간행물
한국도로학회논문집 KCI 등재 International journal of highway engineering
- 발행기관 한국도로학회
- 자료유형 학술지
- 간기 격월간
- ISSN 1738-7159 (Print)2287-3678 (Online)
- 수록기간 1999 ~ 2024
- 주제분류 공학 > 토목공학 공학 분류의 다른 간행물
- 십진분류KDC 534DDC 625
권호리스트/논문검색
제20권 제4호 (2018년 8월) 9건
도로 포장 및 시설
1.
2018.08
구독 인증기관 무료, 개인회원 유료
PURPOSES: The objective of this study is to evaluate of the effect of thermal segregation reduction in asphalt paving using material transfer vehicles (MTVs).
METHODS: Asphalt paving using MTVs was carried out, and the paved surface temperature was measured using an infrared camera. The amount of thermal segregation was estimated from temperature variations.
RESULTS : The transportation of hot mix asphalt (HMA) using dump trucks caused temperature segregation that persisted in the paving surface if an MTV was not used. The average temperature variation was 8.58% in paved surfaces where an MTV was not used. However, the temperature variation was 3.10%, 2.86%, and 4.53% for the base layer, inter-layer, and surface layer, respectively, when an MTV was used.
CONCLUSIONS: The use of an MTV in asphalt paving reduces thermal segregation approximately 2.3 times in an asphalt mat via a remixing process and also allows for a smoother work process because the paver never needs to stop to receive HMA. However, MTV equipment without pre-heating devices requires careful temperature control during the warm up process at the MTV during construction in the winter.
4,000원
2.
2018.08
구독 인증기관 무료, 개인회원 유료
PURPOSES: In order to apply high-speed weigh-in-motion (HS WIM) systems to asphalt pavement, three high-durability asphalt concrete mixtures installed with a WIM epoxy are evaluated.
METHODS: In this study, dynamic stability, number of loading repetitions to reach the rut depth of 1 mm, and rut depth measurements of three asphalt mixtures at 60℃ were compared using an Asphalt Pavement Analyzer (APA). Laboratory-fabricated material and field core samples were prepared and tested according to KS F2374.
RESULTS : Through the laboratory tests, it was found that all three modified asphalt mixtures (stone-mastic, porous, and semi-rigid) with WIM epoxy showed favorable permanent deformation results and passed the dynamic stability criterion of 3000 loading repetitions per 1 mm. In addition, it was confirmed that the modified SMA mixtures cored from the field construction yields satisfactory rutting testing results using the APA. Finally, the epoxy used for the HS WIM installation shows good adhesion with the three asphalt mixtures and permanent deformation resistance.
4,000원
3.
2018.08
구독 인증기관 무료, 개인회원 유료
PURPOSES : The purpose of this study is to analyze the magnitude of shoving of asphalt pavement by junction type between airport concrete and asphalt pavements, and to suggest a junction type to reduce shoving.
METHODS : The actual pavement junction of a domestic airport, which is called airport “A”was modified by placing the bottom of the buried slab on the top surface of the subbase. A finite element model was developed that simulated three junction types: a standard section of junction proposed by the FAA (Federal Aviation Administration), an actual section of junction from airport “A”and a modified section of junction from airport“ A”. The vertical displacement of the asphalt surface caused by the horizontal displacement of the concrete pavement was investigated in the three types of junction.
RESULTS: A vertical displacement of approximately 13 mm occurred for the FAA standard section under horizontal pushing of 100 mm, and a vertical displacement of approximately 55 mm occurred for the actual section of airport “A”under the same level of pushing. On the other hand, for the modified section from airport“ A”a vertical displacement of approximately 17 mm occurred under the same level of pushing, which is slightly larger than the vertical displacement of the FAA standard section.
CONCLUSIONS: It was confirmed that shoving of the asphalt pavement at the junction could be reduced by placing the bottom of the buried slab on the top surface of the subbase. It was also determined that the junction type suggested in this study was more advantageous than the FAA standard section because it resists faulting by the buried slab that is connected to the concrete pavement. Faulting of the junctions caused by aircraft loading will be compared by performing finite element analysis in the following study.
4,000원
4.
2018.08
구독 인증기관 무료, 개인회원 유료
PURPOSES: The objective of this study is to evaluate the application of soil stabilization method for soft shoulder construction in the iRoad Project of Sri Lanka.
METHODS: Firstly, the quantitative analysis of soil strength improvement due to soil stabilization was done for soil samples collected from iRoad construction sites. Two types of soils were selected from iRoad Project sites and prepared for soil stabilization testing by the Road Development Authority. Secondly, the appropriate stabilizer was selected at given soil type based on test results. Two different stabilizers, ST-1 and ST-2, produced in Korea were used for estimating soil strength improvements. Finally, the optimum stabilizer content was determined for improving shoulder performance. The uniaxial compressive strength (UCS) test was conducted to evaluate the strength of stabilized soil samples in accordance with ASTM D 1633. The use of bottom ash as a stabilizer produced from power plant in Sri Lanka was also reviewed in this task.
RESULTS: It is found from the UCS testing that a 3% use of soil stabilizer can improve the strength up to 2~5 times in stabilized soft shoulder soils with respect to unstabilized soils. It is also observed from UCS testing that the ST-1 shows high strength improvement in 3% of stabilizer content but the strength improvement rate with increase of stabilizer content is relatively low compared with ST-2. The ST-2 shows a low UCS value at 3% of content but the UCS values increase significantly with increase of stabilizer content. When using the ST-2 as stabilizing agent, the 5% is recommended as minimum content based on UCS testing results. Based on the testing results for bottom ash replacement, the stabilized sample with bottom ash shows the low strength value.
CONCLUSIONS: This paper is intended to check the feasibility for use the soil stabilization technique for shoulder construction in Sri Lanka. The use of soil stabilizer enables to improve the durability and strength in soft shoulder materials. When applying the bottom ash as a soil stabilizer, various testings should be conducted to satisfy the specification criteria.
4,000원
5.
2018.08
구독 인증기관 무료, 개인회원 유료
PURPOSES: The objective of this study is to evaluate the physical properties of recycled asphalt mixtures reinforced with glass fiber.
METHODS: Firstly, mixing design was conducted on recycled asphalt mixture for use of 50% recycled aggregate. Various laboratory tests were performed on four types of recycled asphalt mixtures with different glass fiber content to evaluate the physical properties. The laboratory tests include indirect tensile strength test, dynamic modulus test, Hamburg wheel tracking test and tensile-strength ratio to evaluate cracks, rutting and moisture resistance of mixtures.
RESULTS: The indirect tensile strength of fiber reinforced glass increased about 139.4%. As a result of comparing the master curves obtained by the dynamic modulus test, the elasticity was low in the low temperature region and high in the high temperature region when the glass fiber was reinforced. The glass fiber contents of PEGS 0.3%, Micro PPGF 0.1% and Macro PPGF 0.3% showed the highest moisture resistance and rutting resistance.
CONCLUSIONS : The test results show that use of glass fiber reinforcement can increase the resistance to cracking, rutting, and moisture damage of asphalt mixtures. It is also necessary to validate the long-term performance of recycled asphalt mixtures with glass fiber using full scale pavement testing and field trial construction.
4,000원
도로교통체계
6.
2018.08
구독 인증기관 무료, 개인회원 유료
PURPOSES: The purpose of this study is to compare the lane curing time of natural drying and a lane drying device when painting lines on a highway.
METHODS: The painting process was carried out in July 2015 and September 2015, respectively, for the Gimcheon IC - Gimcheon JC. After the painting, measurements were obtained three times at six measurement points located at 20 m intervals on the shoulder line and the dividing line. The curing time was measured for natural drying and drying using a lane drying device, and compared for different pavement types (asphalt, concrete) and paint types (waterborne paint, methyl methacrylate paint).
RESULTS : The results of the lane curing time comparison on the highway are as follows. The combination of asphalt and methyl methacrylate paint cured more rapidly during both the natural drying and drying using the lane drying device. Finally, it was cured at least 32.2% and 40.7% faster when using a drying device than in natural drying.
CONCLUSIONS: The comparison of lane curing time of the highway showed that the combination of asphalt and methyl methacrylate paint cured more rapidly when using both natural drying and a lane drying device.
4,300원
7.
2018.08
구독 인증기관 무료, 개인회원 유료
PURPOSES: Seoul introduced public bicycles to reduce environmental pollution and create a healthy society. Because the use of bicycles is highly weather dependent, and bicycles are rented by the people, member characteristics and seasonal influences should be considered. This study analyzed bicycle traffic characteristics considering seasonal and member characteristics and highlighted some implications.
METHODS: The Yeouido and Sangam districts, which have multiple business districts, were taken as the areas of interest. In order to reflect seasonal and membership characteristics, the traffic volume, time of use, and characteristics of each zone were categorized by season (spring, summer, autumn, winter) and membership type (season, daily, group). In addition, we analyzed the pattern of traffic volume and usage time according to the traffic purpose after separating rental locations into residential, business, subway, and park, reflecting the land characteristics.
RESULTS: The results revealed that seasonal characteristics were high for bicycle traffic, time of use, and occupancy rate for park locations in spring and autumn. In terms of membership characteristics, group and daily users appeared as major visitors for park locations, and the trends of commuter pass users showed that bicycle use meets the purpose of introducing public bicycles.
CONCLUSIONS: Traffic characteristics differed according to seasonal and membership characteristics. It is necessary to involve and extend the users of the commuter pass. Situations in which commuter pass users cannot function as a group or in which daily users monopolize bicycles (especially near parks, near subway stations, etc.) must be avoided.
4,300원
8.
2018.08
구독 인증기관 무료, 개인회원 유료
PURPOSES : This study was conducted to develop expressway safety treatments based on the analysis results of older driver behaviors through literature review, surveys, and driving simulator experiments.
METHODS: In this study, three analyses were conducted: surveys of 700 older drivers to find the risk segments they recognized, driving simulator experiments with older and younger drivers to investigate driver behaviors, and expert surveys to find the priority of expressway safety treatments for older drivers.
RESULTS : Through survey results it was found that merging areas and tunnels were identified as the most dangerous areas, and more dangerous older driver behaviors were observed on those expressway segments in the driving simulator experiments. In addition, the priorities of safety treatments for each segment of expressways were decided based on expert surveys.
CONCLUSIONS: It was concluded that choice and concentration strategies of expressway safety treatments for older drivers should be applied as perceptions regarding dangerous spots and older driver behaviors, including geometric designs, safety facilities, regulation, and institutes to improve expressway safety.
4,600원
9.
2018.08
구독 인증기관 무료, 개인회원 유료
PURPOSES: Most of the traffic surveys are carried out by an inspection method by the manpower. In some cases, the video equipment is used only in some regions when the traffic volume is surveyed. In this case, there is environmental restriction that the road equipment to fix the video equipment should exist. Also, in areas where information such as digital maps and satellite photographs is old or not provided, they are forced to rely on manpower research, but it is difficult to put huge amounts of time and money into the research in places where labor supply and demand is difficult. This difficulty is particularly pronounced in overseas business.
METHODS : The purpose of this study is to improve the efficiency of business by using the drones in the traffic investigation through analysis of the cost reduction effect between the existing method and the proposed method in the overseas business traffic survey. The scope of the research is limited to the scope of research, and based on the case of overseas projects, the method of using drone for each research sector is suggested.
RESULTS: In the traffic condition survey section, we propose the use of drone for traffic survey and queue length survey, and it is confirmed that there is a cost saving effect of 16% ~ 27% compared with the existing method. In the road condition survey, we propose the use of drones for road surface linear survey, geometry survey, and obstacle survey, and it was confirmed that the cost reduction effect is 39% ~ 93% compared to the existing method.
CONCLUSIONS: In addition to overseas business, it is expected that it will have a positive effect on research time and cost reduction by using drone in traffic survey in domestic area where labor supply is not easy or basic data is insufficient.
4,300원
