia as the test compounds. The carrier possessed the ability to adsorb toluene and ammonia. The adsorption capacity of toluene and ammonia at the inlet concentration of 100 ppmv was 58 g/g and 96 g/g, respectively. In the biofilter using the carrier as the packing material, the biofilter performances were different depending on the supply of moisture and liquid-nutrient. The critical loading was found to be 33.13 g/m3/hr for toluene removal and 6.5g /m3/hr for ammonia removal even when no nutrients were supplied. The proposed material has been confirmed to be capable of adsorbing inorganic and organic compounds, and can be effectively applied as packing materials for the biofiltration.

Odor emitted from the degradation process of food waste is a common cause of public complaints, and appropriate odor treatment methods need to be implemented. In this study, a hybrid plasma catalyst system was applied to treat individual odorous compounds including acetaldehyde and hydrogen sulfide, which are known to be major odor compounds produced from food waste. MnOx catalysts were prepared by varying Mn/support loading ratios, and surface analyses showed that the Mn_5% catalyst achieved the highest performance because dominant manganese oxide species on the surface of the catalyst was found to be Mn2O3, Using the catalyst, the removal rate of hydrogen sulfide steadily increased as the space velocity in the MnOx catalyst reactor decreased. Meanwhile, the removal rate of acetaldehyde did not increase significantly when decreasing the space velocity more than 24,000 hr-1. Following the catalyst experiments using the individual odorous compounds, the hybrid system was applied for testing odor treatment of actual food waste. The actual food waste study showed that both hydrogen sulfide and acetaldehyde were steadily removed; hydrogen sulfide was removed almost completely during the initial 30-minute period, while the acetaldehyde removal was started after the decrease of hydrogen sulfide. In addition, it was confirmed that the dilution-to-threshold for odor reduced from 2,080 D/T to 300 D/T during the initial period. In conclusion, the plasma and Mn2O3 catalyst system can be applied in food waste collection containers to effectively control odor problems.

This study was conducted to separate microorganisms with excellent odor component decomposition ability from nature. Microorganisms growing sulfur and ammonia compounds as substrates were isolated and identified in the tidal flat of Suncheon Bay. The strain YUN4 cultured on ammonia and sulfur compound substrates was found to have 100% genetic homology to Streptomyces fulvissimus. The optimum growth temperature of YUN4 was 20oC to 40oC, and the optimum pH was investigated in the range of pH 5 to pH 9. In addition, in order to evaluate the ability to reduce odor, after mixing the culture strain with each concentration of 1%, 5%, and 10% in the malodor generating sample, the efficiency of malodor reduction was evaluated after 30 minutes. As a result, the ammonia decomposition efficiency was 82.4%~93.9%, and hydrogen sulfide was 88.7%~94.9%.

This study was conducted to analyze the characteristics of odorous components that have been generated from the downtown sewer system based on twenty-three survey items for complex odor and designated offensive odor. As a result of the research, the contribution rates for the causative materials of the odor indicated 73.5% of hydrogen sulfide, 26.0% of methyl mercaptan, 0.4% of dimethyl sulfide, and 0.1% of dimethyl disulfide. The occurrence for the odorous materials according to sampling site revealed data of which contribution rates showed 56.9% of hydrogen sulfide and 36.8% of methyl mercaptan from the combined sewer system in the business district; whereas the combined sewer system in the residential area showed 16.4% of dimethyl sulfide and 4.3% of dimethyl disulfide. The seasonal occurrence rate of the odor materials was observed higher in summer and lower in winter And, the combined sewer system in the business district recorded the highest concentration of 4.61 ppm of hydrogen sulfide among the sampling site. An hourly occurrence rate for the odor materials consistently showed the greatest increase between 11:00 and 14:00 at each location and showed a decreasing tendency afterward.

The purpose of this study was to evaluate indoor air pollutants of children’s facilities in libraries. The indoor pollutants, which were managed under the “Indoor Air Quality Control Standards” and “Environmental Safety Standards for Children’s Activity Zones,” were measured within five months. The new environmental pollutants such as phthalates and pesticides were also measured. The pollutant-measuring device was installed in children’s spaces in libraries and children’s libraries of the metropols. The result of investigating indoor pollutants showed that the concentration of fungus and floating bacteria had low distributions due to the use of air purifiers in all libraries. The concentration of HCHO and TVOCs was also measured lower than the environmental standards in well-ventilated libraries. On the other hand, phthalates and pesticides were detected in all libraries. In the case of heavy metals, they were mainly found in the finishing materials of the library walls and floors. As a result, indoor pollutants are managed under court receivership. On the other hand, phthalates and pesticides, which are not regulated by environmental standards should be managed because they were detected in all libraries.